What color of antifreeze should be added to the Nissan Qashqai?

2 Answers
McEmma
07/24/25 5:49am
Nissan Qashqai uses blue antifreeze, and the original antifreeze model is XTDB110700-L265. The method for replacing antifreeze is as follows: Before completely replacing the antifreeze, conduct a thorough inspection to check for any signs of leakage or cracks in the pipes, with a particular focus on the five-way water pipe. The antifreeze flows through the five-way pipe and is then distributed to different parts of the car to function. If there is any leakage of antifreeze in this part, replace the water pipe or re-secure the connection as needed. Drain the old antifreeze, then flush the fluid channels with clean water. Add clean water to the antifreeze reservoir, then continuously inject water into the reservoir to allow it to flow through the engine cooling system. Start the engine and let it idle for 3 to 5 minutes to circulate the water. The water initially flowing out of the reservoir will be slightly pinkish. Continue adding clean water until the outflowing water is clear. Note: Don’t forget to remove the heater hose and drain the water from the heater core. About one hour after draining, add the new antifreeze through the radiator hose. Then, add another container of antifreeze to the antifreeze reservoir until it is nearly full. Start the engine and let it run for about 10 minutes. During this time, the coolant level will drop slightly as air is purged from the system. Add more antifreeze until the level reaches the "MAXT" mark on the reservoir.
Was this review help?
1
5
Share
McAlexa
08/11/25 1:33am
I've been driving a Nissan Qashqai daily for several years, and I usually use the green type of coolant. The factory recommends the green bottle with organic acid technology formula, which can prevent corrosion and scale. The color is not chosen randomly; green indicates compatibility with Nissan's engine system. Adding other colors like red or blue may cause sediment to block the radiator, and it won't provide good protection against freezing in winter. It's safest to change the coolant every two years, as old coolant deteriorates and weakens the cooling effect. Check the expansion tank level when the engine is cold, and if it's below the Min line, add Nissan's special green bottle or a compatible 50/50 pre-mixed coolant. Don't add tap water to prevent scaling—safety first for a worry-free drive.
Was this review help?
8
3
Share
Expand All
More Forum Discussions

Why does the Breeze have higher fuel consumption than the CR-V?

This is related to individual driving habits. Here is the relevant information: 1. The Breeze and CR-V are actually sister models, sharing the same powertrain and chassis. The Breeze is equipped with two types of engines: a 2.0-liter naturally aspirated engine and a 1.5-liter turbocharged engine. 2. The model with the 2.0-liter naturally aspirated engine is the hybrid version. The Breeze's 2.0-liter naturally aspirated engine delivers 146 horsepower and a maximum torque of 175 Nm, with the maximum torque achieved at 3500 rpm and the maximum power at 6200 rpm.
5
3
Share

How many coolant temperature sensors does the Mercedes-Benz E200 have?

Mercedes-Benz E200 has 2 coolant temperature sensors. Introduction to coolant temperature sensor: The coolant level and temperature sensor consists of a thermostat section and a water level control section, with matching components including a pressure reducing device before the electric valve and a rotary muffler heater for heating. Function of coolant temperature sensor: The temperature sensor converts coolant temperature into electrical signals to adjust fuel injection quantity (increasing injection during cold starts), modify ignition timing (advancing timing at low temperatures while delaying it at high temperatures to prevent knocking), and influence idle control valve operation (ECU controls idle speed based on sensor signals during cold starts to increase RPM).
6
5
Share

Where is the air conditioning filter located in the Mercedes-Benz S400?

The air conditioning filter of the Mercedes-Benz S-Class is located behind the glove compartment. Specific reasons: Lack of antifreeze used by the engine, the engine's antifreeze reaching the replacement cycle, damage to the engine thermostat, excessively dirty air conditioning filter, or blockage in the vehicle's circulation system, among other reasons, can all cause the vehicle's heating system to not produce enough heat. Solution: When the heating system of the vehicle does not produce enough heat, you can inspect the vehicle's heating system using a troubleshooting method. After identifying the specific fault, carry out the corresponding repairs. If any parts cannot be repaired, they should be replaced directly. After repairs, the vehicle's heating system will return to normal operation.
17
1
Share

What car brand has the SWM logo?

SWM is a brand founded in Milan, Italy. Here is the relevant information: 1. In 2014, Dongfang Xinyuan Holdings fully acquired the Italian SWM brand and established the SWM Motors Design Center in Milan, Italy. Currently available models include: SWM X3; SWM X7; SWM G01; among which the SWM G05 is about to be launched. 2. Not long ago, SWM Motors announced the official launch of the new SWM G01-F edition. The exterior design of the new SWM G01-F edition remains consistent with the 2018 G01-F edition. This F edition can be considered as the sports kit version of the SWM G01, including components such as the grille, front/rear bumpers, front lip, and exhaust tailpipes.
10
1
Share

Will crossing solid lines on highways always be captured by cameras?

Crossing solid lines on highways will always be captured by cameras. The specific meanings of highway solid lines: 1. Rumble strips: The raised white markings on the road are rumble strips, reminding drivers of curves, downhill sections, etc. 2. Optical illusion markings: These create an optical illusion where the road appears to narrow or sink, prompting drivers to slow down before entering tunnels. 3. Deceleration markings: These visually narrow the lane to create a sense of pressure, alerting drivers to slow down at curves, ramps, etc. 4. Channelizing lines: Used at irregular, overly wide, or complex intersections and other special locations.
2
3
Share

Can a Car Still Run Without Fuel?

When the fuel gauge indicates empty, a car can typically continue to drive for approximately 70 kilometers. Below are specific details about a car's fuel tank: Marked capacity is the safe volume: The volume marked on most fuel tanks represents the safe capacity, which is generally about 10% less than the actual capacity. During the design of the fuel tank, considering the thermal expansion and contraction characteristics of fuel, a certain amount of space must be left inside the tank after filling to the rated volume to prevent excessive internal pressure and ensure driving safety. Fuel gauge cannot accurately reflect fuel level: It is not possible to precisely determine the remaining fuel based solely on the fuel gauge on the dashboard, as it provides a qualitative indication rather than a quantitative measurement of the fuel in the tank.
9
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.