What is ln052167f4 engine oil?

1 Answers
McBrooke
07/24/25 1:12am
Volkswagen LN052167F4 is a FAW-Volkswagen (Volkswagen) genuine 5W-40 gasoline engine oil/lubricant. FAW-Volkswagen genuine engine oils are divided into three viscosity grades: 5w-40, 0w-40, and 5w-30. Among them, only 0W-40 and 5W-30 are fully synthetic oils, while 5W-40 is a semi-synthetic oil. Below is relevant information about gasoline: 1. Compression ratio: The type of gasoline to use depends on the engine's compression ratio. Generally, the lower the compression ratio, the lower the fuel requirements. 95-octane gasoline is purer than 92-octane gasoline, as indicated by the higher number representing higher purity. Using a higher octane gasoline indicates a higher engine compression ratio. 2. Anti-knock performance: 92-octane gasoline contains 92% isooctane and 8% n-heptane, while 95-octane gasoline contains 95% isooctane and 5% n-heptane. This ratio difference affects their anti-knock properties. 92-octane gasoline is more prone to knocking, meaning it has poorer anti-knock performance, requiring the spark plug's ignition timing to be delayed to prevent knocking, resulting in relatively weaker power. In contrast, 95-octane gasoline is less prone to knocking, allowing the computer to control an earlier ignition timing, thus providing relatively stronger power.
Was this review help?
5
5
Share
More Forum Discussions

Tips for Resolving Engine Warning Light on 2010 Citroen C-Quatre

Citroen C-Quatre engine warning light can be resolved by removing carbon deposits. Emission faults caused by engine carbon buildup may result from frequent high-gear low-RPM driving, which leads to prolonged low-RPM high-load operation and subsequent carbon accumulation. Engine Cleaning: When the engine warning light illuminates, owners should promptly clean the engine: 1) Use specialized cleaning agents at repair shops to remove carbon deposits; 2) Apply quality fuel additives to clean the entire fuel system, including cylinder carbon removal. Using Higher Octane Fuel: After engine cleaning, to maintain optimal engine performance, owners may switch to 95 or 97 octane gasoline, which typically resolves the engine warning light issue.
4
2
Share

How to Use Turn Signals in a Manual Transmission Car?

When starting the vehicle, turn on the left turn signal. When parallel parking, turn on the right turn signal. At intersections and forks, turn on the left turn signal when turning left, and the right turn signal when turning right. When entering a roundabout, no turn signal is needed; when exiting, turn on the right turn signal. When overtaking, first turn on the left turn signal, and after maintaining a necessary safe distance from the overtaken vehicle, turn on the right turn signal to return to the original lane.
13
4
Share

How to Use the Lights in a Manual Transmission Car?

The common light controls are located on the left front of the steering wheel and the left control lever. Turn the light knob to the low beam symbol to turn on the car's low beams. Rotate the outer ring of the light control lever to the low beam symbol to turn on the low beams, and push the lever outward to switch to high beams. Rotate the inner ring of the light control lever to turn on the fog lights. Visibility is poor at night, so the speed should be appropriately reduced. On highways, there are usually no streetlights, so lighting relies entirely on the car's lights.
9
5
Share

How to Repair Car Interior Burned by a Cigarette?

Here are the methods to repair car interior burned by a cigarette: 1. Replace the car interior, which requires going to a 4S shop or a professional auto repair and beauty shop for professional technicians to operate; 2. Buy two ceiling buckles to cover the burned area; 3. Cover with stickers; 4. Cover with a band-aid of the same color; 5. Purchase a touch-up pen of the same color as the car roof for repair. If using the method of stickers or band-aids, first cut off the burned area with scissors, then clean it with a special car interior cleaner. A small toothbrush can be used for cleaning, limited to the blackened area, and then stick it on.
10
2
Share

What are the reasons for rapid coolant consumption without leakage?

Coolant is consumed quickly without leakage due to: internal engine leakage, which is a rare occurrence and can be identified by checking the engine oil. Functions of coolant: 1. Provides anti-corrosion protection for cooling system components; 2. Prevents scale formation to avoid reducing the radiator's heat dissipation efficiency; 3. Ensures the engine operates within the normal temperature range. Precautions for using coolant in vehicles: 1. Avoid mixing different types of coolant; 2. Refrain from using inferior quality coolant; 3. Do not directly add concentrated coolant to prevent coolant deterioration and low-temperature thickening.
17
2
Share

What to Do When the Car Handbrake Still Holds After Being Released?

If the car handbrake still holds after being released, you can first warm up the car. After warming up the car, start it slowly. Increase the throttle until you feel the car jerk, and the handbrake will naturally release. Then, under safe conditions, lightly tap the brake to smooth the contact surface of the brake disc. If the problem persists, you may need to visit an auto repair shop to replace the brake cable. If the rear wheels remain locked after releasing the handbrake, professional repair by an auto technician is required.
9
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.