What causes the reversing camera on the VV6 not to display?

How to Adjust the Gear Switch on a Peugeot 307?

Loosen the fixing screw of the gear switch and place the gear lever in the N position. Some automatic transmissions have a reference line engraved on the gear switch housing. During adjustment, align this reference line with the notch on the manual valve rocker shaft. Once the gear switch position is properly adjusted, secure it in place. Move the gear lever through all positions and check if the gear indicator light matches the gear lever position.

13

2

Share

What to Do When the Small Battery of BAIC New Energy Vehicle Runs Out of Power?

Turn the ignition switch to the ON position, press the horn once, and turn on the headlights. If the dashboard does not light up, it can basically be determined that the battery is out of power. If you have a battery jumper cable, connect it to the battery of another normal vehicle for a cross-vehicle jump start. After a successful start, wait for about 5 minutes before disconnecting the jumper cable. If there is no way to replenish the power in time, then unfortunately, you can only wait quietly for rescue. If the vehicle is a BAIC New Energy vehicle, you can call for assistance and wait for rescue.

19

1

Share

Do You Need to Wait for a Red Light When Making a U-Turn?

If there is a U-turn signal light and it is red, you must wait to make a U-turn. Otherwise, it will be considered running a red light, which, according to the "Road Traffic Safety Law," results in a penalty of 6 demerit points and a fine of 200 yuan. If there is no U-turn signal light, and the gap is marked with a dashed line, the U-turn is not affected by the traffic light and does not require crossing the pedestrian crossing. However, if the gap is marked with a solid line, the U-turn must cross the pedestrian crossing and is subject to the left-turn signal light. Making a direct U-turn without following these rules may result in being photographed or penalized by on-site traffic police. When making a U-turn that requires crossing a pedestrian crossing, you must yield to pedestrians: If pedestrians are walking on the right side of the crosswalk and have not reached the centerline of the road, vehicles on the left side must slow down and ensure safety before proceeding. If pedestrians are waiting outside the boundary of the motorized and non-motorized lanes and have not entered the roadway, vehicles should slow down and proceed only after ensuring safety. If pedestrians have crossed the boundary between motorized and non-motorized lanes, vehicles must stop; otherwise, it is a violation and subject to penalties. If pedestrians have entered the motorized lane (Lane A) via the crosswalk, vehicles in Lane B must slow down and proceed only after ensuring safety. If vehicles in Lane A do not stop, it is a violation and subject to penalties. If pedestrians are waiting at the centerline of the road without entering the motorized lane, vehicles must stop; otherwise, it is a violation and subject to penalties. If pedestrians cross the centerline and enter the motorized lane, vehicles must stop; otherwise, it is a violation and subject to penalties. If the road is divided by a green belt and pedestrians are waiting in the middle area, vehicles must slow down and proceed only after ensuring safety. Scenarios where U-turns are allowed: If there is a U-turn sign at the intersection, you can make a U-turn. If there is a U-turn signal light, follow its instructions. If there is no signal light, make the U-turn without obstructing other vehicles or pedestrians. If there is no explicit "No U-turn" or "No Left Turn" sign at the intersection, a U-turn is allowed. "No explicit prohibition" means the absence of "No U-turn" or "No Left Turn" signs and no solid centerline. U-turns are also allowed in yellow grid zones. Yellow grids indicate no-parking areas at intersections or key locations. While stopping in these zones is prohibited, making a U-turn is allowed unless there is a central barrier. If there is a U-turn signal light, follow its instructions—only proceed on green. If "No Left Turn" and "U-turn Allowed" signs appear together, U-turns are permitted, but left turns are not. Note that "No U-turn" does not necessarily mean "No Left Turn." Things to note when making a U-turn at an intersection: Check the road markings. If they are solid lines, U-turns are prohibited under any circumstances. Continue driving to find a suitable location. If there is a "No Left Turn" sign, even without a "No U-turn" sign, U-turns are not allowed because U-turns inherently involve a left turn. U-turns must be made from the innermost left-turn lane. If you are in the second left-turn lane, U-turns are not allowed at that intersection. Always yield to straight-moving vehicles. Only make a U-turn if it does not interfere with their normal flow. Otherwise, you will bear full responsibility for any accidents. Near the stop line at intersections, lanes often have guiding arrows. The leftmost lane is not always for left turns only. If it has a straight arrow, U-turns are prohibited even without explicit "No U-turn" signs.

