How to turn off the Land Cruiser's ECO mode?

What Causes the Steering Wheel to Make Abnormal Noises When Turning?

Abnormal noises when turning the steering wheel may be caused by the following reasons: 1. Lack of lubrication in the shock absorber top bearing: If the noise is heard coming from outside the vehicle when turning the steering wheel, it might be due to insufficient lubrication in the shock absorber's top bearing. 2. Loose stabilizer bar bushings: If the noise does not originate from the shock absorber's top bearing, check if the stabilizer bar bushings are loose or damaged. Loose or damaged stabilizer bar bushings can cause noises not only when turning but also when driving over uneven roads. This issue can often be resolved by adding shims. 3. Dirty power steering fluid: If the power steering fluid is too dirty, it increases the pressure in the power steering system, leading to a "buzzing" noise from the power steering pump. It is essential to replace the power steering fluid promptly. 4. Aging of the tie rod end ball joint: If the tie rod end ball joint is worn out, it can cause the steering wheel to shake and produce noises. In such cases, the tie rod end ball joint should be replaced, followed by a four-wheel alignment.

19

0

Share

What is the speed requirement for straight-line driving in Subject 3?

Speed should not be lower than 40km per hour. The straight-line driving test in Subject 3 requires testing gear shifting, usually up to the 4th gear, which corresponds to a speed of 40km per hour. Below this speed, the vehicle may experience gear disengagement and jerking, which must be noted during the test. Here is additional information: Driver's License: The motor vehicle driver's license examination follows a specific sequence. Subject 4 examination can only be scheduled after passing Subject 3. Upon passing Subject 4, the motor vehicle driver's license will be issued, allowing the legal and proper driving of motor vehicles.

8

0

Share

What does 17*7.5j mean for wheel rims?

The number 17 indicates that the wheel rim is 17 inches in diameter. 7.5J represents the width of the wheel rim, measured in inches, and is suitable for tires with a width range of 215-235. However, 7.5J is just one form of expression; some wheel rims may be marked as 7;1/2, which also signifies 7.5J. Below is an introduction to the various parts of a wheel rim: 1. Rim: The part of the wheel that fits and supports the tire. 2. Spoke: The part of the wheel that connects to the axle hub and supports the rim. 3. Offset: The distance between the center plane of the rim and the mounting surface of the spoke. It can be positive offset, zero offset, or negative offset. 4. Flange: The part of the rim that maintains and supports the direction of the tire. 5. Bead seat: Also known as the mounting surface, it contacts the tire bead and supports the radial direction of the tire. 6. Well: A depression in the rim with a certain depth and width to facilitate tire installation and removal. 7. Valve hole: The hole for installing the tire valve.

14

5

Share

Is it a violation if the front wheel crosses the solid line but the rear wheel does not?

Generally, crossing or driving over a solid line during driving is considered a traffic violation. However, if you cross the line to yield to emergency vehicles such as police cars, fire trucks, ambulances, or engineering rescue vehicles performing urgent tasks, it is not a violation. According to Article 90 of the Road Traffic Safety Law of the People's Republic of China, motor vehicle drivers who violate road traffic safety laws and regulations regarding road traffic rules shall be given a warning or fined between 20 and 200 yuan. If there are other provisions in this law, penalties shall be imposed in accordance with those provisions. Here is additional information: Single yellow solid line: In areas with relatively low traffic volume and narrow roads, a single yellow solid line may be installed to separate opposing traffic flows. Vehicles are prohibited from crossing or driving over the single yellow solid line in both directions. Randomly crossing the line may lead to collisions with oncoming vehicles and result in a fine and a deduction of 3 points.

12

5

Share

Is there a theoretical test for Subject 3?

There is no limit on the number of attempts for Subject 4, but it must be passed within the three-year validity period. In 2016, there were no new regulations regarding the number of attempts for Subject 4, which remains unlimited as long as it is completed within the three-year validity period. Subject 4, also known as the Subject 4 theoretical test or driver's theoretical test, is part of the motor vehicle driver's license assessment. Here is additional information: Subject 1: After passing the Subject 1 test, the vehicle management office should issue a driving skill test permit within one day. The driving skill test permit is valid for three years, and the applicant must complete Subject 2 and Subject 3 tests within this validity period. If the tests are not completed within the validity period, the results of any passed subjects will be voided.

9

2

Share

What is the maximum speed limit for turning and U-turns?

When turning or making a U-turn, the maximum speed must not exceed 30 kilometers per hour. According to Article 46 of the "Regulations for the Implementation of the Road Traffic Safety Law": "When encountering a U-turn, turning, or descending a steep slope, the maximum speed of a motor vehicle must not exceed 30 kilometers per hour, while for tractors, battery-powered vehicles, and wheeled special machinery vehicles, it must not exceed 15 kilometers per hour." Below is additional information: Relevant regulations: When a motor vehicle passes through an intersection controlled by traffic signals and turns left, it must turn from the left side of the intersection center point. Turn signals must be activated when turning, and low beams must be used when driving at night. At intersections without directional signal lights, turning motor vehicles must yield to straight-moving vehicles and pedestrians. Right-turning motor vehicles from the opposite direction must yield to left-turning vehicles.

6

3

Share

How to turn off the Land Cruiser's ECO mode?

What Causes the Steering Wheel to Make Abnormal Noises When Turning?

What is the speed requirement for straight-line driving in Subject 3?

What does 17*7.5j mean for wheel rims?

Is it a violation if the front wheel crosses the solid line but the rear wheel does not?

Is there a theoretical test for Subject 3?

What is the maximum speed limit for turning and U-turns?

What is the difference between 97V and 97H tires?

How to Start the Car Without the Key for One-Button Start?

How many meters away from traffic lights is parking prohibited?

What Causes the Rattling Noise When Accelerating in a Teana?