What are the steps to start the Volkswagen T-Cross automatic transmission?

[MacHarmony]

The following are the relevant steps for starting the Volkswagen T-Cross automatic transmission: Enter the driver's seat and press the brake: First, enter the main driver's compartment inside the car, then press the brake with your foot. Note that the brake is the one on the left, not the right, so don't press the wrong one. Press the brake and press the start button: After pressing the brake, start the car by pressing the start button. Since this model features keyless start, you only need to have the key nearby to press the button and start the car. Release the brake: After the car starts, you can then release the brake with your foot, because the gear hasn't been engaged nor the handbrake released, so the car won't move. If you want the car to move, press the brake again, then shift the gear to D, which is the forward gear and the conventional forward gear for automatic transmissions. Shift to D and release the handbrake: After shifting to D, then release the handbrake. Since this is an electronic handbrake, you only need to press it down slightly to release the handbrake. Release the handbrake and press the accelerator: After releasing the handbrake, slowly release the brake, and the car will start to move slowly. Then press the accelerator to increase the car's speed.

[Jill]

As a seasoned driver who frequently operates this vehicle, I'd like to share my starting routine. Before ignition, I always ensure the surroundings are safe, adjust the seat to a comfortable position, and fasten the seatbelt. With my right foot firmly on the brake pedal, I press the one-touch start button to fire up the engine. After confirming all dashboard indicators are normal, I shift to D gear. Gradually releasing the brake allows the vehicle to begin creeping forward, then I gently tap the accelerator – avoiding sudden presses as the 1.5L engine delivers relatively gentle initial power. Remember to use turn signals when making turns, and the doors will automatically lock once speed exceeds 20km/h. During cold starts, it's best to warm up the engine for 30 seconds until the coolant temperature reaches 50°C on the dashboard before moving off.

[StSkylar]

Just picked up the Tharu automatic last week, sharing some newbie driving tips. First, adjust the rearview mirror angle and check if the handbrake is fully released. When starting the engine, you must press the brake pedal firmly, otherwise the start button won't engage. To shift into Drive (D), press the shift lever button and pull it all the way back - the electronic parking brake will release automatically. If you're not yet familiar with throttle control, I recommend using ECO mode; listen to the engine sound changes during acceleration to gauge pedal pressure. The reversing camera is especially helpful for beginners - pay close attention to the guidance lines on the screen when exiting parking spaces.

[Adelyn]

After driving the T-Cross for three years to pick up and drop off kids, here's the most fuel-efficient starting method summarized: In the early morning, wait 30 seconds after starting to lubricate the engine, then gently press the accelerator to keep RPM below 1500. When smoothly accelerating to 40km/h, release the accelerator for 1 second before pressing again, allowing the transmission to automatically shift up. Pay attention to three lights: a green Auto Hold light indicates the automatic parking is on; a yellow start-stop light means it should be turned off; the red handbrake light must be off before starting. During long red lights at the school gate, shifting to N gear and pulling the handbrake is best for car care.