Is it normal for the car's atoiltemp light to come on and the car won't start?

What are the reasons for the discrepancy between the odometer reading and the actual mileage?

The reasons for the discrepancy between the odometer reading and the actual mileage include a faulty odometer sensor, issues with the wiring between the sensor and the dashboard, or a malfunctioning dashboard pointer. Generally, the latter has a very low probability of occurring and can usually be ruled out. It is recommended that the driver visit a repair shop to have the odometer sensor inspected and replaced if necessary. Determining whether the issue is with the sensor or the dashboard: Disconnect the sensor connector, turn on the ignition, and locate the 2nd electrode connected to the brown wire with a red stripe in the connector. Use a homemade wire with a plug to extend it and lightly brush against a grounded part of the vehicle body to input a pulse signal to the dashboard. If the speedometer needle moves, it indicates that the dashboard is functioning properly. The fault lies with the sensor's reed switch or magnetic ring. If the speedometer needle does not move, it suggests an issue with the dashboard or the connecting wiring. Determining whether the issue is with the dashboard or the wiring: Remove the dashboard without disconnecting the plug, and use a multimeter to measure the three electrodes on the dashboard. Turn on the ignition, and check that the voltage from fuse No. 26 to the power supply line of the speedometer should be 12V when measured against the ground. Use the multimeter's resistance mode to measure; the resistance of the pulse signal line from the dashboard to the sensor connector should be zero, and the resistance of the ground electrode to the ground should also be zero. If the actual measurements do not match these three values, any short circuits in the wiring should be addressed. If the wiring is confirmed to be fault-free, the issue lies with the speedometer, which should be repaired or replaced as needed.

13

2

Share

Can You Drive on the Road with a Temporary License Plate but No Vehicle License?

You cannot drive on the road with a temporary license plate but no vehicle license. The vehicle license is the legal document that permits a motor vehicle to drive on roads within China. It consists of three parts: the license holder, the main page, and the supplementary page. It is issued by the Vehicle Management Center and is used to verify the authenticity of vehicle information. The paper motor vehicle license plate that permits temporary driving on the road, also known as the temporary driving license plate, is a temporary vehicle driving certificate issued by the public security vehicle management department for newly purchased vehicles before they are officially registered. The validity period of a temporary license plate generally does not exceed thirty days. There are four types of temporary license plates: temporary license plates for administrative jurisdictions, temporary license plates for cross-administrative jurisdictions, temporary license plates for testing, and temporary license plates for special-type motor vehicles.

9

3

Share

Can I go to any 4S store for the first maintenance?

You can go to any 4S store for the first maintenance. The vehicle maintenance manual contains the addresses of 4S stores, and generally, maintenance can be done nationwide. However, you need to bring the first maintenance voucher and the vehicle maintenance manual when doing so. If the car was purchased from a 4S store, check if there is a stamp of the 4S store in the maintenance manual. If there is, just take the first maintenance free card and drive to the nearest 4S store of the same brand for maintenance. New car maintenance refers to the use of new car preservation technology to maintain and restore the technical performance of the car, ensuring it has good usability and reliability, extending its service life, and improving safety performance. This includes maintenance of the car paint, car glass, car tires, wheel hubs, genuine leather seats, interior, and air purification and sterilization inside the car.

17

2

Share

What is the method to reset the maintenance light on a Volkswagen?

Volkswagen maintenance light reset method is: 1. Turn the ignition key to the 'on' position with your right hand; 2. Press and hold the reset button on the right side with your left hand; 3. Turn off the ignition key, wait until the instrument panel screen goes completely black, then turn the key to the 'on' position again; 4. Keep holding the button until the maintenance reminder disappears automatically. Volkswagen models include: Volkswagen Lavida, Volkswagen Bora, Volkswagen Teramont, Volkswagen Lamando, Volkswagen Tacqua, etc. Taking the 2021 Volkswagen Lavida as an example, its body dimensions are: length 4670mm, width 1806mm, height 1474mm, with a wheelbase of 2688mm. The 2021 Volkswagen Lavida is equipped with a 1.4T turbocharged engine, delivering a maximum horsepower of 150PS, maximum power of 110kW, and maximum torque of 250Nm.

20

3

Share

What are the solutions for unpleasant odors in car air conditioning?

The solutions for unpleasant odors in car air conditioning are: 1. Open the windows for ventilation; 2. Turn on the internal circulation; 3. Place activated charcoal in the car; 4. Install an air purifier in the car; 5. Turn on the external circulation of the air conditioning; 6. Place some grapefruit or orange peels in the car to use the fruit fragrance to counteract the odor; 7. Replace the air conditioning filter. The maintenance methods for air conditioning are: 1. Clean the air conditioning vents promptly; 2. Maintain the air conditioning condenser in a timely manner; 3. Clean or replace the air conditioning filter promptly. The functions of air conditioning are: 1. Filter the air entering the cabin; 2. Absorb moisture from the air; 3. Keep the air clean and prevent bacterial growth; 4. Prevent fogging on the glass; 5. Adjust the cabin temperature.

18

2

Share

Why Does a Sedan Emit a Gasoline Smell When Starting?

The reasons for a gasoline smell when starting a sedan are: 1. Incomplete combustion during startup; 2. Aging rubber hoses in the engine compartment, leading to leaks; 3. Insufficient air intake by the throttle, causing incorrect air flow information, affecting fuel injection quantity, resulting in increased fuel consumption and a gasoline smell; 4. Poor sealing or uncleaned residues after disassembling and reassembling the fuel pump; 5. Leaks in the gasoline carbon canister or fuel pump rubber ring. Solutions to address the gasoline smell when starting a sedan include: 1. Replace the throttle; 2. Replace the carbon canister or carbon canister solenoid valve; 3. Clean the engine interior; 4. Replace the fuel injector; 5. Open the solenoid valve; 6. Replace the carbon canister rubber hose.

2

Share

Is it normal for the car's atoiltemp light to come on and the car won't start?

What are the reasons for the discrepancy between the odometer reading and the actual mileage?

Can You Drive on the Road with a Temporary License Plate but No Vehicle License?

Can I go to any 4S store for the first maintenance?

What is the method to reset the maintenance light on a Volkswagen?

What are the solutions for unpleasant odors in car air conditioning?

Why Does a Sedan Emit a Gasoline Smell When Starting?

What is the problem with the car lights flashing?

How to remotely start the JAC JY A5?

What is the emission standard for the 2013 New Jetta?

How Long Does It Take to Change the Engine Oil for a Car?