What is the actual fuel consumption of the Changan CS35 Plus?

2 Answers
Haley
07/29/25 9:52am
The actual fuel consumption of the Changan CS35 Plus is as follows: 1. The 1.4T model has a fuel consumption of 8.1 liters per 100 kilometers. 2. The manual transmission 1.6L model has a fuel consumption of 7.2 liters per 100 kilometers, while the automatic transmission model has a fuel consumption of 8.0 liters per 100 kilometers. Relevant information about vehicle fuel consumption is as follows: 1. Constant-speed fuel consumption: This refers to the fuel economy indicator when the vehicle is driving at a constant speed on a good road surface. Since constant-speed driving is a basic operating condition for vehicles on highways and this type of fuel consumption is easy to measure, it is widely adopted. 2. Road cycle fuel consumption: This is the fuel economy indicator measured when the vehicle is driven in repeated cycles according to specified speed and time regulations on the road, also known as multi-condition road cycle fuel consumption. The speed and time regulations specify various driving conditions included in each cycle, as well as the shifting times, braking and stopping times, driving speed, acceleration, and braking deceleration values for each cycle.
Was this review help?
6
3
Share
StEmiliano
08/13/25 11:51am
I've been driving the CS35 Plus for almost two years now. As a frequent city driver, my actual fuel consumption averages 8-9L/100km. In urban traffic jams, it can jump above 10L, while on highways it stays steadily below 7L. Driving habits significantly affect fuel efficiency—I usually try to accelerate smoothly and brake less, and I've developed the habit of checking tire pressure, keeping it at 2.5Bar to save some fuel. Regular maintenance is also important, such as changing the engine oil and air filter every 5,000 kilometers. A smoother engine can slightly reduce fuel consumption by about 0.5L. In summer, using the air conditioner at high settings increases fuel consumption by around 1L. Overall, I feel this SUV is quite fuel-efficient, with its spacious and practical design making it worth it, and suitable for daily commuting.
Was this review help?
7
1
Share
Expand All
More Forum Discussions

How to Remove a Stuck Volkswagen Ignition Lock?

The steps to remove a stuck Volkswagen ignition lock are: 1. Insert the key into the keyhole and rotate it 90 degrees clockwise; 2. There is a small hole next to the keyhole, insert a prepared steel wire into it; 3. The ignition lock cylinder will pop out, allowing you to remove it. Taking the Volkswagen Bora 2020 1.5L Automatic Comfort model as an example, its dimensions are 4663 mm in length, 1815 mm in width, and 1462 mm in height, with a wheelbase of 2688 mm, a fuel tank capacity of 50 liters, and a curb weight of 1285 kg. It is equipped with a 1.5L naturally aspirated engine, delivering a maximum horsepower of 113 PS and a maximum power of 83 kW, paired with a 6-speed automatic transmission.
17
0
Share

What is the duration of the three-guarantee period for vehicles?

The three-guarantee period for vehicles is no less than two years or 50,000 kilometers, whichever comes first. During the "three-guarantee validity period," if the conditions for return or exchange as stipulated are met, consumers can process return or exchange procedures with the "three-guarantee" certificate, purchase invoice, etc. If the cumulative repair time due to product quality issues exceeds 35 days, or if the same product quality issue has been repaired more than five times cumulatively, the consumer can request a vehicle exchange with the three-guarantee certificate and purchase invoice. The "three-guarantee" regulations also stipulate that consumers can choose to replace or return the vehicle product under the following circumstances: 1. If two repairs have been conducted cumulatively due to severe safety performance failures, and the severe safety performance failures have not been resolved or new severe safety performance failures have occurred; 2. If the same major component of the steering system, braking system, suspension system, front and rear axles, or body has been replaced twice due to quality issues and still cannot function normally. The seller shall be responsible if the consumer chooses to replace or return the vehicle.
16
1
Share

Can You Step on the Accelerator During a Hill Start?

You can step on the accelerator during a hill start to prevent the car from stalling or rolling backward, as it provides additional power for climbing the slope. If you are not proficient in operating the clutch and cannot rely solely on it for starting, pressing the accelerator during a hill start serves as a precaution. Additionally, when starting on a slope, avoid releasing the clutch pedal immediately. Instead, first engage the accelerator and then gradually release the clutch, as the car encounters greater resistance on an incline and requires more power to start. The key point is the timing of releasing the handbrake. During the start, press the accelerator with the ball of your right foot while slowly releasing the brake with your right heel, and gently lift the clutch with your left foot. After starting, fully release the clutch pedal. The coordination between the ball and heel of your right foot is crucial. This hill-start method is relatively difficult to master and is recommended only as an emergency measure.
9
3
Share

Why is the exhaust pipe particularly black after high-speed driving?

The reasons for the exhaust pipe being particularly black after high-speed driving are: 1. Poor engine combustion; 2. The engine's fuel system has not been cleaned for a long time; 3. Poor quality gasoline. The exhaust pipe is part of the engine's exhaust system, which mainly includes the exhaust manifold, exhaust pipe, and muffler. Generally, the three-way catalytic converter, which controls engine pollutant emissions, is also installed in the exhaust system. The exhaust pipe usually includes the front exhaust pipe and the rear exhaust pipe. The main functions of the exhaust pipe are exhaust and noise reduction. The composition of the entire exhaust system is: exhaust manifold, three-way catalytic converter, intermediate muffler, tail muffler, and connecting pipes.
2
0
Share

Why does the car still roll when in P gear?

The reason the car still rolls when in P gear is that the vehicle is parked on a slope, which can cause rolling. P gear is a common gear position in automatic transmission vehicles, usually located at the foremost position on the gear shift console, in front of the R gear, designed to lock the axle when the car is stationary on a slope. After shifting into P gear, the handbrake should be firmly engaged; otherwise, it may cause excessive force on the P gear locking mechanism, reducing its service life. The correct method is to shift into N gear first, engage the handbrake, and then shift into P gear. This approach can extend the service life of both the transmission and the P gear locking mechanism.
17
2
Share

How to Deal with White Marks on Car Paint Caused by Firecrackers?

To address white marks on car paint caused by firecrackers, use a damp cloth with a bit of dish soap to gently wipe the affected area. If wiping doesn't remove the marks, the only solution is to polish and wax the car paint again. Avoid using a dry cloth directly, as residue from the firecrackers can cause further damage to the paint by scratching it back and forth. Note that car paint can only be polished a limited number of times; frequent polishing can cause permanent damage to the paint. Car paint is a type of coating sprayed onto the vehicle, forming a protective film on the surface. This not only prevents corrosion but also extends the car's lifespan.
1
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.