Is it okay to leave a new car unused for 20 days?

1 Answers
Philip
07/29/25 4:36pm
It is generally fine to leave a car unused for 20 days, but it is recommended not to leave it parked for more than half a month. The potential harms of leaving a car unused for an extended period include: 1. The battery may lose charge if not recharged for a long time, making it difficult to start the car; 2. The tires may deform due to uneven pressure if left in one position for too long. Precautions to take: 1. Park the car in a garage and cover it with a car cover to protect the paint from sun, rain, or falling leaves; 2. Do not engage the handbrake, as the brake system can react with moisture and oxygen in the air when left unused for a long time, leading to rust on the brake discs and pads, which may cause the wheels to lock; 3. Disconnect the battery if the car will not be used for an extended period to prevent power drain from onboard electronics; 4. Check the tire pressure of all four tires to ensure they are normal and there are no leaks.
Was this review help?
14
0
Share
More Forum Discussions

Why can't the window glass of Roewe RX5 be raised or lowered?

Roewe RX5 window glass cannot be raised or lowered, which is a failure of the power window. The following are common causes of the failure: 1. The mud slot of the glass is deformed or damaged. 2. The screws fixing the lifter are loose. 3. The window lifter is damaged. 4. There is a deviation in the installation position of the guide rail. The following are general solutions for the window glass lifting failure of Roewe RX5: (1) Turn on the ignition switch, pull the switch up and hold it, continue to pull for more than 3 seconds after the glass rises to the top. (2) Release the switch and immediately press and hold it to lower the glass to the bottom for more than 3 seconds, then repeat the rising action once. The initialization program is completed, and the window lifting function is restored. (3) This method is effective for most models. If the restoration is unsuccessful, it is necessary to go to a regular repair shop for inspection.
14
5
Share

Do You Need to Press the Clutch When Shifting to Neutral?

Shifting to neutral requires pressing the clutch. Not pressing the clutch can cause the following issues: 1. Difficulty in shifting gears; 2. Excessive wear of the synchronizer inside the clutch, leading to damage due to shifting impact. The method to shift to neutral is: release the accelerator, press the clutch, and gently move the gear lever into neutral. Neutral gear refers to the state where the vehicle's gear lever is not engaged in any forward or reverse gear, completely separating the transmission from the engine. In manual transmissions, neutral is located in the middle position, while in automatic transmissions, it is marked with an 'N'. The clutch is installed between the engine and the transmission and is a component directly connected to the engine in the vehicle's drivetrain. Its functions include ensuring smooth vehicle starting and enabling seamless gear shifting.
7
5
Share

Is Baojun a Domestic or Joint Venture Car Model?

Baojun is a domestic car model, which is an automobile brand under SAIC-GM-Wuling. Taking the Baojun 730 as an example, it is a 5-door, 7-seater MPV with body dimensions of 4685mm in length, 1785mm in width, and 1745mm in height, and a wheelbase of 2750mm. The Baojun 730 is equipped with a 1.5L naturally aspirated engine, delivering a maximum power of 77 kW at 5600 rpm and a maximum torque of 135 Nm between 3600 to 5200 rpm. Its front suspension adopts a MacPherson strut independent suspension, while the rear suspension uses a torsion beam semi-independent suspension.
14
2
Share

How to clear the maintenance reminder on Changan CS75?

To clear the maintenance reminder on the Changan CS75, follow these steps: 1. Click on the vehicle settings in the homepage interface of the multimedia controller; 2. Select to turn the maintenance reminder on or off, and set the maintenance cycle in months and mileage; 3. Click the reset button to restore the default cycle values. The Changan CS75 is a compact SUV with body dimensions of 4650mm in length, 1850mm in width, and 1715mm in height, with a wheelbase of 2700mm. It is equipped with a 1.5L turbocharged engine, delivering a maximum horsepower of 178PS and a maximum power of 131kW.
15
3
Share

Where is the battery located in the CRV?

CRV's battery is located in the engine compartment. The car battery, also known as a storage battery, is a type of battery. Its working principle is to convert chemical energy into electrical energy. The battery referred to here is a lead-acid battery, which is mainly composed of lead and its oxides, with sulfuric acid solution as the electrolyte. The charging method for the Honda CRV battery is as follows: 1. First, connect the battery's positive terminal to the power source's positive terminal and the battery's negative terminal to the power source's negative terminal. 2. The initial charging is carried out in two stages: First, charge with the initial charging current until the electrolyte releases bubbles and the single-cell voltage rises to 2.3~2.4V. Then, reduce the current to half of the initial charging current and continue charging until the electrolyte releases intense bubbles, and the specific gravity and voltage remain stable for 3 consecutive hours. The total charging time is approximately 45~65 hours. 3. During the charging process, the temperature of the electrolyte should be frequently measured. Use methods such as halving the current, stopping charging, or cooling to control the temperature between 35~40°C. If the specific gravity of the electrolyte does not meet the specified requirements after the initial charging is completed, adjust it using distilled water or an electrolyte with a specific gravity of 1.4. After adjustment, charge for another 2 hours until the specific gravity meets the specified requirements.
12
5
Share

How to Remove ETC?

ETC can be removed by the following methods: 1. Use a hairdryer to blow hot air at the joint between the OBU device and the windshield, then slowly twist the OBU device off by hand; 2. Soak a towel in hot water and place it on the outside of the windshield to heat the adhesive tape behind the OBU device, then remove the device. ETC is an electronic toll collection system. Its working principle is: through dedicated short-range communication between the vehicle-mounted electronic tag installed on the vehicle's windshield and the microwave antenna on the ETC lane at the toll station, the system uses computer networking technology to perform background settlement processing with the bank, achieving the purpose of vehicles passing through highway or bridge toll stations without stopping to pay tolls.
3
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.