Is stopping not allowed during reverse parking?

1 Answers
DerekFitz
07/29/25 2:22pm
During the reverse parking test in Subject 2 of the driving exam, stopping midway is not permitted. If the vehicle stops for more than 2 seconds during the process, 5 points will be deducted each time. Midway stopping refers to the vehicle having no displacement change within 2 seconds, which the system will judge as a stop. Different items in Subject 2 have different point deductions. The specific analysis is as follows: Reverse Parking: Exceeding the 210-second time limit, not following the prescribed route or sequence, failing to drive the front wheels over the control line before reversing, or not completing the parking will result in a 100-point deduction. Stopping for more than 2 seconds will deduct 5 points each time. Curve Driving: Driving over the edge line or stopping for more than 2 seconds will result in a 100-point deduction.
Was this review help?
1
5
Share
More Forum Discussions

How to install the anti-theft device for Wuling Hongguang S?

Wuling Hongguang S anti-theft device installation steps: 1. Prepare tools: anti-theft device (contains many components), Phillips screwdriver, pliers, scissors, electrical tape, 10mm socket. 2. Remove the cover under the steering wheel, then pull out the two brown turn signal wires from the main harness, and thread the connector upwards from below. 3. Remove the original vehicle connector and connect it with the anti-theft device connector. After connecting, straighten the wires, replace the cover, and tighten the screws. 4. Connect the door wire. The turn signal wire and door wire are together. After connecting, wrap with tape and reinsert the connector. 5. Connect the ground wire, brake pedal wire, and horn wire. 6. Install the central locking system and anti-theft horn.
17
5
Share

Is it necessary to change spark plugs for BMW at 20,000 kilometers?

BMW does not require spark plug replacement at 20,000 kilometers. The replacement cycle for BMW spark plugs: Under normal maintenance conditions, replacement is recommended between 40,000 to 60,000 kilometers. However, this may vary depending on the brand and engine type, so it's advisable to follow the owner's manual. You can refer to the following maintenance standards for replacement: Platinum spark plugs should be replaced at 40,000 kilometers, ordinary nickel alloy spark plugs at 20,000 kilometers, and iridium spark plugs between 60,000 to 80,000 kilometers. How spark plugs work: The spark plug's ground electrode is connected to the metal shell, which is threaded into the engine block via the cylinder head. The insulator primarily serves to isolate the metal shell from the center electrode. The terminal nut is the part of the spark plug that contacts the high-voltage coil. When current passes through the terminal nut and center electrode, it ionizes the medium between the center electrode and ground electrode to produce a spark, thereby igniting the air-fuel mixture in the cylinder.
8
0
Share

When is the best time to take a new car for high-speed driving?

It is best to take a new car for high-speed driving after its first maintenance. Relevant details are as follows: 1. Purpose of high-speed driving: Avoid 'high-speed driving' before the first maintenance of a new car, as it can cause severe engine wear. High-speed driving for a new car is only intended to remove carbon deposits from the engine. During the break-in period, prolonged slow driving of a new car can easily lead to carbon buildup in the engine (high-speed driving should be done some time after the first maintenance). This applies not only to new cars but also to cars frequently driven in congested areas. If there is no time or opportunity for high-speed driving, you can drive at 'high engine speeds' on city roads to reduce carbon deposit formation. 2. Significance of high-speed driving: The real purpose of high-speed driving is to increase the engine speed, which should be maintained between 3000 and 5000 RPM. In the end, 'high-speed driving' is only meant to reduce carbon deposits in the engine, not to break in the various components of the car, so new car owners should pay special attention to this.
10
4
Share

How to Distinguish Between Prado 2700 and 4000?

Prado 2700 and 4000 can be distinguished as follows: 1. Fuel tank capacity: 2700 has a fuel tank capacity of 87L; 4000 has a fuel tank capacity of 150L. 2. Power: 2700 is equipped with a Toyota 2.7L V6 (2GR engine) with a maximum power of 110KW; 4000 is equipped with a 4.0L V6 (1GR engine) with a maximum power of 179KW. The 2700 is powered by a 2.7L 2TR-FE engine, and its power performance is lower compared to the 4000, but it is sufficient for daily use. The 4000 is powered by a 4.0L 1GR-FE engine. 3. Displacement: 2700 has a displacement of 2694CC; 4000 has a displacement of 3956CC. The displacement of the 4000 is larger than that of the 2700. 4. Sunroof: 2700 does not have a sunroof; 4000 comes with a sunroof.
18
0
Share

Is the Honda Enjoy a 3-Cylinder Engine?

Honda Enjoy is equipped with a 3-cylinder engine. The advantage of a 3-cylinder engine is that, compared to a 4-cylinder engine with the same power level, it has one less piston. This significantly reduces the engine's fuel consumption to a certain extent, achieving the goal of energy saving and emission reduction. Additionally, the 3-cylinder engine reduces turbo lag to some degree. In terms of power: All models are equipped with a 1.0T turbocharged engine, with a maximum power of 90kW and a maximum torque of 173 Nm. The engine is paired with either a 6-speed manual transmission or a CVT continuously variable transmission. In terms of body dimensions: The Honda Enjoy measures 4756mm in length, 1804mm in width, and 1509mm in height, with a wheelbase of 2730mm. It features a foldable small table in the middle, rear air conditioning vents, a 12V power outlet, dual USB ports, and a hidden storage channel behind the central armrest that connects directly to the trunk when opened. In terms of chassis suspension: The Honda Enjoy is equipped with a front MacPherson strut and a rear torsion beam suspension. It adopts the ACE (Advanced Compatibility Engineering) body structure, utilizing high-heat pressure welding technology and high-strength steel. The vehicle is also equipped with the Honda SENSING safety and driver-assistance system.
8
4
Share

Does the 2021 Tayron 330 have a particulate filter?

The 2021 Tayron 330 is equipped with a particulate filter to meet the China VI emission standards. The particulate filter is a ceramic filter installed in the diesel engine's emission system, designed to capture particulate matter before it enters the atmosphere. It can reduce soot emissions from diesel engines by more than 90%, and the captured particulate matter is subsequently burned off during vehicle operation. Pollution from diesel engines mainly comes from three sources—particulate matter, hydrocarbons (HCx), nitrogen oxides (NOx), and sulfur. Particulate matter (soot) primarily consists of tiny carbon or carbon compound particles (smaller than 4-20μm in size). How the particulate filter works: The diesel particulate filter is coated with metals such as platinum, rhodium, and palladium. The black smoke containing carbon particles emitted by the diesel engine enters the exhaust particulate trap through a dedicated pipe. Inside, a densely arranged bag-type filter captures the soot particles on a metal fiber felt filter. When the accumulated soot reaches a certain level, the burner at the end automatically ignites, burning off the captured carbon particles and converting them into harmless carbon dioxide. To check if the 2021 Tayron 330 has a particulate filter, you can use the following three methods: 1. Refer to the Owner's Maintenance Manual and Owner's User Manual to see if the particulate filter function is mentioned. Additionally, carefully review the fault codes in the manual to check for any "particulate filter" warning light indicators. 2. Check the label on the oil filler cap. If it clearly states 0W-20 grade oil, it indicates the presence of a particulate filter. 3. Inspect the exhaust pipe behind the three-way catalytic converter for an additional cylindrical section. If present, that is the particulate filter.
5
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.