Is learning C2 easier than learning C1?

Will Insurance Cover a Car Washed Away by Rain?

Insurance companies will compensate for a car washed away by rain, provided that the user has purchased vehicle damage insurance. Only vehicle damage insurance covers compensation for a car being washed away by water. According to the coverage scope of vehicle damage insurance, losses to the insured vehicle caused by lightning strikes, hailstorms, floods, heavy rain, tsunamis, and similar events are covered by the insurer. After a car is washed away by rain, the policyholder should immediately report the incident to the insurance company. If the car cannot be found, the policyholder must obtain a relevant certificate from the local public security authority and complete the vehicle deregistration procedures at the vehicle management office before the insurance company will process the compensation. According to the "Motor Vehicle Registration Regulations," in cases where a motor vehicle is lost due to a natural disaster, a certificate proving the loss must be issued by a government department at the township level or above in the area where the disaster occurred. Additionally, if a motor vehicle is lost due to a disaster, the owner must apply for deregistration at the vehicle management office where the vehicle was registered. The application requires filling out a form and submitting the vehicle registration certificate, vehicle license, the owner's identification, and the loss certificate.

11

2

Share

Is Subject 2 Difficult?

Subject 2 is not difficult. In Subject 2, if you accurately identify the reference points, use the clutch properly, and perform normally during the test, you can generally pass. In summary, during Subject 2, it's important to drive as slowly as possible—only by going slow can you make adjustments. If the speed is too fast, there won't be enough time to adjust. Below are some key points to note for the Subject 2 test: Fasten your seatbelt: Once you get in the car, fasten your seatbelt immediately. Make sure not to buckle it incorrectly or fasten it to the passenger seat, as the system will directly disqualify you. Do not unfasten the seatbelt at any point during the test. Adjust the seat and mirrors: After getting in the car, adjust the seat, mirrors, fasten the seatbelt, turn on the left turn signal, shift into first gear, and release the handbrake. These six steps are essential. Ensure all preparations are complete before starting. No stopping during the test: There is no time limit for reversing into the parking space, but you must not stop during the process. If the wheels remain stationary for 3 seconds, the system will judge it as stopping midway. Therefore, controlling the speed is crucial. The time limit for hill start is 30 seconds: The hill start must be completed within 30 seconds. The system will give a voice prompt every 10 seconds, and exceeding 30 seconds will result in disqualification.

6

1

Share

What Are the Effects of Leaving a Motorcycle Out in the Rain?

Leaving a motorcycle out in the rain can cause issues, such as rusting of the exterior and parts, which may lead to decreased performance and affect safe driving. Here are some maintenance methods for a motorcycle engine: Ensure the air entering the cylinder is clean; if the air passing through the air filter contains excessive dust, it can act like an abrasive, accelerating wear on the cylinder surface. Therefore, it's crucial to keep the air entering the cylinder as clean as possible. To enhance filtration, you can add a layer of foam sponge outside the paper filter element. The foam sponge should be rinsed with water daily to prevent clogging. Maintain good lubrication on the cylinder surface; liquid friction causes much less wear compared to dry friction. To avoid dry friction, ensure the lubricating oil adheres well to the cylinder and piston surfaces, forming a liquid friction layer. This requires the lubricating oil to have an appropriate viscosity. Since viscosity varies with temperature, different viscosity grades should be used in different seasons. Ensure smooth engine operation; engine knocking is primarily caused by excessively fast combustion. Knocking generates strong impact forces on the piston, striking the cylinder walls and causing wear. Reasons for overly fast combustion include: Using gasoline with an octane rating that doesn't match the engine's compression ratio. If the driver fails to shift gears promptly, causing the engine to stall, sudden acceleration can produce knocking sounds in the cylinder.

20

1

Share

What maintenance is needed before a car goes on a long trip?

