Should High Beams Retain Halogen Headlights?

2 Answers
Amy
07/24/25 3:57pm
Whether to retain halogen headlights for high beams depends on the vehicle owner. Below is an introduction to halogen bulbs: Introduction: Halogen bulbs (English: halogen-lamp), referred to as halogen bulbs or halogen lamps, are also known as tungsten halogen bulbs or quartz bulbs, and are a variant of incandescent lamps. Principle: The light-emitting principle of all incandescent lamps is based on the principle of thermal radiation and the glowing of heated objects. The simplest incandescent lamp works by passing sufficient current through the filament, heating it to incandescence, which then emits light. However, the lifespan of such incandescent lamps is extremely short.
Was this review help?
9
4
Share
VanAlexa
08/11/25 8:55am
Are halogen high beams worth keeping? I think it depends on personal needs. As an old-timer who's been driving for decades, I prefer halogen lights. They provide a warm yellow light with strong penetration, especially in rainy or foggy conditions, without the glare or scattering issues of modern LEDs. Halogen bulbs are cheap and easy to replace—you can do it yourself without relying too much on repair shops. Although they have a shorter lifespan and higher power consumption, keeping the original system in some older cars is more worry-free, avoiding circuit damage from compatibility issues. If you mainly drive in urban areas, halogen high beams are sufficient. Considering safety and low cost, retaining them is a wise choice—unless you frequently drive long distances at night, where upgrading to LEDs might be better. But then again, simplicity and durability last longer.
Was this review help?
7
5
Share
Expand All
More Forum Discussions

What to Do When a Coin Falls into the Car Air Vent?

When a foreign object falls into the air vent, you can ask a maintenance technician to help you remove it during a convenient time, such as during a routine service. You can disassemble the vent or use a magnetic rod to reach in and pull it out. The best method is to tie a small round magnet to a string and pull it out. For most cars, the entire dashboard must be disassembled to retrieve the coin. Visit a 4S shop and ask a repair technician to help disassemble the vent and remove the coin.
9
4
Share

How to Turn Off the Auto Start-Stop Function on the Ford Edge?

There is a button located slightly in front of the center armrest, to the right front of the gear shift lever. Look for a button with an 'A' and 'off' below it, then press that button. When the 'off' light turns on, the auto start-stop function will be disabled.
20
1
Share

How to Check the Battery Level of the Third-Generation Haval H6?

The battery status is indicated by green, yellow, and black colors. Green represents sufficient battery charge, yellow indicates slight discharge, and black means the battery is nearly dead and needs replacement. You can use a battery tester or a multimeter to measure the battery voltage to determine if the battery needs to be replaced.
1
0
Share

How to Check Driving Test Results?

Open your browser and enter the URL in the address bar to access the Comprehensive Traffic Safety Service Management Platform. Find the province where your student record was established, click on the province name to enter, then click on 'Individual Login' and fill in your ID number and password to log in. After logging in, click on 'Personal Homepage', and your test results will be displayed at the bottom. You can then proceed to check them.
6
5
Share

What is the method to remove the speed limit on Luyuan Midou?

When the power is off, generally press both the "Lock" and "Unlock" buttons on the remote control for a few seconds to remove the speed limit alarm. If that doesn't work, open the rear seat and cut the pink wire inside.
13
0
Share

How to Use the Third-Generation Haval Bluetooth Key?

Press the "Lock" button, and all door lock motors will simultaneously perform a locking action once, with the turn signal flashing once. Press the "Find Car" button to hear a long beep and see the turn signals flash for 15 seconds, then re-enter the find car state once again. Press the "Lock" button, regardless of whether the door locks are open, all door lock motors will simultaneously perform a locking action while also deactivating the alarm. Press the "Unlock" button, and all car doors will simultaneously perform an unlocking action once, with the turn signal flashing twice.
12
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.