Is There a Difference Between Paint Jobs at 4S Stores and Outside?

1 Answers
Casey
07/29/25 3:21pm
There is a significant difference between getting a paint job at a 4S store and outside. The technicians at 4S stores are more professional, the quality of paint used is better, and the paint booths at 4S stores are more advanced, providing a superior working environment. Here is some relevant information: Advantages: Therefore, it is recommended to get a paint job at a 4S store, as the results and durability are better. A car's paint surface is quite complex, consisting of four layers from the inside out: the electrocoat layer, the primer layer, the base coat layer, and the clear coat layer. Function of the electrocoat layer: The electrocoat layer serves to prevent rust. After the entire car body is assembled, robots immerse the body into an electrocoating bath, forming an electrocoat layer over the entire surface. After the electrocoat layer is applied, robots spray the primer layer, which also helps prevent rust and enhances adhesion to the next layer of paint.
Was this review help?
18
2
Share
More Forum Discussions

How to restore the brightness of car headlight covers?

For minor scratches, you can use toothpaste for polishing. Apply toothpaste on the cover and gently rub in circular motions with a soft towel to restore the finish. For longer scratches and cracks, use fine sandpaper for sanding, then apply wax for polishing and restoration. You can also visit a professional auto detailing shop for sanding and polishing restoration.
19
1
Share

How to Install License Plate Screws and Nuts for a Car?

Prepare the screw components, including the spacer block, screw, and cap, which need to be obtained from the vehicle management office. Position the license plate with the license number facing outward and align it with the vehicle's mounting points. Insert the screw into the hole and secure it using a flat-head screwdriver. Adjust the position of the license plate and then tighten all the screws. Finally, align the cap with the spacer block and press it firmly into the screw with slight force to secure the cap in place.
13
2
Share

How to Buy Insurance for the Second Year of a Car?

Whether it's the first year, the second year, or subsequent years, car owners must purchase compulsory traffic insurance, which is a mandatory requirement. For safety reasons, it is highly advisable to purchase third-party liability insurance in the second year. As a major component of commercial insurance, it is essential to purchase vehicle damage insurance in the second year.
4
0
Share

How to Deal with Fog and Water Droplets in Car Headlights?

You can turn on the headlights, and within 15 minutes, the heat generated by the headlights will evaporate the fog or expel it through the vent rubber tube along with the hot air. You can also place car headlight desiccant inside the headlights to dissipate the fog.
14
3
Share

How to Repair a Crack in a Car Windshield?

Use a vacuum injector with a structure similar to a syringe, the function of which is to remove the air from the glass wound. Fill the crack with a glass repair agent and perform several cycles of suction and pressure treatment. Use an ultraviolet lamp to irradiate the area for two minutes in all directions to allow the repair solution to solidify. Drop a higher concentration of repair agent, cover with a glass piece, and after drying, scrape and polish it smooth.
20
0
Share

What to Do When a Car Battery Dies?

The driver sits in the car to steer while four other people push the car from the front, back, left, and right sides. Find a functioning car and use jumper cables to first connect the positive terminals of both cars, then connect the negative terminals. Select a rope of appropriate length, tie the front and rear of both cars tightly with secure knots, and have the driver of the front car slowly tow the rear car.
17
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.