Here are the precautions to take during the Subject 2 driving test: 1. First, make sure to complete all preparations before the test. 2. Before getting into the car to start the test, report to the examiner. 3. Throughout the entire process, you must not stop (except at designated points), roll back, shift gears incorrectly, stall the engine, or cross the lines. Below are specific precautions for each item in the Subject 2 test: 1. Reverse parking precautions: (1) When driving to the starting position, ensure the distance between the car body and the line is correct; the car body should cover the white line at the front right of the parking space but not exceed it. (2) While reversing, accurately align with the reference points, turn the steering wheel fully, and use the rearview mirror to align with the parking space points. (3) Once the car is in the parking space, ensure it is straight and the steering wheel is centered; avoid unnecessary left or right turns. (4) Do not reverse too far into the space; stop immediately upon entering. (5) When exiting to the left, pay attention to the distance between the left side of the car and the parking space line, adjusting the steering wheel as needed. (6) Ensure the car exits completely to the designated position when leaving to the left. (7) Throughout the entire process, you must not stop, roll back, shift gears incorrectly, stall the engine, or cross the lines. 2. Parallel parking precautions: (1) When driving to the test position, ensure the car body does not exceed the white line. (2) Adjust the distance between the car body and the edge of the parking space appropriately; do not get too close to the space, ensuring the rear wheels at least cross the edge line of the parking space. (3) When turning the steering wheel, accurately align with the reference lines. (4) After entering the parking space, turn on the left turn signal and honk the horn; when exiting, ensure the car does not touch the corner of the parking space. (5) Throughout the entire process, you must not stop, roll back, shift gears incorrectly, stall the engine, or cross the lines. 3. Right-angle turn precautions: (1) While driving forward, adjust the distance between the car body and the right edge line. (2) When reaching the corner, turn the steering wheel fully according to the speed. (3) After turning fully, you may lean out slightly to check if the left rear wheel can touch the corner; if it can, slightly adjust the steering wheel back. (4) Throughout the entire process, you must not stop, roll back, shift gears incorrectly, stall the engine, or cross the lines. 4. Hill start and stop precautions: (1) When driving uphill, turn on the right turn signal and maintain a slow speed; generally, the right wheel should be about 30 cm from the edge line. Control this distance carefully. (2) When reaching the designated position, slow down further to accurately align with the reference point. (3) Before starting, turn on the left turn signal and honk the horn, find the half-clutch point, and generally avoid pressing the accelerator. (4) Throughout the entire process, you must not stop (except at designated points), roll back, shift gears incorrectly, stall the engine, or cross the lines. 5. Curve driving precautions: (1) After entering the curve, make wide turns. (2) Maintain a slow and steady speed, accurately align with each curve point, and turn and straighten the steering wheel quickly. (3) Throughout the entire process, you must not stop, roll back, shift gears incorrectly, stall the engine, or cross the lines.
