What are the conditions for purchasing duty-free cars in Hainan?

What are the reasons for abnormal noises after replacing brake discs and pads?

The reasons for abnormal noises from newly replaced brake pads are as follows: 1. The most likely cause is an improper contact surface, where the old brake disc was not resurfaced when installing new brake pads, resulting in a poor fit. If the installation is improper or new pads are installed without resurfacing the old disc, the new pads will directly rub against the uneven surface of the old disc, ultimately causing uneven wear on the new brake pads. 2. Another possible reason is a defect in the brake system itself, causing the brake pads to only partially contact the brake disc. This increases the pressure per unit area during braking, leading to abnormal noises. It is recommended to inspect components such as the caliper and guide pins.

5

0

Share

Can a B1 Driver's License Be Upgraded to an A2?

Currently holding a B1 driver's license, you can directly upgrade to an A2, but you must have held the B1 license for more than three years or have held a large passenger vehicle driving qualification for more than one year. Additionally, you must not have accumulated 12 penalty points in any of the last three scoring cycles before applying. To upgrade from a B1 to an A2 driver's license, the following conditions must be met: 1. You must already hold a motor vehicle driver's license, and when applying to add a new vehicle class, you must not have accumulated 12 penalty points in the current scoring cycle or the most recent scoring cycle before applying. 2. You must have held a medium or large passenger vehicle driving qualification for more than three years or a large passenger vehicle driving qualification for more than one year, and you must not have accumulated 12 penalty points in any of the last three consecutive scoring cycles before applying.

7

1

Share

What Causes Water Leakage from a Car's Exhaust Pipe?

Exhaust pipes drip water because gasoline contains trace amounts of moisture, which cannot be burned. During combustion in the engine's combustion chamber, these trace amounts of moisture are separated from the gasoline. This moisture is then expelled with the exhaust gases. Inside the cylinder, the temperature is quite high, but as the moisture enters the exhaust pipe, it rapidly cools and condenses, forming water vapor that adheres to the inner walls of the exhaust pipe. As more water vapor accumulates, it eventually forms droplets that flow out of the exhaust pipe. Thus, water dripping from the exhaust pipe does not indicate a car malfunction. In fact, it can even suggest that the engine is of good quality, as the formation of water droplets indicates that the fuel is being burned efficiently.

18

3

Share

What are the tire specifications for the Focus?

The tire specifications for the Focus are as follows: 1.6L model - 205/60-R16; 2.0L model - 215/50-R17. Below is relevant information about tires: 1. The international standard tire code represents the section height and aspect ratio as a percentage in millimeters, followed by the tire type code, rim diameter (in inches), load index (permissible load capacity code), and permissible speed code. 2. Tires are one of the crucial components of a vehicle, directly contacting the road surface and working with the suspension system to absorb shocks during driving. They ensure good ride comfort and smooth operation, maintain excellent traction between wheels and road surfaces, improve vehicle traction, braking, and off-road capability, and bear the vehicle's weight.

19

2

Share

What to Do When the ABS Light Comes On?

Solutions for when the ABS light comes on: 1. Carefully inspect the wiring and connectors to check for poor contact or damage; 2. Examine the installation gap and position of the wheel speed sensor and tone ring, as well as any contamination by dust or debris; 3. Check if the wheel bearing clearance is too large and adjust it to the normal value; 4. Avoid high-speed driving and sudden braking, and take the vehicle to a 4S shop for inspection as soon as possible. Reasons for the ABS light coming on include: 1. No speed signal is transmitted to the ABS control unit when the vehicle speed exceeds 10 km/h; 2. The speed signal exceeds the tolerance value when the vehicle speed is greater than 40 km/h; 3. There is a recognizable open circuit or short circuit to the positive or ground in the sensor.

17

0

Share

How to Use the Cruise Control on the Hyundai Elantra?

To use the cruise control on the Hyundai Elantra, follow these steps: Press the CRUISE button on the steering wheel to activate the cruise control system, and the cruise control indicator will light up. Accelerate to your desired speed, which must be greater than 30 km/h. Below are some precautions when using the cruise control system on the Hyundai Elantra: 1. In principle, cruise control should be used on highways or fully enclosed roads. This is because, on non-enclosed roads, complex road conditions can compromise traffic safety. 2. It should be disabled on winding mountain roads or roads with too many curves. Under normal circumstances when navigating curves, it is necessary to appropriately apply throttle to provide greater steering force. In cruise control mode, the vehicle automatically maintains a constant speed, with the throttle controlled by the onboard computer, which can often pose a danger when driving on curves. Under such conditions, it is advisable to control the speed appropriately.

10

1

Share

What are the conditions for purchasing duty-free cars in Hainan?

What are the reasons for abnormal noises after replacing brake discs and pads?

Can a B1 Driver's License Be Upgraded to an A2?

What Causes Water Leakage from a Car's Exhaust Pipe?

What are the tire specifications for the Focus?

What to Do When the ABS Light Comes On?

How to Use the Cruise Control on the Hyundai Elantra?

What is the tire model size for Honda Accord

Is it allowed to make a right turn ahead without using the dedicated right-turn lane?

Why does the car intermittently shake when in N gear?

Where is the fuse box of the Santana?