Is There a Height Requirement for a C1 Driver's License?

1 Answers
VonEmma
07/25/25 9:42pm
C1 driver's license does not have a height requirement. Although there is no height restriction, to ensure the driver's safety while operating a vehicle, it is necessary for the driver to maintain a correct sitting posture. If the driver is relatively short, it may be more tiring to check reference points, and the reference objects may also change. According to the regulations on the application and use of motor vehicle driver's licenses: Applicants for large buses, tractors, city buses, large trucks, and trolleybuses must be at least 155 centimeters tall. Applicants for medium-sized buses must be at least 150 centimeters tall. For small cars, small automatic transmission cars, small automatic transmission passenger cars for the disabled, and light motorcycles, applicants must be between 18 and 70 years old, with no height requirement.
Was this review help?
11
5
Share
More Forum Discussions

How often should the automatic transmission fluid be changed in the new Santana?

New Santana automatic transmission fluid should be changed every 40,000 kilometers. Transmission fluid replacement interval: It is best to change it once after 4,000 kilometers. Because manual transmission fluid will not cause discomfort when exceeding 4,000 kilometers, but this is a critical point. Function of transmission fluid: The transmission generates a large amount of heat during operation, and the transmission fluid serves to dissipate this heat. In daily driving, gears must be shifted according to driving conditions, and transmission fluid needs lubrication to make gear shifts smoother. It keeps the transmission system clean and extends the service life of the transmission.
12
5
Share

How many kilometers does it take to replace the gasoline filter?

The gasoline filter needs to be replaced approximately every 20,000 kilometers. Filters are divided into diesel filters, gasoline filters, and natural filters. The method for replacing the gasoline filter is: the gasoline filter is located under the chassis of the car. After lifting the car with a lift, follow the fuel tank and fuel lines to find the cylindrical filter element. After removing the old filter element, simply insert the new one. The function of the gasoline filter is: to filter out harmful particles and moisture in the engine fuel system, protect the fuel pump nozzle, cylinder liner, and piston rings to reduce wear, avoid clogging, remove iron oxide, dust, and solid debris contained in the fuel, reduce mechanical wear, and ensure stable engine operation.
14
2
Share

What is the minimum ground clearance of the Lynk & Co 03?

The minimum ground clearance of the Lynk & Co 03 is 120mm. Minimum ground clearance refers to the distance between the lowest point of the vehicle (excluding the wheels) and the supporting surface when the car is fully loaded and stationary. It is used to indicate the vehicle's ability to pass over obstacles such as rocks and tree stumps without collision. Taking the 2021 Lynk & Co 03 as an example, its front suspension is a MacPherson independent suspension, and the rear suspension is a multi-link independent suspension. It is equipped with a 1.5T turbocharged engine, with a maximum horsepower of 156 PS, a maximum power of 115 kW, and a maximum torque of 245 Nm. It is paired with a 6-speed manual transmission.
8
2
Share

Where is the Cabin Air Filter Located on the Captiva?

The cabin air filter on the Captiva is located inside the glove compartment on the passenger side. Simply open the glove compartment to access it. The replacement procedure for the cabin air filter is as follows: 1. Remove the damper rods on both sides of the glove compartment; 2. Take off the glove compartment to reveal a black rectangular cover panel, then pry it open and remove the clips; 3. Take out the old cabin air filter; 4. Install the new cabin air filter. Taking the 2017 Captiva as an example, it belongs to the midsize SUV category with body dimensions of: length 4690mm, width 1849mm, height 1753mm, wheelbase of 2707mm, fuel tank capacity of 65 liters, and curb weight of 1750kg.
14
5
Share

Is the Axela Equipped with a Three-Cylinder Engine?

Axela is not equipped with a three-cylinder engine. All currently available Axela models on the market come with four-cylinder engines. In terms of powertrain options, the Axela offers a choice between a 1.5L naturally aspirated engine and a 2.0L naturally aspirated engine. Below are the specifications for these two engines: 1. The 1.5L version delivers a maximum horsepower of 117 HP, with a peak power output of 86 kW and a maximum torque of 148 N·m, paired with either a 6MT or 6AT transmission. 2. The 2.0L version produces a maximum horsepower of 158 HP, with a peak power output of 116 kW and a maximum torque of 202 N·m, mated to a 6AT transmission.
1
2
Share

Why does the scooter jerk when accelerating?

When the car jerks while accelerating, it is usually due to the half-shaft of the car being subjected to long-term torsional fatigue and impact forces, which can easily lead to bending, twisting, fracture, or wear and skew of the spline teeth. These faults can cause the car to experience regular shaking in the front when accelerating within a certain speed range. The shaking may disappear or lessen when the accelerator is released. Below is additional information: Car throttle: If the car jerks when accelerating, the issue is likely related to the engine's operation. For the engine to function properly, it requires sufficient air, adequate gasoline, and a well-functioning ignition system. Any problem in these areas can cause the engine to shake. To ensure proper operation, the engine needs sufficient air. If there is a leak or blockage in the intake system, the car may experience jerking during acceleration.
20
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.