How to reset the wrench light on Great Wall Fengjun 6?
4 Answers
Great Wall Fengjun 6 wrench light reset method: 1. Turn on the ignition switch. 2. Press the button on the instrument panel to switch the mode to display instant fuel consumption status. 3. Turn off the ignition switch. 4. Press and hold the "mode switch" button on the instrument panel, turn on the ignition switch, turn the switch to the "NO" position, and release the "mode switch" button. 5. Simultaneously press the "mode switch" button and the left "time adjustment" button on the instrument panel. The reset is complete. Fengjun 6 diesel maintenance light reset steps: 1. Turn off the ignition switch and disconnect the car's power. 2. Press and hold the 0.0 button, then turn on the ignition switch to power the car. 3. After the car is powered on, release the 0.0 button, then press the 0.0 button again. 4. This will reset the maintenance light.
Last year when I was driving the Great Wall Wingle 6, I also encountered the wrench light coming on. This is actually the maintenance reminder light. To reset it, first make sure the vehicle is completely turned off, then press and hold the trip reset button (the small stick-like button on the right side of the dashboard). With your other hand, turn the key to the ignition-on position, but don't start the engine. Keep watching the dashboard while continuing to hold the button for about 5-6 seconds - you'll see the wrench icon flash and then disappear. Release the button, fully turn off the power, then restart the engine to confirm. I recommend resetting this reminder promptly after each maintenance service, otherwise having it constantly lit can affect your driving mood. If repeated attempts don't work, it might be due to a dirty throttle body or the mileage data not being reset during the last maintenance - in that case, you should take it to a repair shop for inspection.
Simply put, eliminating the wrench light means resetting the maintenance reminder. Specific steps: After parking and turning off the engine, firmly press the TRIP button on the right side of the instrument panel (the button used to switch the odometer), then turn the key to the ignition position. Keep holding the button without releasing it for about seven or eight seconds, and the wrench light will go off. At this point, turn off the power and restart the vehicle. I've encountered a few situations where the reset wasn't successful, either because the button was pressed for too short a time or because the operation was performed before the engine was turned off. By the way, when this light comes on, it means it's time for maintenance. Don't just turn off the light without performing the maintenance—the turbocharged engine of the Fengjun 6 requires timely care.
Here's how to do it: After the car is completely turned off, press and hold the button on the dashboard that switches the trip meter. Then turn the key to power up the dashboard while continuing to hold the button for 5 to 10 seconds, and the wrench light will go off by itself. Release the button, turn off the power, and then start the car—that's all it takes. The key is to make sure the car is fully turned off before starting the operation. This light is essentially a maintenance reminder based on mileage, so even if you clear it yourself, remember to go for maintenance when it's due.
