Should the Inspire use 92 or 95 octane gasoline?

What Causes the Anti-Theft Indicator Light to Suddenly Start Flashing When It Didn't Before?

Below are the reasons why the anti-theft indicator light suddenly starts flashing when it didn't before, along with corresponding solutions. Details are as follows: Normal Alarm Trigger: If the engine anti-theft light flashes at a regular frequency, it indicates that the vehicle's engine has entered the anti-theft mode. The engine anti-theft system is functioning normally, and the flashing anti-theft indicator light signals that the vehicle's electronic anti-theft system has been triggered. Solution: Inspect the vehicle and take appropriate measures. Fuel Issues: First, check the front and rear oxygen sensors. Early signs of damage may include the engine warning light staying illuminated on the dashboard. Modern vehicles typically have two oxygen sensors, located before and after the catalytic converter. Solution: Promptly troubleshoot the issue or replace the faulty components.

14

0

Share

What day is Sinopec's discount day?

But the 5th, 15th, and 25th of every month are Sinopec's member discount days. Moreover, there are sometimes recharge promotions, so applying for a Sinopec fuel card can be considered a win-win approach to some extent. Secondly, the fuel card also has a very convenient function, which is supporting self-service refueling for car owners. It is not only quite easy to operate but also saves time by avoiding queues for refueling. Below is an introduction to gasoline compression ratios: 90-octane gasoline: for gasoline cars with an engine compression ratio below 8.5. 93-octane gasoline: for gasoline cars with an engine compression ratio between 8.6 and 9.9. 97-octane gasoline: for gasoline cars with an engine compression ratio between 10.0 and 11.5. 98-octane gasoline: for gasoline cars with an engine compression ratio above 11.6.

12

1

Share

What is Corrected Ignition Timing Advance Angle?

Corrected ignition timing advance angle refers to the spark plug firing before the piston reaches the compression top dead center, igniting the combustible mixture in the combustion chamber, from the moment of ignition until the piston reaches the compression top dead center. Air-fuel ratio voltage correction: Under closed-loop control, the engine uses the feedback signal from the oxygen sensor to correct the air-fuel ratio. Through the correction function of the oxygen sensor, the amount of fuel injection can be controlled. When the feedback correction reduces the fuel quantity, the ignition timing advance angle increases accordingly; when the feedback correction increases the fuel quantity, the ignition timing advance angle decreases accordingly. Correction during warm-up: The ignition timing advance angle is corrected based on the engine's coolant temperature. Different coolant temperatures have varying effects on the engine's ignition timing advance angle. When the coolant temperature is low, the ignition timing advance angle increases to speed up ignition and help the engine warm up faster. As the coolant temperature rises, the correction value of the ignition timing advance angle gradually decreases.

15

0

Share

Can an Old Land Cruiser Modified to Look New Pass Vehicle Inspection?

An old Land Cruiser modified to look new cannot pass vehicle inspection. Scope of vehicles exempt from inspection: Non-commercial large, small, and mini (under 7 seats) passenger cars registered within 6 years, as well as non-commercial small and mini passenger vehicles, enjoy a six-year exemption from inspection. Scope of vehicles not exempt from inspection: Vehicles that have not been registered for over 4 years since the date of manufacture, vehicles involved in fatal accidents during this period, and vehicles with outstanding traffic violations or unresolved traffic accidents are not eligible for the six-year exemption from inspection. Documents required for vehicle inspection exemption: Vehicles within the exemption scope are exempt from on-site inspection for 6 years, but must apply for the inspection exemption mark at the vehicle management office every two years by presenting the vehicle registration certificate, ID card, and a copy of the compulsory traffic insurance policy. This can also be done online.

13

5

Share

Does Speeding at the Starting Point of Section Speed Measurement Count as a Violation?

Speeding at the starting point of section speed measurement does not count as a violation. Below is a detailed introduction: Introduction to Section Speed Measurement: Section speed measurement involves setting up two adjacent monitoring points on the same road section. The principle is to calculate the average speed of a vehicle over that section by measuring the time it takes to pass between the two monitoring points, and then determining whether the vehicle has exceeded the speed limit based on the standard set for that section. Working Mechanism of Section Speed Measurement System: The section speed measurement system uses cameras installed at checkpoints to establish a monitoring and capture system. It monitors and captures vehicles passing through the checkpoint area in real-time to obtain information such as vehicle speed, traffic flow, license plate number, color, approximate physical dimensions, and driver characteristics. This information is then transmitted via a network to the public security traffic command center and traffic control sub-center databases for data storage, query, and comparison processing.

6

1

Share

Is Overtaking Allowed on Center Streets?

Overtaking is not allowed on center streets. Overtaking refers to the process where a following vehicle changes lanes to the rear side of the leading vehicle, passes it, and then returns to the original lane. The lane typically used for overtaking is the inner lane, which is closer to the center of the road and farther from the shoulder. Below are some driving precautions: Check the rearview mirror: When turning or changing lanes, you must use the turn signal, slow down, and always check the rearview mirror before turning. For left turns, primarily check the left rearview mirror; for right turns, primarily check the right rearview mirror; and for both left and right turns, check the interior rearview mirror. Do not fixate on the area directly in front of the car: When driving on a clear road, look straight ahead at a distance of 100 meters, avoiding staring at the immediate front of the car. Depress the clutch: Generally, when decelerating at speeds above 40 km/h, there is no need to depress the clutch first; wait until the speed drops to around 20 km/h before depressing the clutch. Steering: Turn the steering wheel slowly for high-speed turns and quickly for low-speed turns.

18

4

Share

Should the Inspire use 92 or 95 octane gasoline?

What Causes the Anti-Theft Indicator Light to Suddenly Start Flashing When It Didn't Before?

What day is Sinopec's discount day?

What is Corrected Ignition Timing Advance Angle?

Can an Old Land Cruiser Modified to Look New Pass Vehicle Inspection?

Does Speeding at the Starting Point of Section Speed Measurement Count as a Violation?

Is Overtaking Allowed on Center Streets?

Which company owns the Seres brand?

What does car headlight mean?

How many liters of engine oil should be added to a BMW 320?

What does PICC new car endorsement mean?