···
Log in / Register

What are the hidden functions of the Murano car key?

3 Answers
DeJosiah
07/29/25 11:29pm
The Nissan Murano key has three buttons: lock, trunk open, and unlock. The hidden functions are: to lower all four windows, press and hold the unlock button; to raise all four windows, press and hold the lock button. Precautions are as follows: 1. Replacement: Improper battery replacement may damage the car key. 2. Model: Check the battery model before replacement. When purchasing a new battery, pay attention to its voltage, size, and specifications. 3. Installation: Always install the battery correctly. Damage to the key due to self-replacement of the battery is not covered under the warranty. 4. Range: To avoid key failure, minimize use outside the effective range. 5. Magnetic field: Within a range of 1 meter from a magnetic field, the battery may become magnetized and fail.
Was this review help?
7
1
Share
VanJameson
08/16/25 2:17am
As a parent with kids, driving the Murano to pick up and drop off children, I discovered some life-saving hidden features of the car key. Holding down the lock button can close all windows at once, especially useful when you forget to close them after parking—no need to run back to operate them. Another feature is holding down the unlock button to lower the windows, which is super practical for cooling down the car on hot days before getting in. The car locator function makes the lights flash and the horn sound with a single press, making it much easier to find your car in large supermarket parking lots. The trunk release button opens the hatch with a simple press, making it super convenient for loading strollers or shopping bags without needing to free up hands to find the keyhole. If the battery dies, there’s a small slot on the back of the key to pull out a mechanical key for emergency access—simple and reassuring. Though these features may seem small, they’re used daily. For maintenance, it’s recommended to replace the CR2032 battery every two years to keep the key responsive. Total: about 170 words.
Was this review help?
16
4
Share
Expand All
SanArcher
10/19/25 2:22am
I'm particularly fond of researching automotive electronics. The hidden functions of the Murano key are based on RFID technology, which is quite fascinating. For example, holding down the start button can remotely start the engine, saving time for preheating the car in winter. Long-pressing the lock button not only locks the doors but also closes all the windows to prevent water ingress. Holding the unlock button can automatically open the windows for ventilation, making it more comfortable before getting in the car during summer. The car-finder function triggers the lights and horn via the button, making it easy to locate the parking spot. Personalized settings linked to the key on the dashboard memorize seat positions and temperature preferences, offering strong practicality. The key battery lasts about 2 years, and a DIY replacement with a cheap CR2032 is possible—just ensure correct polarity alignment to avoid damaging the circuit. Code programming allows adding new keys but requires professional tools to avoid errors during tinkering.
Was this review help?
1
5
Share
Expand All
More Forum Discussions

How to Remove the Accelerator Pedal of Emgrand GL?

Disconnect the throttle cable (accelerator cable) of the Emgrand GL. Remove the intake manifold from the Emgrand GL throttle body. Disconnect the throttle position sensor harness and the idle motor harness. Remove the crankcase forced ventilation hose and the throttle body preheating inlet and outlet hoses of the Emgrand GL. Remove the 4 mounting bolts and the mounting bracket bolts.
14
4
Share

Is the purchase invoice required for the first maintenance?