Before a car goes on a long trip, it is necessary to check the fluids; carefully remove dust and clean the car surface; inspect whether the windshield washer fluid, coolant, engine oil, transmission fluid, power steering fluid, and brake fluid are clean and sufficient; check the tire system, including whether the tire screws are loose or show abnormal wear; inspect the electrical system, mainly focusing on whether the wipers, wiper blades, and front windshield washer nozzles are damaged; check whether the interior and exterior lights, horn, and remote control are functioning properly, etc. Below are some precautions for driving on highways: Drive in the designated lane: Highways have clearly marked lanes, including dedicated lanes for large vehicles, small vehicles, etc. When overtaking, once you occupy a lane, return to your own lane promptly after completing the overtaking maneuver. Do not occupy other lanes for extended periods. Additionally, the emergency lane should not be occupied for non-emergency reasons. Maintain a safe speed and avoid speeding: The dangers of speeding are well-known, whether on local roads or highways, as it can lead to irreversible consequences. Maintain a safe following distance: Under normal conditions, on dry roads with good braking, the following distance (in meters) should not be less than the speed (in km/h). For example, at 80 km/h, the distance should be no less than 80 meters; at 100 km/h, no less than 100 meters. Always pay attention to roadside distance markers. In rainy, foggy, snowy, or wet road conditions, the following distance should be doubled. Observe traffic signs: Always pay attention to roadside and overhead signs and markings while driving, and stay appropriately to the right to avoid running over the right lane divider, providing sufficient lateral distance for overtaking vehicles. Do not arbitrarily occupy the emergency lane in case of accidents: Traffic accidents are inevitable on highways. If other vehicles cause a blockage in the travel lane, do not occupy the emergency lane, as it may hinder rescue vehicles from performing their duties. Avoid fatigue driving and take timely breaks: Fatigue driving is extremely dangerous on highways. When fatigued, the body's reaction time slows down, making it difficult to respond correctly to sudden situations.

12

1

Share

What are the differences between Volvo XC90 T6 and T5?

Volvo XC90 T6 and T5 have the following differences: 1. Different engines. The T5 features a transverse inline 5-cylinder engine, while the T6 has a transverse inline 6-cylinder engine. The main difference lies in the number of cylinders, with the T6 having one more cylinder than the T5, resulting in different displacements, maximum output power, and torque. 2. Different power outputs. Both are 2.0T engines, but the T5 has a maximum horsepower of 254 HP, a maximum power of 187 kW, and a maximum torque of 350 N.m, while the T6 version boasts a maximum horsepower of 321 HP, a maximum power of 235 kW, and a maximum torque of 400 N.m. From this, it is evident that the T6 offers more robust power, and the T6 version provides more driving mode options compared to the T5. 3. Different drive systems. The T5 uses front-wheel drive with a turbocharger, whereas the T6 version employs both mechanical and turbo dual-charging and features all-wheel drive.

7

5

Share

How to clear the maintenance reminder on the Great Wall H7?

Here is the method to reset the maintenance light on the Haval H7: 1. With the engine off, press and hold the trip reset button located below the tachometer. 2. While holding the button, turn the ignition on, then release the trip reset button. When the display shows the "SERVICE" indicator, pull out the minute button on the clock and turn it to the right. 3. After the mileage is displayed on the screen, turn off the ignition to complete the maintenance light reset. Here are some details about the Haval H7: 1. Suspension: It features a front MacPherson and rear double-wishbone four-wheel independent suspension system. 2. Body dimensions: The length is 4715mm, width is 1925mm, height is 1718mm, and the wheelbase is 2850mm.

7

1

Share

Is learning C2 easier than learning C1?

Will Insurance Cover a Car Washed Away by Rain?

Is Subject 2 Difficult?

What Are the Effects of Leaving a Motorcycle Out in the Rain?

What maintenance is needed before a car goes on a long trip?

What are the differences between Volvo XC90 T6 and T5?

How to clear the maintenance reminder on the Great Wall H7?

What should you pay attention to when buying a used forklift?

Detailed Explanation of Traffic Signal Lights

Can mobile phones be charged on bullet trains?

How long is the validity period of Shenzhen car quota?