What does 105V tire mean?

1 Answers
SanKyle
07/30/25 5:27am
The 105 in tire 105V indicates the load index, meaning each tire can carry a load of 925KG, and the V indicates the maximum speed of the tire is 240 km/h. The load index of a tire refers to the maximum load capacity the tire can bear when inflated to the specified pressure, while the speed rating of a tire refers to the maximum speed at which the tire is allowed to travel, generally represented by uppercase English letters and marked on the side of the tire. The maximum load capacity does not mean the tire will immediately fail if it exceeds this limit, but prolonged operation is not allowed. Prolonged operation will generate more heat, ultimately leading to tire fatigue damage, reduced lifespan, or even structural failure causing a blowout. Different letters represent different speed ratings. For example, "L" indicates a maximum allowable speed of 120 km/h, "T" represents 190 km/h, "V" stands for 240 km/h, and so on. Generally, higher-end cars use tires with higher speed ratings. However, the speed rating of a tire will decrease over time due to aging and reduced elasticity, and tire pressure also affects the speed rating—lower pressure leads to a lower speed rating. In daily use, pay attention to the following points regarding tires: Regularly check the tire surface for cracks, deformations, or other defects. Due to wear from driving, the tread grooves gradually become shallower. If the tread is worn flat, it loses its drainage and anti-slip functions, significantly reducing the car's performance. Small cracks may seem minor but can be a hidden danger for blowouts at high speeds. Additionally, promptly remove small stones stuck in the grooves. Try to park on flat ground. Avoid parking on roads with thick, sharp, or pointed stones. Do not park near or in contact with petroleum products, acids, or other materials that may deteriorate rubber. After parking, the driver should not turn the steering wheel, as this accelerates tire wear. Do not splash water for cooling. In hot weather or during high-speed driving, tires can overheat, and pressure may increase. In such cases, stop to allow the tires to cool naturally. Never release air to reduce pressure or splash water to cool them, as this may cause abnormal aging of the tread rubber. Avoid sudden braking. Try to minimize frequent or hard braking to prevent accelerated tread wear from dragging against the road.
Was this review help?
6
4
Share
More Forum Discussions

What Could Be the Reason When a Car Fails to Start?

There are 5 possible reasons why a car fails to start: 1. Car battery is dead or damaged: A dead battery requires jump-starting with another battery or using the universal push-start method. Failure to start may be caused by leaving headlights on for an extended period or an expired battery lifespan. Generally, replacing the battery according to the maintenance manual will resolve the issue. 2. No fuel pressure in the engine's fuel supply line: This situation often occurs on extremely cold mornings, caused by long-term contamination in the fuel line. At very low temperatures, water mixed with debris can block the fuel line, resulting in failure to start. 3. Car lacks antifreeze: Adding water or low-quality antifreeze can cause the entire cooling system to freeze in extremely cold winter conditions, leading to a cracked engine block. This prevents the water pump from functioning, resulting in failure to start and potential damage to other engine components. 4. Excessive carbon buildup in the vehicle: The solution is to frequently drive at highway speeds to reduce carbon deposits. 5. Steering wheel lock engaged: The steering wheel lock is a simple anti-theft feature. When the car is turned off, rotating the steering wheel from its centered position to a certain angle in one direction will activate the lock. Solution: Turn the steering wheel left and right while pressing the engine start button to release tension and unlock the steering wheel.
19
2
Share

How Many Turns of the Steering Wheel for Turning?

Here is the relevant introduction on how many turns of the steering wheel are needed when turning: 1. Right turn: one turn of the steering wheel: For a right turn, one turn of the steering wheel is generally sufficient. If it's a large intersection, you may feel the need to turn more during the right turn, but you should stop turning. If it's a small intersection and the angle isn't enough, you can adjust slightly. The angle of the steering wheel for a right turn depends on the size of the intersection—the larger the intersection, the smaller the angle of the steering wheel turn. 2. Left turn: half a turn of the steering wheel: Turning too much at a large intersection may lead you into oncoming traffic. Especially when turning left across two or three lanes, excessive steering in the right lane can interfere with left-turning vehicles in the left lane. The correct method is to turn the steering wheel slightly less than half a turn initially, then adjust if needed until it feels right. Additional Information: Precautions for turning: 1. For a tight turn, turn the steering wheel as much as possible, then gradually straighten it after completing the turn. 2. For a wide turn, turn the steering wheel slowly. 3. Beginners often focus only on what's directly ahead or to one side during a turn, neglecting blind spots, which can lead to hitting the curb or causing a scrape. 4. Always check for obstacles below the rearview mirrors; if necessary, open the door and look before turning.
20
3
Share

Which gear should an automatic transmission car be in when warming up?

