How to Turn on the Fog Lights on Chery Tiggo 8?

[DeJuliet]

The method to turn on the fog lights on Chery Tiggo 8: First, you need to turn on the low beam lights or the position lights, then rotate the middle knob on the light control lever to the fog light position to activate the rear fog lights. Below is some relevant information about rear fog lights for vehicles: 1. Rear fog lights for vehicles are red signal lights installed at the rear of the vehicle, with higher luminous intensity than tail lights, designed to make the vehicle more visible to other road users behind in conditions of low visibility such as fog, rain, or dust. 2. Front fog lights are installed slightly lower than the headlights at the front of the vehicle and are used to illuminate the road during rainy or foggy weather. Due to low visibility in foggy conditions, the driver's line of sight is limited. Fog lights can increase the visibility distance, especially yellow fog lights, which have strong light penetration, improving the visibility for both the driver and other road participants, allowing oncoming vehicles and pedestrians to spot each other from a greater distance.

[_travis]

Turning on the fog lights on the Tiggo 8 is actually quite simple, though I remember spending some time figuring it out the first time. On the left-side light control stalk near the steering wheel, you first need to rotate the outermost ring to turn on the parking lights or low beams - this is a prerequisite. Then, using your thumb and middle finger, grip the textured rotary knob ring in the middle section of the stalk. Turning it clockwise one notch activates the front fog lights (indicated by a green curved icon on the dashboard), and another turn brings on the rear fog lights too (shown by a yellow icon with a horizontal line). I often use them in rainy weather, but remember to turn them off afterward - you don't want to blind drivers behind you. If nothing happens when you turn the knob, it might be a blown fuse or you may need to restart the vehicle's infotainment system.

[Margot]

The fog light switch of the Tiggo 8 is located in the middle section of the light control stalk. The operation involves three steps: First, turn on the low beam or position lights, then while holding the steering wheel with your left hand, use your index finger to push the rotating ring. The first click activates the front fog lights, indicated by a green icon on the dashboard, which allows visibility of about ten meters in heavy fog. Pushing it one more click turns on the rear fog lights, with a yellow warning light illuminating to alert vehicles behind you. It's crucial to rotate the knob fully until you hear a confirming click. I once tested it on the highway during rain, and the penetration was indeed much stronger than regular headlights. Also, remember to turn off the fog lights before shutting down the engine; otherwise, an alarm will sound upon the next start-up. While it doesn't significantly affect the battery, the noise can be annoying.

[Terrance]

Before turning on the fog lights, ensure the vehicle is powered on. Locate the light control stalk on the lower left side of the steering wheel with your left hand. Rotate the outermost ring to the position marker light position and stop. At this point, the independently rotatable middle ring on the stalk can be operated: turn forward one notch to activate the front fog lights, and another notch for the rear fog lights. To turn them off, simply twist back in reverse. In foggy conditions, tests show a 20-meter penetration distance is achievable, but remember to combine it with reduced speed and hazard lights for added safety. The tricky part is finding that small rotary knob – in low light, feel for the raised dot to locate it. It's recommended to practice several times in your home garage to develop muscle memory.

[VonKennedy]

Want to turn on the fog lights while driving the Tiggo 8? First operate in the lighting control area: After starting the vehicle, rotate the end of the left stalk to turn on the low beams. Then use your middle finger to press the dedicated fog light knob in the middle section of the control lever, rotating it forward in two stages. The first stage activates two yellow front fog lights, while the second stage turns on the high-intensity red rear fog light. The instrument cluster provides the clearest indication: A green icon means the front fog lights are on, and a yellow icon shows the rear fog lights are activated. In urban haze conditions, front fog lights alone are sufficient; reserve rear fog lights for mountain roads with thick fog. If the button gets stuck, simply restart the engine to resolve the issue.

[VonChristopher]

The fog light switch of the Tiggo 8 is integrated into the light lever. First, turn on the low beam mode, which powers up the fog lights for activation. There's a knurled rotating ring in the middle section of the lever - turn it clockwise with your thumb. The first click activates the front fog lights, indicated by three green droplet symbols on the dashboard. Continue turning until you hear a click to activate the rear fog light, shown by an orange rear fog light symbol. Rainy day tests show it's three times brighter than daytime running lights, and it genuinely reduces rear-end collision risks in fog. Remember to twist the knob back to turn off before parking, as prolonged forgetfulness may cause overheating in the headlight assembly. Beginners are advised to check the manual illustrations beforehand to familiarize themselves with the control positions.