What are the maintenance items for the Haval H2 at 50,000 kilometers?

1 Answers
Figueiredo
07/30/25 2:41am
Replace engine oil, oil filter, air filter, cabin air filter, fuel filter, transmission fluid or brake fluid and power steering fluid, and perform a full vehicle inspection including the chassis, lights, and brakes. Great Wall Haval H2 maintenance cycle: Maintenance is divided into intervals of 3,000 kilometers, 6,000 kilometers, 11,000 kilometers, and then every 6,000 kilometers after 16,000 kilometers, meaning the maintenance cycle is every 6,000 kilometers. The first four maintenance services for the H2 are generally free. When purchasing the car, 4S dealerships usually offer customers the benefit of free first four services to attract buyers. Great Wall Haval H2 pros and cons: The advantages of the Haval H2 are its stylish exterior, refined interior, and high cost-performance ratio. The disadvantages include issues with the brakes, which can sometimes feel soft and fail to engage gears properly, and some owners have reported body vibration issues.
Was this review help?
3
3
Share
More Forum Discussions

What level of SUV does the Dongfeng Fengdu MX6 belong to?

Dongfeng Fengdu MX6 is a compact SUV with the following dimensions: length 4625mm, width 1790mm, height 1735mm, wheelbase 2630mm, front track 1540mm, rear track 1545mm, fuel tank capacity 65L, luggage capacity 603L, and curb weight 1445kg. The Dongfeng Fengdu MX6 is equipped with a 2.0L naturally aspirated engine, delivering a maximum horsepower of 144PS, maximum power of 106kW, maximum torque of 198Nm, and is paired with a 6-speed manual transmission.
13
4
Share

What does high-frequency violation section mean?

High-frequency violation sections refer to road segments where traffic violations occur frequently. Below is an introduction to common high-frequency violations and their corresponding penalty points: 1. Crossing solid lines: This is a common issue for novice drivers, primarily due to inadequate driving skills and limited experience. Paying attention while driving and gaining more experience can effectively prevent this problem. 2. Forgetting to fasten seat belts: Seat belts are the simplest yet most effective protective devices in vehicles for occupants. However, both new and experienced drivers with low safety awareness often forget to buckle up. 3. Illegal parking: This is a major concern for most car owners in urban areas when going out, as finding parking spaces can be challenging.
13
0
Share

How to Identify China IV and China V Vehicles?

The methods to identify China IV and China V vehicles are: 1. For vehicles that have already received the environmental protection inspection qualification mark, the emission standard can be viewed on the original or duplicate of the environmental protection inspection qualification mark; 2. You can log in to the Motor Vehicle Environmental Protection Website and enter the vehicle model and engine model in the New Vehicle Compliance Query System to check the emission standard. China IV and China V refer to different stages of emission standards stipulated by the national regulations. The higher the number of the emission standard, the higher the level, and the higher the level, the lower the engine emissions will be. Emission standards refer to the regulations on the content of harmful gases such as carbon monoxide, hydrocarbons, nitrogen oxides, particulate matter, and carbon smoke emitted from vehicle exhaust.
18
1
Share

What is the voltage of the ABS sensor connector?

ABS sensor connector input voltage is 5 to 8V, output voltage is 650 to 850mV. The measurement method is to observe the voltage value displayed on the multimeter at the moment the ignition switch is turned on. As long as the voltage value changes, it indicates that the circuit connection is normal. Symptoms of a faulty ABS sensor include: 1. Inability to prevent wheel lock-up during emergency braking, posing a safety hazard; 2. The ABS warning light will illuminate, and the brake pads may not reset. The ABS system has a self-diagnostic function that monitors the system's operation. Once a fault that affects the normal operation of the system is detected, the ABS will automatically shut down, the ABS warning light will turn on, and a warning signal will be sent to the driver.
16
4
Share

In which year was the eighth-generation Accord produced?

The eighth-generation Accord was produced in 2008. The dimensions of the eighth-generation Accord are 4930mm in length, 1845mm in width, and 1470mm in height, with a wheelbase of 2775mm. In terms of exterior design, the eighth-generation Accord follows a robust and powerful design philosophy, embodying a grand, advanced, and prestigious design direction. The front fascia features a more heroic design, with angular headlights, a distinctive grille, and flared fenders, showcasing a dynamic and sleek character. For the interior, this model is equipped with an 8-inch embedded color LCD screen that includes GPS navigation, a trip computer, automatic xenon headlights, 8-way power-adjustable heated seats, and a dual-zone automatic climate control system with independent controls.
8
0
Share

Why Does a Car Make Noise When Braking?

Car brakes may produce noise due to uneven wear during normal use or the presence of foreign objects between the brake disc and brake pads. In such cases, it is necessary to promptly inspect the vehicle to ensure driving safety. The materials used for brake pads include: 1. Asbestos, cellulose, sintered glass; 2. Carbon fiber friction materials; 3. Powder metallurgy friction materials; 4. Semi-metallic friction materials. The function of brakes is to reduce speed or bring the vehicle to a stop. Their working principle involves converting the kinetic energy of the moving vehicle into heat energy through friction between the brake pads and brake drum, as well as between the tires and the ground, thereby slowing down or stopping the vehicle.
10
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.