It is safer to warm up an automatic transmission car in P (Park) gear, as this locks the tires. If in N (Neutral) gear, the car may roll even with the handbrake engaged, especially on uneven ground. Additionally, warming up in N gear results in low gearbox oil pressure, which can damage the gears. Below are the gear positions for an automatic transmission car: 1. P - Parking gear: After the car stops, engaging P gear applies the brakes to prevent movement. Some models feature an independent P gear, known as electronic parking, which functions on the same principle. 2. R - Reverse gear: This gear can only be engaged when the vehicle is stationary. Models with a lock button require pressing the button to switch to this gear. 3. N - Neutral gear: Use this gear for temporary stops, such as at traffic lights, and always engage the handbrake. Avoid using this gear when going downhill. 4. S - Sport gear: The difference between D (Drive) and S (Sport) gears lies in the computer switching different shifting programs. S gear can be engaged at any time without damaging the transmission. It is suitable for overtaking but not for high-speed driving. 5. D - Drive gear: The most commonly used gear. Shifting up or down is controlled via the accelerator. D1 (or L gear), D2, and D3 correspond to manual transmission gears 1 and 2, 3 and 4, and 5 and 6, respectively.
10
2
Share

Will leaving the car lights on overnight drain the battery?

Leaving the lights on while driving at night for an extended period can drain the car battery. Here are some specific details about automotive batteries: 1. Introduction: A car battery, also known as a storage battery, is a type of battery that works by converting chemical energy into electrical energy. Typically, when people refer to a car battery, they mean a lead-acid battery. This is a type of battery primarily made from lead and its oxides, with a sulfuric acid solution as the electrolyte. 2. Classification: There are many types of car batteries, which can mainly be categorized into conventional batteries, dry-charge batteries, and maintenance-free batteries. Each type of battery has its own characteristics, with distinct advantages and disadvantages.
14
3
Share

Which brand is the new energy electric car with a 'T' logo?

A new energy electric car with a 'T' logo is Tesla. Tesla, Inc. is an American company that manufactures and sells electric vehicles, founded by engineer Martin Eberhard on July 1, 2003, with its headquarters located in Silicon Valley, California, USA. Tesla is committed to accelerating the development of sustainable transportation with the most innovative technologies. Here is some relevant information: 1. Development: Tesla Motors is named after electrical engineer and physicist Nikola Tesla and specializes in the production of pure electric vehicles. Its major models include the Tesla Roadster, Tesla Model S, and Tesla Model X. Tesla Motors was the world's first electric vehicle company to adopt lithium-ion batteries, with its first electric vehicle being the Roadster. From 2008 to 2012, the company sold over 2,250 Roadsters in 31 countries. In 2010, the company began producing right-hand-drive Roadsters for the UK and Irish markets and expanded sales to Australia, Japan, Hong Kong, Singapore, and mainland China. On November 22, 2016, the company completed the acquisition of solar company SolarCity. 2. Logo: Tesla's 'T' logo is not only the initial of inventor Tesla's name but also carries deeper meaning. Tesla CEO Elon Musk once explained on his Twitter that this stylized 'T' is also a hint at the company's products, stating that the 'T' logo represents the cross-section of an electric motor. The main part of the letter 'T' represents a part of the motor's rotor, while the top line represents a part of the stator's outer section.
7
1
Share

What are the reasons for the Buick Regal not responding when stepping on the accelerator?

Buick Regal not responding when stepping on the accelerator may be due to the following reasons: 1. Transmission failure: This is relatively easy to diagnose. If the accelerator pedal cannot be depressed, the engine speed may suddenly increase from 2000 RPM to 4000 RPM. This happens because the power is cut off, causing the engine to suddenly operate with zero load, leading to speed fluctuations. Generally, when there are issues with the engine, including problems with the transmission control system, the engine warning light will illuminate, and a fault code will be stored. In this case, use a diagnostic tool to read the fault code. 2. Clutch: It might be that the clutch is not released; simply releasing it should resolve the issue. 3. Handbrake: If the handbrake is not released, it can also affect the accelerator response.
11
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.