The purchase invoice is required for the first maintenance. In addition, you will also need to bring: driver's license; maintenance manual; warranty manual; owner's ID card; vehicle registration certificate; and the vehicle's registration book to the designated first maintenance facility for the service. Important note: Make an appointment with the 4S store in advance. The first maintenance refers to the initial service after the new car has been driven. The specific time varies by vehicle, usually after driving 5,000 kilometers or 6 months. The car must undergo the first maintenance on time—neither early nor delayed. The completion of the first maintenance marks the end of the car's break-in period, allowing it to be driven under standard load and normal speed as required. The first maintenance period is calculated from the date of vehicle pickup. There are two indicator values for the first maintenance: mileage and time. Whichever indicator is met first will be the standard. First maintenance items include: Check tire condition/wear and adjust pressure if necessary; Inspect lighting system operation (headlights, indicator lights, emergency signal lights, trunk light, cabin light, glove box light, dashboard warning lights, etc.); Check windshield wiper and washer operation/wiper blade position/wear; visually inspect the exterior of the vehicle, underbody protective components, pipes/hoses (exhaust, fuel lines, brake lines), and rubber parts (dust covers, bushings, spacers, etc.); Visually inspect the condition of various control belts; Check/adjust clutch pedal height and travel; Check/adjust handbrake travel; Check and tighten chassis bolts; Clean the air filter element. Time required: Completing all tasks takes approximately 2 hours. The most important aspect of the first maintenance for a new car is changing the engine oil and oil filter. When replacing the engine oil, the oil filter must also be replaced. The choice of engine oil must refer to the "Vehicle Use and Maintenance Manual," as different models require different oil specifications. Maintenance precautions: Do not rinse the interior of the car with water: Many people clean their cars themselves during holidays, rinsing the body with water and wiping it with a cloth. It is important to note that the interior of the car should not be directly rinsed with water. If the floor mats are dirty, use a vacuum cleaner or take them out, scrub them with a brush and detergent, dry them, and then put them back. The rubber mats on the cabin floor have many drainage holes beneath them. If water enters, it will not dry naturally but will flow through the holes to components like the transmission, causing corrosion. The best practice is to vacuum clean first and then wipe with a cloth to prevent water accumulation. Do not mix different brands of antifreeze: When the antifreeze in the car is low, it is recommended to drain the existing antifreeze and refill it with the same brand from the beginning. Different brands of antifreeze have different chemical properties and use different corrosion inhibitors. Do not mix them to avoid unnecessary issues. Do not lubricate wheel bolts and nuts: When bolts on a moving car rust, they are often oiled to function properly again. To prevent rust on wheel bolts and nuts, some people apply lubricant, but this poses a safety risk. At high speeds, bolts and nuts may loosen or even fall off, leading to driving malfunctions.
16
1
Share

How early can motorcycle insurance be renewed?

Motorcycle insurance can generally be renewed three months before the expiration date. Since auto insurance is renewed annually, the end of the year is the peak period for renewals. Completing the renewal three months in advance not only avoids the peak period but also allows you to enjoy corresponding discounts. If an accident occurs after the insurance expires, the insurance company will refuse to compensate, and the repair costs and the owner's losses will have to be borne by the owner themselves. Therefore, vehicle owners must pay attention to the validity period of their insurance to be prepared for any eventuality. Below is some relevant information: Compulsory Traffic Insurance (CTPL): The first must-mention is the compulsory traffic insurance, which must be purchased annually and is bundled with the vehicle and vessel usage tax. There are two types of costs: one for small-displacement vehicles, i.e., those with a displacement below 250cc. Third-Party Liability Insurance: This covers compensation for damages caused during daily riding, such as hitting a luxury car or injuring someone, where the third-party liability insurance can provide compensation.
1
3
Share

What does VSA mean in a car?

VSA stands for Vehicle Stability Assist, an advanced control system designed to enhance vehicle stability and driving safety. VSA system: In addition to traditional Anti-lock Braking System (ABS) and Traction Control System (TCS) functions, the VSA system also incorporates a skid control function. Function of VSA system: The VSA system helps drivers maintain better control of the vehicle, keeping it within normal driving parameters as much as possible, thereby providing a more secure driving experience. Particularly in emergency situations such as sudden steering or driving on slippery roads, it can maximize vehicle safety.
16
1
Share

How to License a Car?

Obtain the vehicle conformity certificate and keep the triplicate purchase invoice, as they will be needed for the subsequent licensing process. Acquire the main and supplementary tax certificates. After purchasing the vehicle, go to the nearest vehicle management office to pay the vehicle purchase tax, and prepare the required documents in advance. A specialized traffic police officer will inspect the vehicle, primarily checking the vehicle identification code, exterior appearance, and warning triangle plate, among other things. Prepare these items beforehand. After selecting the license plate number, pay the fees and wait to receive the plate. It usually takes three to five working days to get the license plate.
6
0
Share

How to reset the maintenance light on Jetta VS7?

Press and hold the button on the right side of the dashboard with your left hand, do not release it. Then turn the key with your right hand to illuminate the dashboard, but do not start the engine. Press and hold the button on the right side of the dashboard with your left hand, do not release it. Then turn the key with your right hand to illuminate the dashboard, but do not start the engine. Release your left hand and press the button on the left side of the dashboard. The wrench symbol will disappear, indicating the maintenance light has been successfully reset.
7
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.