What does BSM mean on a car?

What kind of engine oil should be used for the new Santana?

Engine oil can meet the braking requirements of the new Santana, while gasoline cannot. More details about the new Santana are as follows: 1. Completely redesigned: The exterior design of the new Santana no longer resembles the 'Pusang' or Zhijun models. Its family-style front grille is similar to models like the new Lavida, making it more aligned with the aesthetic preferences of the modern generation compared to its predecessor. 2. Compact model: Similar to the overseas three-box POLO, new Jetta, and Skoda Rapid, it has a wheelbase of 2603mm, placing it in the compact sedan category. It also performs well in terms of passenger space. The new Santana's body dimensions are 4473*1706*1469 (mm), with a wheelbase of 2603mm. Compared to similarly priced joint-brand models like the Sunny, Corolla, and Excelle, it does not have an advantage in length, width, or height, but its wheelbase is slightly longer than these three comparison models.

8

5

Share

Can ETC be used without sticking it on the windshield?

ETC can be used without sticking it on the windshield. Installing ETC on the upper part of the windshield is to minimize obstruction of the driver's view and to ensure better recognition by the equipment at highway toll stations. For small cars, the ETC installation position is generally in the upper middle part of the front windshield, while for large vehicles like trucks and buses, the installation position is in the lower middle part. The appropriate installation position should be no lower than 1.2 meters and no higher than 2.5 meters, with an installation angle between 30 to 90 degrees. For vehicles with built-in or later-added anti-explosion films, which may affect the signal transmission of the microwave communication link, the ETC should be installed in the microwave window area. Here are some precautions for installing ETC: Do not block the view; it is best to install it behind the rearview mirror: Many car models have windshields with a large rear tilt angle, which reduces the driver's field of vision. If this is not considered during ETC installation, it can increase the driver's blind spots. Installing it behind the rearview mirror on the right side can avoid obstructing the view. Do not interfere with charging: The ETC electronic tag consumes power, but generally does not require charging or battery replacement because it has a solar panel on the back that can charge itself. Therefore, during installation, avoid the black areas on the windshield and positions that may block the solar panel. Once installed, do not remove it casually: The button in the middle of the adhesive is an anti-removal rod connected to a switch. After the electronic tag is installed, the windshield will press the anti-removal rod in. If the tag is removed casually, the rod will pop out and trigger the switch, locking the electronic tag and rendering it unusable. You will then need to visit an ETC service point to unlock it. This is designed to prevent multiple vehicles from sharing one device. When using ETC, note the following: The ETC transaction sensing range is 8 meters. To prevent the ETC device of the vehicle in front from malfunctioning, maintain a distance of more than 10 meters from the vehicle in front to avoid automatic payment for the front vehicle. The ETC lane recognition speed is 20 kilometers per hour; driving too fast may result in failure to read the vehicle's device information, leading to payment failure. When using a debit card linked to ETC, insufficient balance may also cause payment failure.

16

2

Share

What is the actual fuel consumption of the Tiguan L 330?

Around 8L. The all-new Tiguan L is equipped with Volkswagen Group's latest EA888 series 2.0T turbocharged engine, with a maximum power output of 132kW and a maximum torque of 300Nm. It is paired with a 7-speed wet dual-clutch transmission. Compared to its peers, this vehicle demonstrates excellent fuel efficiency. Below is more related information: Actual measured fuel consumption: The Volkswagen Tiguan L 380TSI 4MOTION Top Flagship version, still in its break-in period, was tested under conditions of 50% urban and 50% suburban driving with one passenger onboard. The test covered a total distance of 107 kilometers (specifically 107.6 km) at an average speed of 29km/h. The test included highway driving, urban ring roads, and congested city evening rush hours. The actual fuel consumed was 9.021L, resulting in a measured fuel consumption of 8.4L/100km, meeting expectations. During the Tiguan L test, the air conditioning was not used at all. The vehicle traveled a total of 107.6 kilometers, consuming 9.02L of fuel, with an average fuel consumption of 8.38L/100km. This result is very impressive, indicating that the powertrain system has high transmission efficiency and excellent performance in terms of fuel economy. The measured data closely aligns with the official fuel consumption figures.

2

4

Share

How to Charge a Chaowei Battery for the First Time?

For the first charge of a new battery, the charging time should be extended by 1-2 hours after the charger indicator light turns off. In summer, the supplementary charging time can be appropriately shortened, and prolonged charging after the light turns off should be avoided. The optimal time to charge is when the battery level drops to around 70%. In summer, after the charger light turns green, a float charge of 1~2 hours is sufficient. In winter, the float charge time can be extended by about 2 hours after the light turns green. For extremely cold regions in the north, it is advisable to bring the battery indoors for charging. Note: When the battery is completely drained (100% discharged), using a compatible charger typically requires 8~10 hours for a full charge, but it should not exceed 12 hours (as it may affect battery lifespan). It is best not to fully deplete the battery with each use; charging at around 70% battery level is recommended, with a charging time of 6~8 hours. Additional Notes: Precautions for Battery Usage: 1. Avoid completely draining the battery before recharging. If the battery is in a low-power state, it can damage the battery lifespan. Typically, charging when the battery level drops to half is sufficient. 2. Avoid overloading and speeding. During overload or speeding, the battery discharges at high current, which can harm the battery plates and reduce its lifespan. 3. If the battery is not used for an extended period, it should be fully charged and topped up every half month. Before reuse, ensure the battery is fully charged. 4. After approximately 6 months of use, it is recommended to have the battery capacity tested at an authorized dealer. If the capacity is below 60% or the battery is damaged, replacement may be necessary.

