What are the steps to reset the maintenance light on the Besturn B50?
2 Answers
The steps to reset the maintenance light on the Besturn B50 are as follows: 1. Turn on the ignition switch to power the vehicle. 2. Press the "MODE" button on the left side of the steering wheel. 3. Press and hold the "CANC" button on the right side of the steering wheel until you hear a beep, then release it. 4. Observe the dashboard; the disappearance of the maintenance light indicates the reset is complete. Here is some relevant information about the Besturn B50: 1. The Besturn B50 is a compact car launched by FAW Besturn, with dimensions of 4695mm in length, 1795mm in width, and 1460mm in height, and a wheelbase of 2725mm. 2. The car is equipped with a 1.6L naturally aspirated engine and a 1.4T turbocharged engine, with maximum power outputs of 80kw and 100kw respectively, paired with a 5-speed manual or 6-speed automatic transmission.
I found that resetting the maintenance light on the Besturn B50 is actually quite simple. After each oil change, you need to manually reset it, otherwise the light will keep reminding you. First, sit in the driver's seat, turn the key to the ON position (don't start the engine), just make sure the dashboard lights up. Then locate the TRIP button near the steering wheel, press and hold it firmly for about 10 seconds. You'll see the maintenance light start flashing and then turn off, indicating it's been reset. The whole process takes just a minute, but be careful not to press the wrong button in a hurry, as it might mess up the settings. I always remind my friends to check the light status when doing regular maintenance—it makes driving more reassuring, after all, safety comes first.
