How to Solve Foggy Headlights?

2 Answers
StSebastian
09/03/25 3:12am
Here are the solutions to foggy headlights: 1. Defogging method. If there is slight fog inside the headlight, turn on the car's headlights to bake it. The fog will gradually evaporate when heated. 2. Sunlight exposure. If the fog inside the headlight is heavy or water has entered, drive the car to a sunny area. Use the ultraviolet heat from sunlight to slowly evaporate the fog in the headlight. Here is additional information on the causes of foggy headlights: 1. Check if the headlight is damaged. During normal driving, stones kicked up by other vehicles may hit the headlight. Alternatively, the headlight's dust cover may have been scratched or impacted. A thorough inspection is necessary. 2. Poor sealing of the headlight cover. If the headlight dust cover is not damaged or cracked, the issue may lie with the sealing gasket. Poor sealing can lead to water seepage into the headlight, causing fogging. Visit a professional automotive repair shop for diagnosis and treatment. 3. Condensation. Temperature differences due to climatic conditions can cause condensation.
Was this review help?
3
2
Share
KingMarie
09/15/25 4:52am
As a veteran driver with twenty years of experience, I've seen headlight fogging countless times. It's normal to see a thin layer of mist inside the lens after washing the car or during rainy days—just a natural physical phenomenon, nothing to panic about. Headlights aren't completely sealed; they're designed with vent holes to balance internal and external air pressure, allowing moisture to seep in. As long as the fog dissipates naturally within half an hour, it poses no safety risk. However, if you notice pea-sized water droplets pooling at the bottom of the lens or even dripping, the sealant is likely degraded. Remember to first wipe the lens surface dry, then use a hairdryer on low heat to blow warm air into the gaps for a few minutes to speed up evaporation—but keep it at a safe distance to avoid overheating! Persistent water accumulation requires a visit to the repair shop for resealing.
Was this review help?
16
2
Share
Expand All
More Forum Discussions

What is the reason for a car not accelerating when stepping on the gas?

The reasons why a car does not accelerate when stepping on the gas are: 1. Throttle issues or excessive carbon buildup on the throttle; 2. Malfunction in the fuel supply system; 3. Poor fuel quality; 4. Failure in the ECU control unit, where the ECU activates a backup control unit and enters limp mode. Limp mode is designed to allow the vehicle to move to a safe location or repair shop as quickly as possible, and even with the accelerator fully pressed, the car can only drive at a lower speed. The solutions for a car not accelerating when stepping on the gas are: 1. Check fuel pressure and cleanliness, replace the fuel filter; 2. Inspect the ignition system, spark plug wires, and spark plugs; 3. Check cylinder pressure and whether the engine is misfiring; 4. Inspect the intake and exhaust systems for blockages; 5. Check ignition timing, throttle position sensor, and idle control motor.
7
0
Share

What to Do When the Vehicle License Inspection Expires?

When the vehicle license inspection expires, you need to go to the vehicle management office to renew it. The renewal process is as follows: 1. The renewal should be done within three months (90 days) before the expiration date, during which the vehicle must undergo inspection; 2. For vehicles not exempt from inspection, the owner must bring a power of attorney, the vehicle license, and the compulsory insurance policy to the local vehicle inspection station for inspection; 3. Nowadays, there is no need to apply for an inspection compliance label. After passing the inspection, the details will be directly noted on the supplementary page of the vehicle license. The vehicle license is the legal document permitting a motor vehicle to drive on roads within China. It consists of a cover, the main page, and a supplementary page. The front of the main page contains the endorsed certificate core, while the back features a photo of the vehicle sealed in plastic. The supplementary page is the endorsed certificate core.
12
5
Share

Has the Hill Start Test Been Cancelled?

