What does the urea warning light look like?

What are the 3 situations of wheel lock-up?

Wheel lock-up can be divided into three situations: skidding, straight-line braking, and sliding. Skidding: When a car brakes sharply at high speed on wet or icy roads, dangerous situations may occur: the rear of the car deviates from the direction of travel during braking, and in severe cases, the car may spin around, losing directional stability. This phenomenon is called skidding. Straight-line braking: During braking, the driver cannot control the direction of the car, meaning the car loses directional controllability. If braking occurs on a curve, the car may slide off the road or into the opposite lane. Even during straight-line braking, the inability to control direction may prevent the driver from avoiding obstacles ahead. Sliding: The movement of the wheels relative to the road surface is no longer rolling but sliding. The lateral friction force and longitudinal braking force exerted by the road surface on the tires become very small. The slipperier the road, the more likely the wheels are to lock up. Additionally, the higher the initial speed of the car during braking, the greater the danger caused by wheel lock-up.

20

1

Share

How much does the Toyota RAV4 weigh?

2020 RAV4 weighs approximately 1.5 tons. The Toyota RAV4 is the base model in Toyota's compact multi-purpose off-road vehicle family. Positioned as an urban SUV, as a leader in urban SUVs, the RAV4 combines high quality and performance with driving comfort and excellent off-road capability. Below is relevant information about the RAV4: 1. Introduction: The Toyota RAV4 is the base model in Toyota's compact multi-purpose off-road vehicle family. Its name comes from the abbreviation of 'Recreational Active Vehicle with 4-wheel drive,' meaning 'four-wheel-drive recreational sports vehicle.' 2. Model: It features a completely new exterior and interior design style, with the overall shape further evolving towards an urban SUV, while the off-road style gradually recedes from this model. 3. Positioning: The RAV4 combines high quality and performance with driving comfort and excellent off-road capability, capable of handling both ONROAD and OFFROAD sections freely to meet diverse lifestyle needs.

11

1

Share

What are the causes of automatic transmission stalling?

Automatic transmission stalling is caused by: 1. Circuit failure, where a short circuit in the low-voltage line causes stalling; 2. Component failure, such as faults in the ignition coil, capacitor, or electronic ignition module; 3. Fuel system failure, including damage to the fuel pump, fuel line rupture, clogged carburetor fuel inlet, or an empty fuel tank. The solutions for automatic transmission stalling are: 1. Turn on the hazard lights; 2. Step on the brake to stop as soon as possible; 3. After stopping, shift the gear lever into the P position and turn the key to restart the engine; 4. Conduct inspection and repair after stalling occurs. The gears in an automatic transmission include: 1. P (Parking gear, starting gear); 2. R (Reverse gear); 3. N (Neutral gear); 4. D (Drive gear); 5. L (Low gear); 6. S (Sport mode); 7. OD (Overdrive gear).

19

2

Share

Why is the exclamation mark still there after the tire is repaired?

If the exclamation mark is still there after the tire is repaired, it indicates that there is an issue with the tire pressure of the vehicle, and further inspection is required. Related information: 1. Introduction: Tire pressure, strictly speaking, refers to the air pressure inside the tire. There is a label on the rear of the driver's side door that indicates the standard tire pressure, which is the pressure when the tire is cold, i.e., after the vehicle has been parked for at least three hours or driven no more than 1.6 km. The tire pressure is most accurate when measured while the tire is cold. 2. Expansion: Air pressure is the lifeblood of the tire. Both too high and too low pressure will shorten the tire's lifespan. Low pressure increases the deformation of the tire body, making it prone to cracks on the sidewalls, and also causes flexing movement, leading to excessive heat generation, promoting rubber aging, fatigue of the cord layer, and breakage of the cords. It also increases the tire's contact area with the ground, accelerating wear on the tire shoulders.

5

0

Share

Must a car exiting a parking space yield to through traffic?

A vehicle exiting a parking space must yield to through traffic, as vehicles leaving parking spaces generally need to turn, and traffic regulations stipulate that turning vehicles must yield to through traffic. Areas where parking is prohibited: Road shoulders marked with yellow no-parking lines indicate zones where roadside parking or vehicle stopping is forbidden, with the length of the marking indicating the prohibited range. Yellow grid lines designate areas where stopping is prohibited for any reason, typically applied at intersections or access points prone to traffic congestion caused by temporary parking. Special zones such as within 30 meters of bus stops, gas stations, emergency stations, and in front of fire stations do not permit temporary vehicle parking. No parking is allowed at intersections, railway crossings, sharp curves, narrow roads less than 4 meters wide, bridges, steep slopes, tunnels, or within 50 meters of these locations. Parking is prohibited on road sections with separation facilities between motor vehicle lanes and non-motorized vehicle lanes or sidewalks, as well as at pedestrian crossings and construction zones.

17

2

Share

Can a Second Engine Start After Water Immersion Be Detected?

After a vehicle has been submerged in water, it is possible to detect whether a second engine start has occurred. Insurance companies will dismantle the engine for inspection. Following a second start, water stains will be present on the intake grille and intake tract, and there will be sediment accumulation below the intake housing. Additionally, the originally smooth cylinder walls will show scratches, the engine oil will contain impurities, and the crankshaft connecting rods will exhibit rust. The issue of a second engine start is not explicitly addressed in the commercial auto insurance laws. However, most insurance companies follow the practice of either denying claims or applying partial exemptions for damages resulting from a second start after water immersion. The rationale is that stalling during water immersion is highly likely due to water entering the engine, and a second start constitutes human-induced damage. Self-rescue measures for a water-submerged vehicle include: If the water level has not risen above the exhaust pipe, the engine can be started normally, and the vehicle should be driven away promptly. If the water has just reached the chassis but has not entered the cabin, the vehicle can be powered on and pushed away. If water has already entered the cabin, do not attempt to save the vehicle due to the risk of electric shock. In such cases, the driver should immediately call for emergency assistance.

8

1

Share

What does the urea warning light look like?

What are the 3 situations of wheel lock-up?

How much does the Toyota RAV4 weigh?

What are the causes of automatic transmission stalling?

Why is the exclamation mark still there after the tire is repaired?

Must a car exiting a parking space yield to through traffic?

Can a Second Engine Start After Water Immersion Be Detected?

What is the troubleshooting method for a car generator not generating electricity?

Why is there water in the trunk?

What are the symptoms of a faulty plain bearing?

Where is the windshield washer fluid added in the car?