What car brand has the SWM logo?

1 Answers
LilyLee
07/30/25 9:59am
SWM is a brand founded in Milan, Italy. Here is the relevant information: 1. In 2014, Dongfang Xinyuan Holdings fully acquired the Italian SWM brand and established the SWM Motors Design Center in Milan, Italy. Currently available models include: SWM X3; SWM X7; SWM G01; among which the SWM G05 is about to be launched. 2. Not long ago, SWM Motors announced the official launch of the new SWM G01-F edition. The exterior design of the new SWM G01-F edition remains consistent with the 2018 G01-F edition. This F edition can be considered as the sports kit version of the SWM G01, including components such as the grille, front/rear bumpers, front lip, and exhaust tailpipes.
Was this review help?
10
1
Share
More Forum Discussions

What are the car maintenance items at 10,000 kilometers?

The car maintenance items at 10,000 kilometers are as follows: 1. Change the engine oil on time: Mineral oil should be changed every 5,000 kilometers or once a year, semi-synthetic oil every 7-8 months or around 7,500 kilometers, and full-synthetic oil every 10,000 kilometers or once a year. 2. Check the tire pressure: If there is a tire pressure monitoring system, adjust according to the monitoring results. Insufficient or excessive tire pressure will increase uneven tire wear and fuel consumption. 3. Replace the engine air filter: The engine air filter and cabin air filter are generally replaced every 10,000 to 20,000 kilometers, and the engine throttle should be cleaned every 20,000 to 30,000 kilometers, depending on the situation.
5
0
Share

What Causes the Car Warning Light to Illuminate?

Automobile warning lights illuminate for the following reasons: 1. Poor fuel quality: If the engine warning light on the dashboard comes on shortly after refueling, it is usually due to the use of improper, substandard, or poor-quality fuel, which leads to incomplete combustion of the air-fuel mixture during engine operation. 2. Oxygen sensor malfunction: Modern vehicles are typically equipped with two oxygen sensors, one before and one after the catalytic converter. These sensors monitor the air-fuel ratio under different engine conditions. The front sensor provides signals to the ECU (Engine Control Unit) to adjust fuel injection and calculate ignition timing, while the rear sensor checks the efficiency of the catalytic converter. 3. Mass airflow sensor failure: If the mass airflow sensor malfunctions, the ECU cannot receive accurate intake air volume signals, leading to similar issues as above and causing the engine to operate abnormally.
19
0
Share

Why is R the Reverse Gear?

R stands for reverse gear because it is derived from the first letter of the English word "reverse." The reverse gear enables the vehicle to move backward, with its direction of travel opposite to that of the forward gear. Precautions for using the R gear include: 1. Ensure the car comes to a complete stop before engaging the R gear; 2. Pay attention to the warning sounds from the reverse parking sensors; 3. Observe the surroundings and rear of the vehicle carefully. The functions of vehicle gears are: 1. P gear (Parking gear or Lock gear): Used when the vehicle is stationary or parked with the engine off; 2. N gear (Neutral gear): Used for temporary stops; 3. D gear (Drive gear): Engaged when the vehicle is moving forward.
15
0
Share

How Far Can the Changan Kuayue Wang's Fuel Gauge Actually Go?

Changan Kuayue Wang's fuel gauge can typically allow the vehicle to travel approximately fifteen to thirty kilometers. The function of the fuel gauge is to display the fuel level in the car's tank. The fuel gauge consists of a voltage regulator, a fuel indicator, and a fuel level sensor. The low-fuel warning device activates when the fuel level in the tank falls below a specified threshold, alerting the driver to refuel. Precautions for using the car's fuel gauge include: 1. Avoid waiting until the warning light comes on to refuel, as too little fuel can impair the fuel pump's operation and reduce its lifespan; 2. Indicator deviation—when replacing the battery or fuel filter, the fuel gauge needle may show a lower level upon restarting the vehicle. This is normal due to pressure release in the tank causing the fuel level to drop.
6
1
Share

What causes the zizzing sound after starting the car?

The reasons for the zizzing sound after starting the car are as follows: 1. Carbon brush damage: It may be due to a fault in the carbon brush inside the starter motor; 2. Belt aging: Over time, the engine belt may age and slip, producing a squeaking sound; 3. Loose screws: Loose engine mount bolts may cause improper engine support installation. Here are the solutions for the zizzing sound after starting the car: 1. Loose screws: If it's due to loose engine mount bolts, you can locate and tighten the specific screws yourself; 2. Belt aging: If the belt is loose or aged, replacing it with a new one can resolve the issue. 3. Carbon brush damage: If the carbon brush inside the motor is faulty, it's best to seek professional help at a 4S shop and avoid dismantling the engine yourself.
12
2
Share

What Causes Tire Wear?

Tire wear can be attributed to the following reasons: 1. Wear on both shoulders of the tread: If the tread shoulders of the car tire are worn, it may be due to insufficient tire pressure or vehicle overload. Additionally, insufficient tire pressure or overload can increase fuel consumption and cause the tire temperature to rise excessively, leading to a blowout. 2. Central tread wear: The main cause of central tread wear is excessive tire pressure. High tire pressure reduces the contact area with the ground, resulting in central tread wear. Excessive tire pressure can also overstretch the cord layers, potentially causing blowouts on uneven roads. 3. Inner or outer tread wear: Inner or outer tread wear may be caused by improper front wheel toe-in or abnormal wheel camber. Frequent sharp turns during daily driving can also lead to inner or outer tread wear. 4. Wavy or scalloped tread wear: Wavy or scalloped tread wear is generally caused by poor wheel balance, resulting in steering wheel vibration during turns and uneven tire wear. It can also be due to inaccurate front wheel alignment. Therefore, it is essential to regularly inspect the car's tires to avoid malfunctions and unnecessary losses for the owner.
13
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.