How to Use the Nissan Qashqai Wiper?
4 Answers
There is a wiper control lever on the lower left side of the steering wheel. Push the wiper lever upward one gear to start the wiper; when turning it off, push the lever downward to the OFF position. Precautions for using the wiper: 1. Maintain cleanliness: When there are streak marks on the glass surface, the wiper blade may be dirty. Spray a small amount of alcohol on a towel and wipe the dirty areas and places with residue. Cleaning it once a month can improve the wiper's performance. 2. Check the rubber: If there is abnormal noise on the windshield, it may be due to hardening, wear, or cracks in the wiper blade rubber. If the wear is not severe, you can sand it with sandpaper. 3. Avoid sunlight: Try to park the car in a ventilated and shady place.
The wiper operation on the Qashqai is quite intuitive. I found the wiper lever on the right side of the steering wheel. First, turn the central knob to select the mode: INT is for intermittent wiping, which I often use when it's drizzling; LO is for low-speed wiping, which I switch to when the rain gets heavier; HI is for high-speed wiping, which is very useful during heavy rain. There's also a MIST position for a single wipe, handy for clearing dust before it rains. Don’t forget, pulling the lever toward the steering wheel sprays washer fluid to clean the windshield—super convenient. The rear wiper on the Qashqai is controlled by a button at the top of the lever—just press it to activate or adjust. I recommend checking the wiper blades regularly, replacing them if they’re worn or not cleaning properly, about once a month, to avoid blurred vision and accidents in the rain. Visibility is crucial when driving in the rain, so test the wipers before setting off—don’t take it lightly!
Operating the X-Trail's wipers is not complicated at all, and I find it super smooth to use. The wiper stalk is located on the right side of the steering wheel. Turn the stalk to select the INT (intermittent) mode for light rain, LO (low speed) for heavy rain, and HI (high speed) for storms—it's incredibly useful. Pressing the top of the stalk activates the rear wiper, which is handy for light rain. To spray and clean the windshield, simply pull the stalk toward yourself, and the water will automatically spray and wipe clean. I think beginners might forget to adjust the speed, but a few practices in the rain will make it second nature. Another tip: avoid using the fastest setting in traffic jams during rain to reduce noise annoyance. Regularly replacing the wiper blades (I do it every three months) improves clarity and ensures safe visibility in the rain.
Operating the X-Trail's wipers is straightforward. Locate the stalk on the right side of the steering wheel. Rotating it changes modes: intermittent for light rain, low speed for heavy rain, and high speed for downpours. Pulling the stalk toward you activates the washer fluid for cleaning the windshield. The rear wiper is engaged by pressing the button on top. Remember, safety comes first when driving in the rain—avoid distractions that could impair visibility.
