···
Log in / Register

What is the 0-100 km/h acceleration time of the Audi Q2L?

3 Answers
DelJoanna
08/29/25 5:29am
The 0-100 km/h acceleration time of the Audi Q2L is 8.7 seconds. The 0-100 km/h acceleration time refers to the time it takes for a vehicle to accelerate from 0 to 100 km/h, which is a direct reflection of the car's power. Various factors such as ambient temperature, road conditions, vehicle wear, and even the amount of fuel remaining in the tank can affect the test results. Taking the 2021 Audi Q2L as an example, it features a front MacPherson independent suspension and a rear multi-link independent suspension. It is equipped with a 1.4T turbocharged engine, delivering a maximum horsepower of 150 PS, a maximum power of 110 kW, and a maximum torque of 250 Nm. It is paired with a 7-speed dual-clutch transmission.
Was this review help?
7
1
Share
LaGage
09/11/25 3:13am
As an enthusiast who frequently focuses on car performance, I think the Audi Q2L with the 1.4T engine configuration has a 0-100 km/h acceleration time of approximately 8.5 seconds, which is a fairly average performance among urban SUVs. It features turbocharging technology, delivering smooth responsiveness—it doesn’t feel too aggressive at launch but provides steady propulsion. If you opt for the higher-spec all-wheel-drive version, it might be slightly quicker, but the overall difference isn’t significant. Many factors can influence this, such as insufficient engine warm-up in cold weather leading to sluggish acceleration or reduced tire grip on slippery roads. I’ve tested different driving modes, and in Sport mode, the acceleration feels more responsive, while Eco mode is gentler. For daily driving, I recommend paying attention to tire maintenance and engine health, and avoiding excessive overloading, as these can degrade acceleration performance. Overall, it’s not race-car-level acceleration, but it’s more than sufficient for daily commutes and highway overtaking.
Was this review help?
16
2
Share
Expand All
MacAnderson
10/25/25 4:02am
My experience commuting with the Audi Q2L tells me that its 0-100km/h acceleration of around 8.5 seconds is quite practical - neither too thrilling nor too sluggish. It starts smoothly in urban traffic without that sudden back-pushing discomfort, and responds well when overtaking on highways by stepping on the accelerator. The 1.4T engine delivers moderate horsepower with even power distribution, combined with a lightweight body design that makes the acceleration process quite stable. I've also noticed performance varies across road surfaces - acceleration is slightly slower on gravel roads due to traction adjustment, while normal asphalt roads perform as expected. When carrying the whole family with AC on, the increased load slightly reduces acceleration efficiency, but overall doesn't affect safety. Maintaining proper tire pressure and regular oil changes help preserve this performance level. For average drivers, this acceleration time is sufficient, allowing for both fuel efficiency and relaxed driving.
Was this review help?
10
4
Share
Expand All
More Forum Discussions

What Documents to Bring for Subject 2 Driving Test?

For the Subject 2 driving test, you only need to bring your ID card. Below is relevant information: Introduction: According to Article 25 of the 'Regulations on the Application and Use of Motor Vehicle Driver's Licenses' (Ministry of Public Security Order No. 123), the Subject 2 test includes: (1) For large buses, tractors, city buses, medium buses, and large trucks: stake test, slope fixed-point parking and starting, parallel parking, single-plank bridge, curve driving, right-angle turns, passing through width-limited gates, and passing continuous obstacles. Subject 2: For small car C1 license, the test items include reversing into a garage, parallel parking, slope fixed-point parking and starting, right-angle turns, and curve driving (commonly known as S-curve) – five mandatory items (some regions have a sixth item: highway toll card collection). For C2 license, the test items include reversing into a garage, parallel parking, right-angle turns, and curve driving (commonly known as S-curve) – four mandatory items.
10
1
Share

How long after the Subject 1 test can you apply for Subject 3?

