What Causes High RPM in a Sedan?

Can You Buy a Car Without a Driver's License?

You can buy a car without a driver's license, but you cannot drive the car on the road after purchasing it, as driving without a license is illegal. When registering the car after purchase, a driver's license is not required. More information about the vehicle license is as follows: 1. After purchasing a new car, registering it requires an ID card, certificate of conformity, purchase invoice, proof of purchase tax payment, insurance policy, etc. At the vehicle management office, staff will inspect the vehicle and take photos of it. 2. After the car is registered, the owner will receive a vehicle registration certificate and a vehicle license. The vehicle registration certificate is equivalent to the car's household register, and the vehicle license is equivalent to the car's ID card. 3. The vehicle license must be carried with the car, while the registration certificate is not recommended to be kept in the car; it is advised to store the registration certificate at home.

13

0

Share

How to Check the Tire Pressure Monitoring in Sagitar?

The Sagitar's tire pressure monitoring system does not have a separate air pressure display. When the air pressure exceeds the standard value, a yellow light will appear on the dashboard. The tire pressure monitoring indicator light indicates abnormal tire pressure. Tire pressure monitoring involves real-time automatic monitoring of tire pressure during driving, with alerts for tire leaks and low pressure to ensure driving safety. There are three commonly used tire pressure monitoring methods: Direct Tire Pressure Monitoring: The direct tire pressure monitoring device uses pressure sensors installed in each tire to directly measure tire pressure. It transmits pressure information from inside the tire to a central receiver module via a wireless transmitter, then displays the pressure data for each tire. The system automatically alerts when the tire pressure is too low or there is a leak. Indirect Tire Pressure Monitoring: When the pressure in a tire decreases, the vehicle's weight causes the rolling radius of that wheel to become smaller, resulting in a faster rotation speed compared to other wheels. By comparing the differences in rotation speeds between tires, the system monitors tire pressure. The indirect tire pressure alert system essentially relies on calculating the rolling radius of the tires to monitor pressure. Introduction to Tire Pressure Monitoring System (TPMS): It combines the advantages of the two systems above. Direct sensors are installed in two diagonally opposite tires, along with a 4-wheel indirect system. Compared to using only a direct system, this hybrid system can reduce costs and overcome the limitation of indirect systems, which cannot detect simultaneous low pressure in multiple tires. However, it still cannot provide real-time data on the actual pressure in all four tires, as a direct system can.

17

2

Share

Why Do Vans Lack Heating Function?

The heating principle of vans is fundamentally identical to that of household sedans. The absence of heating functionality may stem from the following causes: 1. Hot coolant fails to reach the heater core. Potential culprits include clogged heater hoses or malfunctioning heater control valves. This issue can be preliminarily diagnosed by manually checking two heater hoses (leading into the cabin) in the engine compartment - if one hose remains cold while the other gets warm, it indicates either heater core or heating system malfunction. 2. Heated air isn't properly delivered through vents. Contributing factors may involve clogged cabin air filters, stuck blend door actuators, detached control cables or faulty servo motors, or insufficient airflow from blower motors.

12

4

Share

Where is the spark plug located on the Cruze?

The spark plug of the Cruze is located under the engine hood. Open the engine hood, and you will find a rectangular cover next to the engine oil filler port. Remove this cover to access the spark plugs. Procedure for replacing spark plugs: Open the engine hood and remove the plastic engine cover. Detach the high-voltage ignition wires, marking each wire according to its corresponding cylinder position to avoid confusion. Use a spark plug socket to remove each spark plug one by one. While removing them, check for any debris like leaves or dust around the area and ensure it is thoroughly cleaned. Insert the new spark plug into the spark plug hole. Hand-tighten it a few turns before using the socket wrench to secure it. Reinstall the high-voltage ignition wires in the correct firing order, then reattach the engine cover. Replacement intervals for spark plugs: Under normal maintenance conditions, spark plugs should be replaced every 40,000 to 60,000 kilometers. However, this may vary depending on the brand and engine type, so always refer to the owner's manual for specific recommendations. Platinum spark plugs typically need replacement at 40,000 km, standard nickel alloy spark plugs at 20,000 km, and iridium spark plugs between 60,000 to 80,000 km.

9

1

Share

What engine is used in the Dongfeng Fengguang 370?

Dongfeng Fengguang 370 uses a naturally aspirated engine. Here are the extended details: 1. Natural aspiration is a form where air is drawn into the combustion chamber by atmospheric pressure without the use of any supercharger. 2. The mixture is drawn in by the naturally formed pressure difference, increasing the pressure and density of the gas. When the valve opens, the pressure difference and the high pressure of the gas itself increase the intake volume, thereby enhancing power. 3. The Fengguang 370 is an MPV model under the Dongfeng Fengguang brand. Its dimensions are 4565 mm in length, 1725 mm in width, and 1810 mm in height, with a wheelbase of 2725 mm. This model is available in both five-seat and seven-seat versions.

7

4

Share

Is built-in or external tire pressure monitoring better?

Tire pressure monitoring systems, whether built-in or external, each have their own advantages and disadvantages, and the choice can be made based on the specific vehicle situation. 1. Pros and cons of built-in tire pressure monitoring devices: Advantages; Installed inside the tire, using a sensor-equipped valve stem to replace the original one, with minimal external protrusion, not extending beyond the wheel hub. Once installed, it is essentially a one-time solution (can last over 5 years without issues). Disadvantages: Complex installation process, and requires wheel balancing. 2. Pros and cons of external tire pressure monitoring devices: Advantages: Easy installation. No need to replace the valve stem, no wheel balancing required, and may not even require inflating or deflating the tire. All the owner might need to do is screw the sensor onto the valve stem. Disadvantages: Not suitable for SUV models with higher tire pressure. Inflating or deflating requires removing and reinstalling the sensor, and external sensors are more susceptible to damage from foreign objects.

14

4

Share

What Causes High RPM in a Sedan?

Can You Buy a Car Without a Driver's License?

How to Check the Tire Pressure Monitoring in Sagitar?

Why Do Vans Lack Heating Function?

Where is the spark plug located on the Cruze?

What engine is used in the Dongfeng Fengguang 370?

Is built-in or external tire pressure monitoring better?

Are Position Lamps and Outline Lamps the Same?

How Many Kilometers Should You Change Transmission Oil?

What is the emission standard for cars from 2011?

Why does a Nissan car display 'PS' and fail to start?