What brand engine is the BJ40 equipped with?

1 Answers
EmmettAnn
07/30/25 9:50am
The BJ40 is equipped with a 2.4L inline-four naturally aspirated engine with the code name G4CA, which is an improvement over the 2.7L engine previously used in the BAW Warrior. It offers two power options: 2.0T and 2.3T, capable of delivering maximum torque outputs of 320N·m and 350N·m, respectively. More details are as follows: 1. Exterior design: The Beijing Auto BJ40, with its rugged SUV style, features numerous right-angle designs, exuding a strong masculine appeal. Interior design: As an off-road vehicle, it does not boast luxurious decorations but adopts a simple and rugged design style reminiscent of the "Wrangler." The window and central locking switches are designed as toggle levers, giving a very retro feel. 2. Powertrain: The BJ40 is powered by a 2.4L naturally aspirated engine, delivering a maximum power of 105kW and a maximum torque of 217Nm, paired with a 5-speed manual transmission. The new vehicle also features a mechanical part-time four-wheel-drive system and employs a body-on-frame structure. Additionally, the Beijing Jeep BJ40's rear suspension is a five-link non-independent setup, providing better support for extreme off-road conditions.
Was this review help?
20
3
Share
More Forum Discussions

Does replacing the engine affect third-party insurance?

Replacing the engine has an impact on insurance claims and vehicle transfer. The owner of the motor vehicle must apply for a modification registration with the local vehicle management office. Introduction to Third-Party Liability Insurance: Motor vehicle third-party liability insurance, referred to as third-party liability insurance, covers the financial liability that the insured or their permitted driver must bear by law when an accident occurs during the use of the insured vehicle, resulting in bodily injury, death, or direct property damage to a third party. The insurance company is responsible for compensation. Definition of Third-Party Liability Insurance: In the past, most local governments classified third-party liability insurance as compulsory insurance. Without this insurance, motor vehicles could not be licensed or undergo annual inspections. After the introduction of Compulsory Traffic Accident Liability Insurance (commonly known as compulsory insurance), third-party liability insurance became non-compulsory. Since compulsory insurance provides relatively low compensation for third-party property losses and medical expenses, purchasing third-party liability insurance can be considered as a supplement to compulsory insurance.
7
5
Share

Can the Battery Be Charged by Idling for Twenty Minutes?

The reasons for increased fuel consumption in the Tayron GTE charging mode are as follows: Dirty Throttle: A dirty throttle can cause increased fuel consumption, so it is necessary to clean the throttle regularly, generally every 20,000 kilometers or so. Since modern vehicles use electronic throttles, it is essential to perform an idle learning procedure after cleaning the throttle; otherwise, the idle speed will become higher. Excessive Carbon Deposits in the Intake Tract: Excessive carbon deposits in the intake tract and cylinders can also lead to increased fuel consumption, so it is necessary to clean the carbon deposits in the cylinders and intake tract regularly. Generally, this should be done every 2 years or 60,000 kilometers. Aging Spark Plugs: Aging spark plugs can also cause increased fuel consumption, so they need to be replaced periodically. Ordinary spark plugs should be replaced every 30,000 kilometers or so, while platinum spark plugs should be replaced every 100,000 kilometers or so. If you notice a lack of power, they should be replaced as soon as possible.
15
2
Share

What is the reason for the Cater 320D's unilateral walking weakness?

Cater 320D unilateral walking weakness reasons are as follows: Motor overflow valve failure: Excavator travel motor overflow valve failure can cause the excavator to have unilateral walking weakness. Central rotary joint damage: Central rotary joint oil seal damage can cause the excavator to have unilateral walking weakness. Travel motor damage: Check the travel motor to see if there are any internal faults, travel motor damage can also cause the Cater 320A excavator to have unilateral walking weakness. Track walking consistency: Also observe whether the tracks are consistent during walking, if not, it indicates there is a problem with track adjustment.
4
3
Share

How much engine oil should be added to the Maxus 2.0?

The SAIC Maxus 2.0T engine requires 5L of engine oil, and the recommended oil type is 5W-30. The differences between types of engine oil are as follows: Semi-synthetic oil: Semi-synthetic oil is one type of automotive engine oil. It is formulated using semi-synthetic base oil, specifically international Group III base oil. It is a product refined from mineral oil through hydrocracking technology, consisting of a 4:6 ratio of mineral oil to full synthetic oil. Semi-synthetic oil's purity is very close to that of full synthetic oil, but its cost is slightly higher than mineral oil, making it an ideal transitional product from mineral oil to synthetic oil. Full synthetic oil: Full synthetic oil can operate over a wider temperature range and has a longer service life. For the same oil film requirements, full synthetic oil can achieve the desired performance with lower viscosity, whereas semi-synthetic oil requires a relatively higher viscosity to meet the same requirements. Conventional mineral oil: Engine oil consists of two parts: base oil and additives. The base oil is the main component of lubricating oil, determining its basic properties, while additives compensate for and improve the shortcomings of the base oil, imparting certain new properties. Additives are an important component of lubricating oil.
19
0
Share

Can I Replace Just Two Tires on a Small Car?

You can replace just two tires on a small car. Follow the tire replacement principles when doing so. Tire Replacement Principles: Tires of different specifications have varying outer diameters and section widths when inflated, leading to uneven load distribution if mounted on the same axle. Same Tire Structure: Radial tires and bias tires have different carcass structures, resulting in varying cushioning performance and circumferential deformation. Mixing these two types on the same axle will cause uneven load distribution and inconsistent wear. Same Tire Material: Material mainly refers to the carcass ply composition. For example, all-steel radial tires and fiber radial tires differ significantly in carcass thickness, ply strength, and heat dissipation performance, affecting performance if mixed. Same Tire Ply Rating: Ply rating indicates the tire's load capacity and corresponding inflation pressure standard. Mixing tires with different load capacities leads to inconsistent inflation pressure and varying tire deformation.
5
5
Share

Is the Wuji Motorcycle Domestic or Joint Venture?

Wuji motorcycles are produced by Loncin General Power Machinery Co., Ltd., which is a domestic brand. Introduction to Joint Venture Vehicles: As the name suggests, joint venture vehicles are projects jointly established by Chinese and foreign investors. The Chinese side contributes by providing land and factory usage rights, as well as capital, while the foreign investors contribute brands, technology, capital, talent, etc. Joint venture vehicles are the products of such collaborations. Foreign partners provide technology, talent, and brands for assembly within China, but the core technologies remain under foreign control. Reasons Why Joint Venture Vehicles Are Expensive: Joint venture vehicles are expensive due to intellectual property issues. The level of cooperation and interdependence between Chinese and foreign automobile manufacturers is generally low. Chinese manufacturers primarily learn assembly techniques, corporate culture, internal management, etc., from foreign manufacturers. However, the core technologies related to automobile engines and transmissions, which are crucial, are often imported from abroad. The technologies sold to China are typically 10 to 20 years behind.
7
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.