You can apply for Subject 3 30 days after the Subject 1 test. Below is relevant information: The driving license test consists of three parts: traffic regulations and related knowledge, field driving, and road driving (including safe and civilized driving). The order of the test subjects is as follows: traffic regulations and related knowledge (referred to as Subject 1 [theory]), field driving (referred to as Subject 2 [nine items]), and road driving (referred to as Subject 3 [road test and safe and civilized driving]). Brief introduction: After completing the Subject 1 test, you must pass Subject 2 and Subject 3 within three years. If you fail to do so, the test results will become invalid, and you will need to re-register for the Subject 1 test. Under the new regulations, both Subject 2 and Subject 3 offer five attempts. If you cannot pass the test within these five attempts, you will need to retake the Subject 1 test.
8
5
Share

Where is the fuel filter located in the Kia Sportage?

The fuel filter in the Kia Sportage is located under the rear seats. The replacement steps for the Kia Sportage fuel filter are as follows: 1. Fuel pressure release procedure; 2. Disconnect the negative terminal of the battery; 3. Use a jack to lift the right side of the vehicle; 4. Lay down cardboard, prepare a fire extinguisher and a towel; 5. Remove the old fuel filter; 6. Install the new fuel filter. The Kia Sportage is equipped with a 2.0L 4-cylinder naturally aspirated engine, with a maximum horsepower of 161ps, maximum torque of 193nm, maximum power of 118kw, and maximum power speed ranging from 1500 to 3200rpm. The Kia Sportage's body dimensions are: length 4460mm, width 1850mm, height 1695mm, with a wheelbase of 2640mm.
13
4
Share

What are the new regulations for the annual inspection of 15-year-old sedans?

Small passenger vehicles over 15 years old need to undergo an inspection every 6 months to ensure they are in a drivable condition and eliminate potential safety hazards. Here are the relevant details: 1. New annual inspection regulations: Non-operational small and micro passenger vehicles with 9 seats or less (excluding minivans) must apply for an inspection compliance mark from the traffic management department every 2 years within the first 6 years, with an on-site inspection required in the 6th year; vehicles aged 6-10 years must undergo an on-site inspection every 2 years; vehicles aged 10-15 years must undergo an annual on-site inspection; vehicles over 15 years old must undergo an on-site inspection every 6 months. 2. Notes: "Six-year exemption from inspection" does not mean "no inspection"; it refers to exemption from on-site inspection within the first 6 years, but vehicle owners still need to apply for an inspection compliance mark (or electronic annual inspection mark) from the traffic management department every 2 years.
15
4
Share

What are the differences between T-Roc and Encore GX?

The differences between T-Roc and Encore GX: 1. Different engines: T-Roc uses a 1.4-liter turbocharged engine; Encore GX uses a 1.3-liter turbocharged engine. 2. Different body dimensions: T-Roc has a length, width, and height of 4318mm, 1819mm, and 1582mm respectively, with a wheelbase of 2680mm; Encore GX has a length, width, and height of 4463mm, 1813mm, and 1642mm respectively, with a wheelbase of 2640mm. 3. Different power outputs: T-Roc has a maximum horsepower of 150ps, maximum torque of 250nm, maximum power of 110kw, and maximum power speed of 5000 to 6000rpm; Encore GX has a maximum horsepower of 165ps, maximum torque of 240nm, maximum power of 121kw, and maximum power speed of 5600rpm.
2
2
Share

What size battery is suitable for a 1200W motor?

Selecting a battery is not directly related to the motor's power, but mainly depends on the motor's voltage and the desired runtime per charge. A battery with insufficient capacity will result in shorter endurance. If a large motor is paired with a battery that has inadequate capacity, the battery's lifespan may be affected. Here is some extended information: 1. Motor power: Motor power = Motor voltage × Motor current. With the battery voltage remaining constant, the higher the maximum current the motor windings can withstand, the greater the motor's power will be. A higher motor current also means greater heat generation, so thicker wire diameters and shorter total wire lengths are required to reduce internal resistance, thereby allowing higher currents to pass. Therefore, motors with higher power generally use thicker wires than those with lower power. 2. Battery: A battery is a type of cell, also known as a storage battery, which works by converting chemical energy into electrical energy. The term 'battery' commonly refers to lead-acid batteries, which primarily use lead and its oxides as electrodes and sulfuric acid solution as the electrolyte.
8
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.