What are the consequences of not repairing engine knocking?

2 Answers
Jeffrey
07/24/25 5:16am
The consequences of not repairing engine knocking: 1. It will shorten the service life of the engine; 2. It will aggravate the wear of components; 3. It will increase engine noise, and may even damage the connecting rod and crankshaft; 4. The engine knocking will cause unstable operation; 5. The engine will vibrate severely, and may cause overheating and black smoke. Solutions for engine knocking: 1. If knocking occurs in a low-temperature environment after the car is started and disappears when the temperature rises, this type of knocking can be temporarily ignored, and the car can continue to be driven; 2. If the knocking sound does not disappear but becomes more obvious when the engine temperature is normal, the owner should avoid high-speed driving, stop and check in time to prevent traffic accidents; 3. If the cylinder is found to be severely out of round, scratched, or the gap between the piston and the cylinder is too large after removing the cylinder head and pulling out the piston, replacement is necessary, including the cylinder sleeve, piston, and piston rings; 4. If the connecting rod is found to be deformed, it should be replaced as much as possible.
Was this review help?
13
2
Share
ParkerMarie
08/11/25 12:55am
Anyone who's driven for decades knows that engine knocking sounds like a ticking noise, and ignoring it can lead to major trouble. It gradually wears down piston rings and cylinder walls, causing severe gas leakage and steadily decreasing engine efficiency. You'll notice a significant increase in fuel consumption, lack of power, and even struggling to climb small hills. Worse yet, the piston may shatter, with debris falling into the engine, damaging the crankshaft and bearings. In the end, you might need a major overhaul or even a new engine, costing tens of thousands—several times more than timely repairs. Plus, it's a serious safety risk; breaking down in a busy area with fast-moving traffic could lead to accidents. My advice: get the fuel quality or ignition system checked at the first sign of unusual noise. Don’t cut corners—delaying repairs will cost you far more in the long run.
Was this review help?
17
1
Share
Expand All
More Forum Discussions

Does the GS8 have a five-seater version?

GS8 has a five-seater version, which belongs to the mid-to-large-size SUV category. Its body dimensions are 4810mm in length, 1910mm in width, and 1770mm in height, with a wheelbase of 2800mm. In terms of exterior design, the GS8 features matrix LED headlights, paired with a full-width Lingyun Wing family-style grille, and the '8'-shaped taillights offer high recognition. Under the hood, the GS8 is powered by a 2.0T engine, delivering a maximum power of 201 horsepower and a peak torque of 320 Nm, mated to an Aisin 6-speed automatic transmission. For the suspension system, the GS8 adopts a MacPherson strut front suspension and a multi-link independent rear suspension.
18
3
Share

What maintenance services are performed at a 4S dealership?

Maintenance services performed at a 4S dealership include: 1. Checking engine oil and oil filter; 2. Inspecting spark plugs; 3. Checking brake fluid and power steering fluid; 4. Inspecting transmission fluid; 5. Checking antifreeze/coolant; 6. Examining timing belt; 7. Cleaning fuel system; 8. Cleaning lubrication system; 9. Air conditioning disinfection; 10. Four-wheel alignment and dynamic balancing. The purpose of vehicle maintenance is to maintain a clean appearance, ensure normal technical conditions, eliminate potential hazards, prevent failures, slow down deterioration processes, and extend the service life. Modern vehicle maintenance mainly covers the engine system, transmission system, air conditioning system, cooling system, fuel system, power steering system, and other maintenance scopes.
13
0
Share

What kind of oil does Dongfeng Fengshen AX7 use?

Dongfeng Fengshen AX7 uses 5W30 fully synthetic engine oil. For older vehicles with higher mileage, 5W40 fully synthetic oil can also be selected. Engine oil serves to lubricate and reduce friction, assist in cooling, seal against leaks, prevent rust and corrosion, and provide shock absorption for the engine. The Dongfeng Fengshen AX7 is a compact SUV with body dimensions of 4645mm in length, 1880mm in width, and 1690mm in height, and a wheelbase of 2715mm. In terms of power, the Dongfeng Fengshen AX7 is equipped with a 1.6-liter turbocharged engine, delivering a maximum power of 170 horsepower and a peak torque of 250 Nm, with the engine reaching its maximum power output at 5500 rpm.
20
4
Share

How to Remove a Car Headlight Bulb?

Car headlight bulb removal method is: 1. Open the front hood, locate the corresponding internal position of the headlight, and loosen the waterproof rubber ring; 2. Remove the waterproof rubber ring; 3. Unplug the headlight power supply; 4. Loosen the headlight clip and remove the headlight from the lamp housing; 5. Place the new headlight into the lamp housing, secure it with the clip, and plug the headlight power supply back to its original position; 6. Find the removed waterproof rubber ring and screw it back to its original position. Car headlights, also known as car front lights and car LED daytime running lights, serve as the 'eyes' of the car. They not only relate to the external image of the car owner but are also closely linked to safe driving at night or under bad weather conditions.
12
3
Share

How to Drive a Honda XR-V Automatic Transmission Car?

To start a Honda XR-V automatic transmission car, follow these steps: 1. When starting the engine, ensure the gear selector is in the P (Park) or N (Neutral) position, and engage the handbrake or press the brake pedal. 2. For normal driving on flat roads, place the gear selector in the D (Drive) position, and the transmission will automatically shift gears based on throttle input and vehicle speed. The Honda XR-V is positioned as a compact SUV, with body dimensions of 4328mm in length, 1772mm in width, and 1610mm in height, and a wheelbase of 2610mm. In terms of exterior design, the Honda XR-V features a significant amount of chrome elements on the grille and fog light areas, with a thick silver bow-shaped trim running across the lower grille connecting the fog lights.
9
3
Share

Where is Wuling Motors Produced?

Wuling Motors is produced in Liuzhou, Guangxi and Qingdao, Shandong. Wuling Motors is a renowned brand in China's automotive industry and an international and modern micro and small vehicle manufacturing enterprise. Currently, Wuling Motors has also launched a global vehicle program. Taking the Wuling Hongguang S as an example, its body dimensions are 4390mm in length, 1660mm in width, and 1750mm in height, with a wheelbase of 2720mm. In terms of power, the Wuling Hongguang S is equipped with 1.2L and 1.4L engines, utilizing DOHC double overhead camshaft and four valves per cylinder design technology. The 1.4L engine of the Wuling Hongguang S can achieve a power of 75KW and a maximum torque of 131NM.
4
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.