How to Use the Air Conditioning in Baojun 510?

1 Answers
VonElisa
07/29/25 9:07pm
To use the air conditioning in Baojun 510: 1. Start the engine; 2. Press the AC button; 3. Adjust the fan speed. The Baojun 510 is a compact 5-door, 5-seat SUV with body dimensions of 4220mm in length, 1740mm in width, and 1615mm in height, with a wheelbase of 2550mm. It is equipped with a 1.5L naturally aspirated engine and a 6-speed manual transmission, delivering a maximum power of 73 kW and a maximum torque of 135 Nm. The drive system is front-wheel drive, with a MacPherson strut independent suspension at the front and a torsion beam non-independent suspension at the rear.
Was this review help?
1
2
Share
More Forum Discussions

Will the Motorcycle Test Be Canceled Due to Rain?

Motorcycle tests will not be canceled due to rain. Below is an introduction to motorcycle-related content: 1. Working Principle: When the pedal is pressed, the mechanism pressurizes the spring, causing the outer edge of the spring to lift and the friction plate to disengage from the pressure plate. At this point, the friction plate and flywheel are no longer connected, so even if the engine continues to run, power will not be transmitted to the transmission and wheels. This allows the rider to shift gears or stop without stalling the engine. 2. Power Transmission: When the crankshaft speed is low, the two friction plates do not contact the housing, preventing power transmission. At higher crankshaft speeds, centrifugal force causes the friction plates to move outward and engage with the housing, enabling power transmission.
18
1
Share

What does A/C mean?

A/C stands for aircondition, which means air conditioning. It can be understood as air control or air regulation. It achieves cooling or heating through different operation modes of the air conditioning compressor, so it has the dual meaning of cooling and heating. Usage method: Press to turn on the light, indicating that the compressor switch is turned on, and the air conditioning is set to cold air. Turn the leftmost knob to blue. When cooling is needed, the compressor works, and cold air can be blown out. Press again to turn off the light, indicating that the compressor switch is turned off. Even if the air conditioning is set to cold air (i.e., the leftmost knob is turned to blue) and cooling is needed, the compressor will not work, and no cold air will be blown out. Outside air will directly enter the car, providing natural wind. Function of car air conditioning: Car air conditioning is used to adjust and control the temperature, humidity, air cleanliness, and air flow inside the car cabin to the optimal state, providing passengers with a comfortable riding environment and reducing travel fatigue. It also creates good working conditions for the driver and plays an important role in ensuring safe driving as a ventilation device. It generally includes a refrigeration device, heating device, and ventilation device.
19
0
Share

How to Clean a Car Sunroof Sunshade?

Some car sunroof sunshades can be removed, allowing you to clean them in your preferred way. If removal is inconvenient, you can use foam cleaner for cleaning. If you prefer not to do it yourself, you can have it cleaned at a 4S shop. Below is additional information: 1. Avoid improper operation: Manual sunshades mainly consist of the shade cloth, pull rod, and a handle for opening and closing the sunshade. It is important to never pull the rod, as doing so can unbalance the sunshade system and may even render it inoperable. Electric sunshades primarily consist of the shade cloth and pull rod, and can be operated simply by using the control switch at the front of the vehicle. 2. Regular maintenance: Regular maintenance of the sunroof should not be overlooked. During daily use, pay special attention to ensure there are no obstacles on the roof that could hinder the sunroof's sliding motion before opening it. On bumpy roads, try to avoid using the sunroof to prevent damage to related components due to vibration. When closing the sunroof, make sure it has fully reached the closed position.
9
1
Share

Why is the car AC blowing strong but not cold?

Reasons why the car AC blows strong but not cold: 1. Compressor aging or damage: The cooling function of the AC mainly relies on the compressor. If the compressor belt is loose, aged, or damaged, only the blower will operate, blowing natural air instead of cold air. 2. Circulation mode: Check if the AC is in recirculation mode. The outside air mode brings hot air from outside into the car. 3. Air vents: Cold air tends to sink, so check if the AC vents are set to blow upwards. 4. Refrigerant: Too much or too little refrigerant affects cooling efficiency. Excessive refrigerant reduces heat dissipation, while insufficient refrigerant hampers cooling. 5. Clogged filter: Long-term use can accumulate dust on the filter, obstructing the flow of cold air into the car. 6. Water infiltration: If the desiccant bottle in the AC system absorbs too much moisture, the refrigerant's water content may freeze in small orifices, blocking refrigerant circulation.
13
4
Share

What is the minimum ground clearance of the Tharu?

The Tharu currently has 11 models on sale, featuring 2 engine options (1.4T and 2.0T) and 1 transmission choice (dual-clutch), with a minimum ground clearance of 150mm. Additional information: 1. Ground clearance: Minimum ground clearance refers to the distance between the lowest point of the vehicle (excluding wheels) and the supporting surface when fully loaded and stationary, indicating the vehicle's ability to pass over obstacles like stones or stumps without collision. A larger minimum ground clearance enhances the vehicle's capability to navigate obstacles or uneven terrain but raises the center of gravity, reducing stability. Conversely, a smaller minimum ground clearance decreases the vehicle's ability to traverse obstacles or rough surfaces but lowers the center of gravity, improving stability. 2. Tharu introduction: The Tharu's front face design is robust and full, with a hollowed-out front grille integrated with the headlight assembly and a rugged front bumper, highlighting its tough character. For body colors, the new vehicle offers six options: Carbon Crystal Gray, Elegant White, Ink Gray, Modern Gold, Glamour Brown, and Lake Light Blue.
7
5
Share

How to Resolve the Magotan U112300 Fault?

U112300 fault is a vehicle fault value received from the total data, usually caused by a break in the communication CAN bus. It requires inserting a gateway to check the communication lines of the missing communication module, locating the breakpoint, and repairing it to restore normal operation. It is recommended to visit a 4S shop for professional computer reading and repair. Below are specific details about the Magotan: 1. Historical Background: The Volkswagen Magotan is closely related to the Passat B6, originating from the Future B6. It is the first B-class sedan to be produced and sold by FAW-Volkswagen since its establishment. According to FAW-Volkswagen, 'Ma' symbolizes confidence, decisiveness, and dynamism, while 'Teng' represents soaring, surpassing, and passion. 2. Body Dimensions: The Magotan measures 4865mm in length, 1820mm in width, and 1475mm in height, with a wheelbase of 2812mm.
9
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.