What are the penalties for motor vehicles violating no-parking signs?

1 Answers
VincentFitz
07/30/25 10:00am
Penalties include a warning, a fine ranging from 20 to 200 yuan, and 3 points deducted from the driver's license. Violating no-parking sign instructions refers to driving a motor vehicle on roads where passage is prohibited. Below are specific details about no-parking signs: 1. Yellow solid line paint: Yellow solid line paint on the edge of the road indicates that parking is prohibited. 2. Black and yellow dashed lines: Black and white dashed lines indicate that temporary parking is allowed. Note that long-term parking is still not permitted, and if discovered by traffic police, it may also result in penalties. 3. Yellow cross-grid markings: These markings are also very common and usually appear at larger intersections with heavy traffic. This is also a ground marking where parking is prohibited. 4. White diversion lines: White diversion lines are typically seen on large multi-lane roads. Parking is also prohibited within diversion lines.
Was this review help?
7
5
Share
More Forum Discussions

Where is the cabin air filter located in the Volkswagen CC?

Volkswagen CC's cabin air filter is installed above the footwell on the passenger side. Below are the steps to replace the cabin air filter for the Volkswagen CC: 1. Open the engine hood of the FAW-Volkswagen CC. 2. Use a T25 screwdriver to remove the screw indicated by the arrow, then take off the cabin air filter cover. 3. Loosen the screws, and the waterproof panel can be directly removed outward to reveal the cabin air filter inside. 4. The cabin air filter is secured by two clips at the positions shown by the arrows and three clips on the inner side. Press both clips simultaneously with your hands, release them, and then lift the cabin air filter housing. 5. Remove the cabin air filter upwards. 6. Detach the old filter from the filter frame. 7. Install the new cabin air filter onto the filter frame. 8. After securing the cabin air filter to the filter frame, it can be installed back into the vehicle.
7
4
Share

What colors are available for the Baojun RS3?

According to the official introduction from SAIC-GM-Wuling Automobile, the new Baojun RS3 offers a total of 5 colors: Starry Blue, Starlight White, Flame Red, Silver Star, and Black Star. Information regarding car colors is as follows: 1. There are primarily two methods to modify a car's color: one is a full-body repaint, and the other is a full-body wrap. 2. A full-body repaint is the most traditional method for changing a car's color. The advantage of a full-body repaint is that the painted surface has a better finish and a more substantial texture, but it can lead to depreciation when selling the car as a used vehicle. 3. A full-body wrap is the most popular method for changing a car's color. Its advantages include the ability to change colors at any time without damaging the original paint, but the quality of wraps can vary significantly. 4. It is important to note that if you change the car's color, you must register the modification with the vehicle management office. Otherwise, the vehicle will not be legally allowed on the road and will not pass the annual inspection.
17
3
Share

How to Fold Down the Rear Seats of the T-Roc?

The method to fold down the rear seats of the T-Roc is as follows: Pull the strap on the back of the rear seat and lift the seat cushion. Here is some related information: The T-Roc is a compact SUV with body dimensions of 4318mm in length, 1819mm in width, and 1582mm in height, with a wheelbase of 2680mm and a fuel tank capacity of 51 liters. The T-Roc is equipped with a 1.4T turbocharged engine, delivering a maximum power of 110kW at 5000-6000rpm and a maximum torque of 250Nm at 1750-3000rpm, paired with a 7-speed dual-clutch transmission.
2
4
Share

What does it mean when a Volkswagen detects pressure loss?

Volkswagen pressure loss indicates an issue with the tire pressure, causing the pressure sensor to detect an abnormality. The impact of tire pressure on vehicle driving is as follows: Affects driving comfort: If the tire pressure is too high, the contact area between the tire tread and the ground decreases, which affects braking performance and causes abnormal bumps during driving, reducing comfort. Additionally, tire tread wear will be abnormally concentrated in the center. Increased fuel consumption: If the tire pressure is too low, the contact area between the tire tread and the ground increases, leading to greater rolling resistance and higher fuel consumption. Moreover, tire tread wear will be abnormally concentrated on both sides, and in severe cases, it can cause standing wave phenomena in the tire, directly increasing the risk of a blowout.
2
0
Share

What Type of Fuel Does a Rolls-Royce Use?

Rolls-Royce uses 97 octane gasoline. Below are the relevant details about the Rolls-Royce Cullinan: Power: The Cullinan is a large SUV equipped with a 6.7L V12 engine featuring twin-turbocharging, delivering a maximum horsepower of 600ps and a peak torque of 900nm. Dimensions: The vehicle measures 5341mm in length, 2000mm in width, and 1837mm in height, with a wheelbase of 3295mm. It is a 5-door, 5-seat SUV with an 8-speed automatic transmission. Drivetrain: The Cullinan employs a front-engine, all-wheel-drive (AWD) system with a full-time AWD setup and a multi-plate clutch central differential.
15
3
Share

How to Open the Hood of a Golf?

Volkswagen Golf's hood release handle is located in the driver's side footwell. Pull the handle to open the hood. If the hood is deformed due to external force and cannot be opened by yourself, it needs to be sent to a repair shop for maintenance. Below are the methods to open a car hood: 1. Pull-handle type switch is located at the lower left corner of the driver's seat. Lift the handle along the arrow to release the hood, then remove the engine compartment support rod from its bracket, and finally hook the support rod into the groove of the engine compartment. 2. Button-type switch is located on the left panel of the center console. Follow these steps to open the hood: 1. Pull the hood release handle, and the hood will slightly pop up. 2. Reach into the central front part of the hood, locate the auxiliary latch handle, lift and hold the latch upwards while raising the hood. 3. After opening the hood, take out the support rod and place one end into the support slot to hold the hood open.
9
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.