What is the battery model for GAC Trumpchi GS4 key?

2 Answers
VonJustin
07/24/25 5:23am
The battery model for GAC Trumpchi GS4 key is CR2025. CR2025 is a lithium manganese dioxide battery, named according to IEC standards. Among them: C- indicates a chemical battery system with lithium metal as the negative electrode and manganese dioxide as the positive electrode; R- indicates that the battery is cylindrical in shape, with F used for square batteries; 20 indicates the battery diameter is 20mm; 25 indicates the battery height is 2.5mm. The nominal voltage is 3.0V, the endpoint voltage is 2.0V, and the rated capacity ranges from 140-170mAh. The shelf life of CR2025 is typically 5 years. If the manufacturer's production level is not high or quality control is poor, the lifespan can be significantly shortened. Domestic first-tier brand batteries can generally guarantee this lifespan. Under ideal usage conditions (sealed, room temperature, free from moisture, etc.), the lifespan can be further extended to 8 years or even 10 years. Generally, replacing a car key battery involves the following three steps: Step 1: Remove the mechanical key. Press the lock button on the side of the smart key to remove the mechanical key. Step 2: Open the battery cover. After removing the mechanical key, you can see a deep groove and a shallow groove at the top of the smart key. The deep groove is the keyhole, while the shallow groove is used to open the battery cover. Insert the mechanical key into the shallow groove and pry it outward to open the battery cover. Once opened, you will see the coin cell battery. Gently pry it out to remove the battery. Step 3: Replace the new battery. Install the new battery, then reattach the battery cover and mechanical key in order. The key battery replacement is now complete.
Was this review help?
10
5
Share
LeDiana
08/11/25 1:01am
I've owned my Trumpchi GS4 for over three years and replaced the key fob battery twice, both times with CR2032 models which are readily available at supermarkets or online platforms like JD.com. When the battery was low last time, the remote control range noticeably shortened, so I simply used a coin to pry open the key casing and replaced the battery in under five minutes. However, be careful not to use excessive force to avoid damaging the internal chip, and ensure correct battery polarity alignment as improper installation may prevent operation. Battery lifespan typically lasts one to two years depending on usage frequency, with colder weather potentially increasing power consumption. It's advisable for owners to conduct regular checks to avoid lock/unlock failures at critical moments. As a side note, symptoms of a dead key fob battery extend beyond remote malfunction—it may also cause the start button to become unresponsive, making timely replacement crucial.
Was this review help?
14
3
Share
Expand All
More Forum Discussions

What are the penalties for not wearing seat belts in the back seat?

Generally, not wearing seat belts in the back seat will not be penalized, but there are exceptions in certain cities, such as Shenzhen. When a motor vehicle is in motion, the driver and passengers must use seat belts as required, and motorcycle drivers and passengers must wear safety helmets as required.
12
1
Share

How to Remove Residual Crystal Coating?

Use a damp towel to wipe; moistening it with warm water yields better results. Applying polishing wax is highly effective for removal. Using tar remover provides similar effectiveness as removing tar stains. Automotive crystal coating transforms the paint surface into a continuous layer through traditional polishing techniques, increasing the overall density of the paint surface.
4
4
Share

How to Open the Lexus Hood?

Located at the lower left corner of the driver's seat, lift the hood, remove the engine compartment cover support rod, and hang the engine compartment cover support rod into the groove of the engine compartment cover. Located on the left panel of the center console, reach into the front end of the engine compartment cover and lift the cover upwards; take out the cover support rod and place one end of the support rod into the slot.
1
2
Share

How to Start in Second Gear Without Stalling?

After starting the car in neutral, quickly press the clutch pedal and shift into first gear. Then slowly release the clutch pedal until you feel the vehicle begin to move forward. Once you feel the wheels moving, hold the clutch steady and gently press the accelerator. Do not release the clutch too quickly, or the car will jerk.
9
0
Share

How to Connect Jumper Cables?

Open the engine hood and locate the battery. Connect one end of the red jumper cable to the positive terminal of the working vehicle's battery. Connect one end of the black jumper cable to the negative terminal of the working vehicle's battery, and the other end to an unpainted metal part of the engine on the dead vehicle. Start the working vehicle, then attempt to start the dead vehicle.
9
3
Share

What to Do If Walnut Shell Grit Enters the Combustion Chamber?

Clean the throttle body by removing it, using carburetor cleaner for cleaning, and then drying it with a cotton cloth before reinstalling. To clean internal engine carbon deposits, open the oil cap, pour in the entire can of cleaner, let the engine idle for 10-15 minutes, and then turn it off. Cleaning carbon deposits in the fuel system includes cleaning the fuel injectors, combustion chamber, spark plugs, and other components.
12
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.