How to reset the maintenance light on Roewe i6?

[VanRylee]

Methods to reset the maintenance light on Roewe i6: 1. Turn on the ignition switch, and press and hold the MODE button for more than 5 seconds while the OIL symbol is displayed on the combination instrument panel; 2. After the OIL symbol starts flashing, quickly press the MODE button more than 5 times; 3. The OIL symbol will flash 3 times and then turn off, and the maintenance reminder warning light will be extinguished, completing the reset operation. The exterior design of the Roewe i6 inherits the design concept of the VisionR concept car, adopting a wide and flat style. The overall vehicle design is composed of smooth surfaces and sharp lines, presenting a very sporty characteristic. At the same time, the rear of the Roewe i6 features a ducktail design with a swallowtail-style inward-cut pattern, where all the lines converge at the taillights, giving it high recognizability.

[McSadie]

My Roewe i6 has been driven for over two years, and I've performed the maintenance light reset several times. The specific method is to first turn off the ignition switch, ensuring the car is completely shut down. Then, press and hold the OK button on the steering wheel without releasing it, turn the key to the ON position (the position where the car is powered but not started). At this point, the dashboard will display a countdown, roughly about ten seconds. Wait until the maintenance light turns off by itself before releasing the button. I previously tried twice before succeeding, mainly ensuring the holding time was long enough. Also, there might be slight differences in buttons for different model years. My friend’s 2018 model has a reset button at the lower left corner of the dashboard. Be sure not to start the engine during the operation, as it can easily lead to failure.

[Betty]

Attention to Roewe i6 owners, resetting the maintenance light is quite simple. First, park the car in a safe spot, turn off the engine, and engage the handbrake. Press and hold the OK button on the steering wheel with your left hand, then turn the key to the ignition position (where all dashboard lights illuminate) with your right hand. Keep watching the dashboard – after about 5-10 seconds when the wrench-shaped maintenance reminder disappears, you can release the button. Some owners report needing multiple attempts; I recommend trying a few times while ensuring proper button pressure. Remember, this light is just a reminder – after manual reset, don't forget scheduled maintenance. If unsuccessful, dealerships can handle it during regular servicing.

[LaJoseph]

Resetting the maintenance light on the Roewe i6 is quite simple. After turning off the engine, hold down the OK button, then turn the ignition to the self-check position. Keep holding for about 15 seconds until the dashboard prompt disappears. The key is to perform this operation without starting the engine, and note that button locations may vary depending on the configuration. Remember to check the next service interval after resetting.

[DiVivian]

I've taught several car enthusiasts how to reset the maintenance light. First, completely turn off the Roewe i6, locate and press the OK button on the steering wheel without releasing it. Then turn the key to the ignition position (without starting the engine) until all dashboard indicator lights illuminate. Keep holding for about 7-8 seconds until the wrench symbol flashes a few times and disappears. It's best to confirm the gear is in P position and the parking brake is engaged during operation. Last time I performed this, I noticed low battery voltage could affect success rate, so ensure your battery is in good condition. After resetting, I recommend noting down the mileage to avoid missing the actual service interval.