How to Turn on the Heater in a Haval M6?
4 Answers
After starting the car, it takes approximately 6 to 8 minutes for the water temperature to rise to the normal level. At this point, you can turn on the heater. Adjust the air conditioning's circulation mode to internal circulation and switch to the heater mode, indicated by the red zone. Set the air conditioning to a suitable temperature level, generally above 25 degrees Celsius, and adjust the air vent direction upwards.
When I first drove the Haval M6, I wasn’t quite sure about the heating controls either, but I figured it out eventually. Remember to start the car first and let the engine run for a few minutes to warm up—otherwise, turning on the fan might just blow cold air. Then, on the central control panel’s AC unit, find the temperature adjustment knob or button, turn it to the right into the red zone or set it to a higher number, like between 27 to 28 degrees. At this point, make sure the A/C button is turned off since it’s for cooling—don’t let it stay lit. For the fan speed control, adjust the airflow knob to your preferred level, starting low and gradually increasing. Wait a minute or two, and warm air will start blowing from the vents—it’s especially cozy in winter before driving. It’s also a good habit to regularly check the cabin air filter to ensure smooth airflow and reduce odors. In short, take your time with the controls—it’s both safe and practical.
With over a decade of driving experience, operating the heater in a Haval M6 is quite straightforward: First, ignite and start the engine, letting it run for about two minutes to allow the coolant temperature to rise to the normal range—this is the key step. Then, on the dashboard's climate control panel, adjust the temperature knob to the heat setting, and make sure to turn off the A/C switch to avoid confusing it with cooling. Set the fan speed knob to a moderate level based on your needs, as blasting air too forcefully can be uncomfortable. This method not only provides warmth but also effectively defogs the windshield, ensuring clear visibility and enhancing driving safety. I recommend checking the vehicle's cooling system every six months to maintain consistent heater efficiency, rather than waiting for issues to arise before taking action.
I'm quite concerned about convenience in daily life, and operating the heater in the Haval M6 is very simple: Start the car and wait about a minute until the water temperature rises slightly, then operate the air conditioning panel. Turn the temperature control knob to the right to a higher setting (usually above 25 degrees), while turning off the button with the A/C light on. Then set the fan speed to medium-low, and quietly wait for the warm air to come out. This operation doesn't consume extra fuel, as it utilizes the engine's waste heat. Remember to prepare this routine before using the car in winter, so passengers don't get cold. Occasionally clean the air vents to prevent dust buildup, and the maintenance cost is also low.