16

0

Share

Can You Still Drive with a Faulty ABS Sensor?

ABS fault light is on, it is recommended not to continue driving, because the ABS light on means that the vehicle's anti-lock braking system is faulty. During emergency braking, if the wheels lock up, the vehicle will lose control and skid, making it impossible for the driver to slow down or adjust the vehicle's trajectory, which poses significant safety hazards. There are various states of the ABS light being on, and the causes and solutions for different states vary. The details are as follows: State 1: ABS fault light stays on (most common). Cause 1: The sensing part of the ABS speed sensor is covered by dirt, mud, or other contaminants, affecting the sensor's ability to detect the corresponding speed signal. This prevents the ABS computer from determining the vehicle speed and the wheel slip rate, and thus cannot issue the appropriate commands to adjust braking. Solution: Clean the dirt on the speed sensor and adjust the gap between the speed sensor and the signal ring to restore normal function. Cause 2: Poor signal due to loose connections between system lines or poor contact of the ABS relay, leading to system failure. Solution: Check the line connections and reconnect any loose parts. State 2: ABS warning light intermittently lights up and turns off when accelerating. Cause: When multiple vehicle electrical devices are used, the battery voltage drops below 10.5V. As the engine speed increases, the voltage rises, and the ABS indicator light turns off; the ABS system power supply voltage is too low, such as due to poor contact at the terminals or grounding issues. Solution: Check the battery specific gravity; inspect the charging system; check the power supply (e.g., voltage relay or poor power contact). State 3: ABS warning light stays on after engine start and only turns off when the engine is turned off. Cause: Poor contact in the ABS hydraulic valve body grounding circuit; poor contact in the ABS hydraulic valve body wiring connector; ABS computer failure. Solution: Loosen the grounding screw of the hydraulic valve body, then retighten it, and clean the contact surface if necessary; check if the connector gap has widened; replace the ABS or ABS/ASR computer. State 4: ABS warning light turns on during high-speed driving. Cause: During high-speed driving, the ABS computer calculates that the rear wheel speed differs too much from the front wheel speed; incorrect tire specifications or incorrect wheel rim specifications. Solution: Refer to the vehicle's tire specifications and wheel rim specifications, as indicated on the sticker near the fuel tank cap. State 5: ABS warning light intermittently lights up. Cause: Improper adjustment of the brake light switch; poor internal contact in the brake light. Solution: Start the engine, press the brake pedal, push the brake switch linkage down with your finger, then release the brake pedal to complete the self-setting position; replace the brake light switch.

1

4

Share

What engine does the xbow use?

xbow uses the CDL engine model, with a maximum horsepower of 320 hp, a maximum power of 235 KW, a maximum power speed of 6500 rpm, and a peak torque of 400 Nm. The car has strong power performance and sufficient horsepower. The engine of the xbow is produced by Volkswagen. Volkswagen has continuously researched and upgraded the engine. For daily maintenance of the xbow's engine, the following methods can be used: Use lubricating oil of appropriate quality grade. For gasoline engines, SD--SF grade gasoline engine oil should be selected according to the additional devices of the intake and exhaust systems and the usage conditions; for diesel engines, CB--CD grade diesel engine oil should be selected according to the mechanical load, and the selection standard should not be lower than the requirements specified by the manufacturer. Regularly change the engine oil and filter. The quality of any grade of lubricating oil will change during use. After a certain mileage, the performance deteriorates, which will cause various problems for the engine. To avoid failures, the oil should be changed regularly according to the usage conditions, and the oil quantity should be moderate. When the oil passes through the fine holes of the filter, solid particles and sticky substances in the oil accumulate in the filter. If the filter is blocked and the oil cannot pass through the filter element, the filter element will burst or the safety valve will open, allowing the oil to pass through the bypass valve, bringing dirt back to the lubrication parts, accelerating engine wear and increasing internal pollution. Regularly clean the crankcase. During engine operation, high-pressure unburned gas, acid, moisture, sulfur, and nitrogen oxides in the combustion chamber enter the crankcase through the gap between the piston ring and the cylinder wall, mixing with metal powder generated by part wear to form sludge. A small amount of sludge is suspended in the oil, while a large amount will precipitate from the oil, blocking the filter and oil holes, making engine lubrication difficult and causing wear. Regularly use a radiator cleaner to clean the radiator. Removing rust and scale not only ensures the normal operation of the engine but also extends the overall life of the radiator and the engine.

16

1

Share

What does BSM mean on a car?

What kind of engine oil should be used for the new Santana?

Can ETC be used without sticking it on the windshield?

What is the actual fuel consumption of the Tiguan L 330?

How to Charge a Chaowei Battery for the First Time?

Can You Still Drive with a Faulty ABS Sensor?

What engine does the xbow use?

What is the fuel consumption of the Mercedes-Benz B-Class?

What car is represented by the letter V?

How often should the spark plugs be replaced in a Nissan Qashqai?

Why is the tire pressure low on rainy days?