Starting from June 1, 2020, the hill start test has been removed from the Category 2 driving test for small and medium-sized automatic transmission vehicles. The scoring criteria for the hill start test are as follows: 1. Front bumper not aligned with the pole line: If the front bumper is not aligned with the pole line after the vehicle stops, and the deviation exceeds 50cm, it is considered a failure. If the deviation does not exceed 50cm, 10 points will be deducted. 2. Exceeding 30 seconds for starting: If the vehicle takes more than 30 seconds to start, it is considered a failure. 3. Wheels crossing the road edge line: If the wheels cross the road edge line during movement, it is considered a failure. 4. Vehicle rolling backward: If the vehicle rolls backward more than 30cm during starting, it is considered a failure. If the vehicle rolls backward between 10cm and 30cm, 5 points will be deducted per occurrence. 5. Distance between the vehicle body and the road edge line: If the distance exceeds 50cm after the vehicle stops, it is considered a failure. If the distance is between 30cm and 50cm, 10 points will be deducted per occurrence. 6. Parking brake not fully engaged: If the parking brake is not fully engaged after stopping, 10 points will be deducted per occurrence.
6
0
Share

How to Transfer a Driver's License File?

Methods for transferring a driver's license file: 1. The student must personally bring their ID card and a copy, along with a handwritten signature for "Voluntary Withdrawal of C Driver's License Business" and contact information, to the vehicle management office affiliated with the driving school where they applied to submit a written application; 2. Fill out the driver's license file cancellation application form; 3. Submit the relevant materials and the application form to the staff for cancellation; 4. Reapply to a driving school, and once the file is successfully established, it can be transferred. The full name of a driver's license is a motor vehicle driver's license, also known as a "driver's license," which is a certificate required by law for motor vehicle drivers. Driving a motor vehicle requires certain driving skills. Without these skills, driving a motor vehicle recklessly may lead to traffic accidents. Generally, individuals cannot drive on the road without a license.
13
2
Share

What does a turtle and a gear light indicate?

A turtle and a gear light indicates that the vehicle's powertrain is not functioning properly but can still maintain low-speed operation. Here is relevant information: 1. Vehicle indicator lights: Dashboard indicator lights are divided into three categories: indicators, warnings, and faults. 2. Classification of indicator lights: The first category includes the most common indicator lights, such as lighting signal lights, turn signal lights, parking lights, etc., which serve to inform the status of various vehicle functions. The second category consists of warning lights, which have an alert function, such as fuel indicator lights, door status indicator lights, seatbelt indicator lights, etc. Typically, warning lights turn off after the driver takes the corresponding action, such as the seatbelt indicator light turning off once the seatbelt is fastened. The third category comprises fault indicator lights, which are the most critical, such as generator fault indicator lights, ABS fault indicator lights, transmission fault indicator lights, etc. Generally, these fault indicator lights rarely illuminate under normal circumstances or may light up briefly when starting the engine before turning off. If a fault indicator light remains lit and is accompanied by a warning sound, it indicates that the vehicle has developed a fault or abnormality.
6
3
Share

How to Use 431 Equipment for Matching When Replacing the Mechatronic Unit in Volkswagen?

Method for using 431 equipment to match when replacing the mechatronic unit in Volkswagen: 1. Connect the vehicle with the 431 equipment to read data, then click to enter the automatic transmission system directory; 2. Click "Basic System Adjustment" to enter, input group number 060 and click OK; 3. Observe the second and third group data in the channel number interface, where the numbers gradually change from approximately 0 to 0. At this point, the vehicle needs to be started, and the entire process requires holding down the brake until the basic setting is completed. Taking the 2021 Bora 200TSI DSG Comfort Intelligent Connected Edition as an example: It is a compact car launched by FAW-Volkswagen, with a length, width, and height of 4663mm, 1815mm, and 1462mm respectively, a wheelbase of 2688mm, equipped with a 1.2T turbocharged engine, a maximum power of 85kw, a maximum torque of 200nm, and matched with a 7-speed dual-clutch transmission.
19
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.