···
Log in / Register

What does the ECO mode in car air conditioning mean?

1 Answers
Cassandra
07/28/25 6:55pm
Car air conditioning ECO mode refers to the economic driving mode of the vehicle. When the ECO switch is pressed, the air conditioning will operate in the economical mode. The temperature set by the car air conditioning refrigeration system is relatively high, which means the compressor operates for shorter durations, reducing engine load and saving fuel consumption. Car air conditioning is an air conditioning device installed in vehicles that can cool, heat, ventilate, and purify the air inside the cabin, providing a comfortable environment for passengers, reducing driver fatigue, and improving driving safety. The cleaning method for car air conditioning is as follows: first, lift the engine hood, remove the clips securing the drainage channel, and after removing the drainage channel, you can see the dust filter. If the dust filter hasn't been used for long, it can be cleaned with high-pressure air. If it's already clogged, simply replace it with an original equipment manufacturer (OEM) dust filter.
Was this review help?
11
2
Share
More Forum Discussions

How many points are deducted for driving in the wrong direction on the highway?

Driving in the wrong direction on the highway results in a deduction of 12 points. Here is some information about driving in the wrong direction on the highway: 1. Legal provisions: Driving in the wrong direction on the highway is a more serious form of wrong-way driving. If a motor vehicle driver reaches 12 points or more twice in a single scoring cycle, or accumulates 24 points or more, the vehicle management office must also conduct a road driving skills test within ten days after the driver passes the examination on road traffic safety laws, regulations, and related knowledge. The road driving skills test should be conducted according to the highest permissible driving model specified on the driver's motor vehicle license. 2. Precautions: Regularly check online for traffic violation hotspots to be aware of locations where violations are most likely to be captured, and avoid repeated violations at the same location. Before setting off, study the travel route carefully to avoid detours or fines due to unfamiliarity with the route or violation of traffic rules.
18
0
Share

What does the L in automatic transmission mean?

In an automatic transmission, the L stands for Low gear. The L gear is used when driving uphill or starting on a steep slope. Other letters in an automatic transmission represent: R for Reverse, N for Neutral, D for Drive, S for Sport mode, OD for Overdrive, and P for Park. The method to start an automatic transmission car: 1. Turn the ignition key to the second position to the power position, and the car's computer system will begin self-checking; 2. Press the foot brake and shift the gear from P to N; 3. Release the foot brake and turn the ignition key to the start position. The steps to park an automatic transmission car: 1. Press the foot brake to stop the car and shift the gear from D to N; 2. Pull up the handbrake, turn off the engine, and release the foot brake, but do not turn off the power; 3. Press the foot brake, shift the gear from N to P, release the foot brake, turn the key back to turn off the power, and remove the key.
9
3
Share

Why Do Tires Make a Clicking Sound?

Here are several situations where tires may produce abnormal sounds: 1. Rhythmic clicking sound: If there is a rhythmic 'click-click-click' sound that gets faster with increasing speed, it is likely due to foreign objects on the tire, such as stones or nails. You can stop the car and check after parking. 2. Intermittent rattling sound: If there is an intermittent rattling or knocking sound when turning, going over bumps, or driving on rough roads, it may be caused by a damaged outer CV joint of the front axle, a broken shock absorber, or worn ball joints and bushings in the chassis suspension. It is advisable to visit a repair shop as soon as possible to eliminate potential safety hazards. 3. Obvious humming sound: If you hear a distinct humming sound while driving that gets louder with increasing speed, the most likely cause is a damaged front wheel hub bearing. To address abnormal sounds, it is best to drive to a repair shop and have a mechanic perform an actual inspection.
17
4
Share

How to Interpret a Three-Light Traffic Signal?

When encountering a traffic signal with three circular lights arranged side by side, which are full-screen lights without directional indicators, the general configuration is as follows: the leftmost light is for left turns, the middle light is for straight-through traffic, and the rightmost light is for right turns. The direction corresponding to a green light is permitted to proceed, while a red light indicates that movement in that direction is prohibited. Typically, the vertical sequence of these lights from top to bottom is: red, yellow, green. Rules for navigating intersections without traffic signals: 1. With traffic signs: At intersections controlled by traffic signs or road markings, vehicles that have the right of way to proceed to the center of the intersection should be allowed to pass first. 2. Without traffic signs: At intersections without traffic signs or road markings, vehicles must stop upon reaching the intersection to observe the traffic conditions. If a vehicle approaches from the right, it has the right of way. 3. Turning vehicles yield to straight-through traffic: Vehicles intending to turn must yield to vehicles going straight. 4. Right-turning vehicles yield to left-turning vehicles: At intersections where vehicles are approaching from opposite directions, right-turning vehicles must yield to left-turning vehicles.
19
2
Share

What is the meaning of front-wheel drive and rear-wheel drive in cars?

Front-wheel drive and rear-wheel drive in cars refer to front-wheel drive and rear-wheel drive, respectively. Two-wheel drive is further divided into four forms: front-engine rear-wheel drive, front-engine front-wheel drive, rear-engine rear-wheel drive, and mid-engine rear-wheel drive. Front-engine front-wheel drive means the engine is positioned at the front of the car, driving the front wheels, which in turn drive the entire vehicle. The layout of front-engine front-wheel drive sedans involves a transversely mounted engine connected to a compactly designed transaxle. Front-engine rear-wheel drive is a traditional driving method where the engine is positioned at the front and the rear wheels are driven. The differences between front-wheel drive and rear-wheel drive are: 1. Different behavior during sharp turns: Front-wheel drive cars have a heavier front and lighter rear, making them prone to understeer during sharp turns; rear-wheel drive cars have a lighter front and heavier rear, making them prone to oversteer, or tail sliding, during sharp turns. 2. Space differences: With the same wheelbase, front-wheel drive cars have a transversely mounted engine positioned more forward, resulting in more interior space; rear-wheel drive cars use a longitudinally mounted engine, which can encroach on interior space.
12
5
Share

What to Pay Attention to When Paying a Deposit for a Car Purchase

Here are the key points to consider when paying a deposit for a car purchase: 1. Product Specifications Clarity: The buyer and seller must clearly agree on the car's brand, origin, manufacturer, model, batch number, configuration, optional equipment, color, and interior decoration. For high-demand models, the delivery time must be specified. 2. Price: The price of the vehicle should be clearly stated, not just verbally agreed upon. 3. Delivery: The contract should specify the delivery time, location, method, and how to handle any issues regarding vehicle quality or delivery procedures upon receipt. It should also clarify the payment timing and method. Upon delivery, besides receiving the keys and the car, the buyer should obtain: the car sales invoice, vehicle certification, import documentation (for imported cars), inspection certificate, warranty card and manual, maintenance records (for used cars), list of included tools and accessories, vehicle registration or temporary license, user manual, product manual, and insurance policy. 4. Liability for Breach of Contract: Once rights and obligations are clearly defined, it becomes easier to determine who has complied or breached the contract. The contract should specify the consequences and remedies in case of a breach. A deposit is a common method to ensure contract fulfillment. If the party paying the deposit breaches the contract, the deposit will not be refunded or offset against the vehicle price. If the party receiving the deposit breaches the contract, they must return double the deposit amount.
18
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.