13

0

Share

What to Do If the Key is Locked Inside a BMW 5 Series?

Generally, vehicles come with two keys, one of which is a spare. If the car is accidentally locked, you can use the spare key to unlock it. However, locksmiths may require documentation, and if the documentation is incomplete, they may refuse service. Check the trunk to see if you can lift the rear seats to gain access. Many high-end models nowadays are equipped with a remote car networking system. If the car is accidentally locked, you can call the manufacturer's after-sales service system for assistance in unlocking the car.

9

2

Share

Why Does a Car Suddenly Sound Like a Motorcycle?

There are several reasons why a car might suddenly sound like a motorcycle: 1. Abnormal engine noise: There are many possible causes for unusual sounds in the engine compartment, often manifesting as sharp metallic noises or wind-like whistles. Abnormal engine noises indicate a change in the technical condition of a certain engine mechanism, usually caused by excessive wear of some parts or improper assembly and adjustment. Some abnormal noises may even signal potential catastrophic engine damage, so it is crucial to repair the engine promptly when such noises occur to prevent further damage. 2. Transmission noise: If there is a "sandy" sound inside the transmission while driving, which disappears when the clutch or accelerator is pressed, or if there is a whistling sound during gear shifts, these could indicate transmission issues. The transmission consists of many parts, making the causes of noise quite complex. When analyzing and diagnosing, pay attention to: Whether the noise is related to specific speeds, such as planetary gears that become noticeably noisy around 50 km/h. Whether the noise is linked to certain gears—this is crucial for diagnosing transmission faults. If a specific gear produces noise, it is likely related to components affecting that gear's transmission. If all gears produce noise, it often indicates a fault in the constant-mesh gear shaft or insufficient transmission oil. Whether the noise is related to specific actions, such as shifting gears, starting, rapid acceleration, sudden deceleration, or turning—these are effective indicators for diagnosing abnormal noises. Changes in speed and direction are particularly important for identifying rear axle issues.

6

1

Share

What is the identity of white license plate vehicles?

White license plate vehicles are special license plates for judicial departments, armed police, and other special units. Below is relevant information about temporary license plates: Conditions for obtaining temporary license plates: When driving a vehicle from the place of purchase to the place of use, a temporary license plate must be applied for at the vehicle management office in the place of purchase. When transferring vehicle registration and after surrendering the official license plate, a temporary license plate must be applied for at the local vehicle management office to drive back to the original location. For new vehicles that have not obtained an official license plate in the local area but need to be driven to another location for modifications, a temporary license plate must be applied for locally. After modifications are completed, a temporary license plate must be applied for at the local office to drive back to the original area. When purchasing a vehicle locally and driving it to another location, a temporary license plate must be applied for locally to drive to the other location, and vice versa. Application procedures: To apply for a temporary license plate, fill out the "Temporary Vehicle Registration Form" and submit the required documents: identification of the vehicle owner and the agent, proof of vehicle origin, the whole vehicle factory certificate for domestically produced vehicles, import certificates for imported vehicles, and imprints of the vehicle identification number (VIN) and engine number.

10

0

Share

What causes the reversing camera on the VV6 not to display?

How to Adjust the Gear Switch on a Peugeot 307?

What to Do When the Small Battery of BAIC New Energy Vehicle Runs Out of Power?

Do You Need to Wait for a Red Light When Making a U-Turn?

What to Do If the Key is Locked Inside a BMW 5 Series?

Why Does a Car Suddenly Sound Like a Motorcycle?

What is the identity of white license plate vehicles?

What is the charging power of the Ora Black Cat?

How to Set Up Auto Window Roll-Up When Locking the Baojun 510?

How to Drive a Porsche Automatic Transmission?

What Causes Paint Bubbling?