What are the differences between the Toyota C-HR and Toyota Izoa?

What is the difference between Volvo T4 and T5 engines?

Differences between Volvo T4 and T5 engines: 1. Different maximum power: The maximum power of Volvo T4 engine is 140kw; T5's maximum power is 187kw. 2. Different maximum torque: The maximum torque of Volvo T4 engine is 300nm; T5's maximum torque is 350nm. Both Volvo T4 and T5 engines are 2.0-liter turbocharged four-cylinder engines. Volvo is an automobile brand founded in Gothenburg, Sweden, originally owned by Ford Motor Company of the United States, and later acquired by China's Geely Automobile with all its equity and related assets (including intellectual property rights), making it a subsidiary brand.

110

Share

What to Do When a Vehicle Loses Control?

Solutions for a vehicle losing control: Immediately lift the accelerator pedal, shift the gear lever into a lower gear, and evenly pull the parking brake with steady force. When the speed noticeably decreases, step on the brake pedal to bring the vehicle to a gradual stop. Remember, do not use emergency braking first to avoid causing a rollover. For vehicles equipped with power steering, if you suddenly find steering very difficult and operation strenuous, remain calm and drive cautiously. If the front of the car skids, usually caused by entering a turn too quickly with insufficient steering, absolutely do not step on the brake. First, slowly release the throttle while turning the steering wheel in the direction the front of the car is skidding (not too much), allowing the front wheels to regain traction, then immediately turn the steering wheel back while gently applying the throttle.

101

Share

How to set the Toyota C-HR to make a sound when locking the car?

Here are the specific steps to set the car to make a sound when locking: 1. First, sit in the driver's seat, press the brake pedal, and keep the gear shift lever in the P position, then release the brake pedal. 2. Then press the one-touch start button twice. Note: There should be a certain interval between these two consecutive presses; if the interval is too short, the car system may not respond. 3. After closing all four doors, press and hold the lock button on the driver's side door for more than 10 seconds. At this point, the setting for the locking beep is completed. Below is the tutorial for replacing the key battery of the Toyota C-HR: 1. Remove the mechanical key. 2. Take off the key cover. Be careful during the removal process to avoid damaging the key. 3. Using a small flat-head screwdriver can make it easier to remove the old battery. 4. Insert the new battery with the positive side facing up. 5. After installing the battery, reassemble the key. 6. Test whether functions like the lock button work properly.

115

Share

How to Turn on the Fog Lights of an Audi?

Audi's headlights and fog lights are turned on in the same way across all models. Taking the domestic Audi A4L as an example, the switch is located below the air vent on the driver's side. The middle knob controls the width lights and low beams, while the two buttons on the left, arranged vertically, are for the front and rear fog lights—simply press them to activate. The right side features controls for the interior lights and instrument panel brightness adjustment. The purpose of fog lights is to make the vehicle visible to others in conditions of reduced visibility, such as fog or heavy rain. Therefore, fog light sources need strong penetration. Most vehicles use halogen fog lights, while more advanced models may feature LED fog lights. Fog lights must be installed below the bumper, as close to the ground as possible, to ensure their effectiveness. If positioned too high, the light cannot penetrate the fog or rain to illuminate the road (since fog is usually thinner below 1 meter), which could lead to hazardous situations. Typically, fog light switches have three positions: the 0 position is off, the first position controls the front fog lights, and the second position controls the rear fog lights. When set to the first position, only the front fog lights are on; at the second position, both front and rear fog lights operate. Therefore, when turning on the fog lights, it's advisable to know which position the switch is in, ensuring convenience for yourself and safety for others on the road.

117

Share

What is the use of the CFMOTO 250SR Bluetooth mode?

CFMOTO 250SR Bluetooth can facilitate making calls and listening to music. Bluetooth is a special short-range wireless technology connection based on low-cost, short-distance wireless connectivity, establishing a communication environment for fixed and mobile devices. From its appearance, the CFMOTO 250SR features a highly original body design with an overall stretched posture and well-proportioned body parts. The model is primarily sport-oriented, with handlebars positioned significantly lower than the fuel tank and rear, giving it an aggressive riding stance. This allows for a lower center of gravity during corners or on the track, making it easier to shift body weight more quickly when entering or exiting turns.

103

Share

What is the valve clearance for Perkins 4012?

Perkins 4012 intake valve clearance is 0.25 to 0.3 mm, exhaust valve clearance is 0.3 to 0.35 mm. Valve clearance: Valve clearance refers to the gap between the end of the valve stem and the valve transmission components when the valve is fully closed. General valve clearance: Generally, when cold, the intake valve clearance is 0.20 mm to 0.30 mm, and the exhaust valve clearance is 0.25 mm to 0.35 mm. The valve clearance for different engine models is determined by the engine manufacturer through testing. For specific details, please refer to the maintenance manual.

120

Share