How to Reset the Low-Pressure Run-Flat Indicator?

How to Break in a Newly Purchased Motorcycle?

Introduction to the break-in methods for a newly purchased motorcycle: 1. Do not exceed 4000rpm when shifting gears: Do not exceed 40 mph. After changing the oil, it is advisable to briefly run at high speed to help the engine operate at high power. Then change the oil again to release wear debris from new parts. 2. Frequently vary the engine speed: During the break-in phase, it is necessary to operate in every gear, and not just one or multiple gears. The balance between gears and components must be fully balanced, but do not exceed the specified maximum speed. 3. Regularly change the oil: The engine is the core of the motorcycle, and the oil is its blood. The role of oil is not only to form a lubricating film on the friction surface of each moving part to lubricate and reduce the friction resistance of the parts but also to clean, cool, and prevent corrosion. 4. Avoid prolonged low-speed driving and check the battery monthly: When driving daily, check whether the brakes are intact and whether the turn signals and brake lights display normally.

20

4

Share

How to Renew an Expired Motorcycle Driver's License?

Motorcycle driver's license renewal process is as follows: The motor vehicle driver should bring the required materials to the vehicle management office where the driver's license was originally issued to apply for renewal. The vehicle management office will process the renewal within one working day after approval. Required materials for license renewal: Bring two copies of ID card, two recent 1-inch color photos without hats, original ID card, original driver's license, and a medical examination certificate from a county-level or above hospital (free medical examination is also available at the vehicle management office). Renewal in other locations and other methods: In addition to applying for renewal at the vehicle management office, you can also apply for renewal through the following methods: Renewal via the "Traffic Management 12123" APP. Download the "Traffic Management 12123" APP, select Service Center -- Expired License Renewal Service -- fill in the information. The new license is usually delivered by mail. Go to the "Police-Medical-Post" service point at the post office for renewal. The entire process, from registration to medical examination to the production of the new license, takes only half an hour. Currently, only a few cities have opened this service, such as Hangzhou.

6

2

Share

How to operate the lights on the Hongqi HS5?

Hongqi HS5 light control lever: The middle part controls the front and rear fog lights. Pushing it upwards turns on the right turn signal, while pushing it downwards activates the left turn signal. Below is relevant information about the Hongqi HS5: 1. Product Positioning: The Hongqi HS5 is an SUV embodying the concept of new high-end refinement. 2. Powertrain: The Hongqi HS5 is equipped with a low-power version of the CA4GC inline four-cylinder turbocharged direct injection engine, with a rated power of 165kW and a maximum torque of 340N·m. This engine, independently developed by FAW Group, incorporates ten industry-leading technologies including high compression ratio Miller cycle combustion technology, 350bar precise fuel injection technology, full MAP intelligent thermal management technology, and all-aluminum lightweight engine technology, achieving a thermal efficiency of 39%. The CA4GC aluminum-steel engine is lightweight, approximately 50% lighter than cast iron cylinder blocks of the same displacement. Benefiting from the platform cross-hatch honing process, the engine reduces wear on cylinder liners and piston rings, extending the overall engine lifespan. This engine was selected as one of the "China Heart" Top 10 Engines of 2019.

19

1

Share

Why does a hot engine have more oil than a cold engine?

Reasons why the oil level is higher when the engine is cold compared to when it is hot: 1. Reason: When the engine is cold, all the oil settles in the oil pan. After the engine has been running for a while, the oil pump continuously circulates the oil, and some of the oil has not yet settled back. Additionally, fully synthetic oil has higher viscosity and lower fluidity, so the oil level appears higher when measured cold. 2. Optimal level: Pull out the dipstick to check the maximum and minimum levels. Add oil if it is below the minimum level, but do not add if it is above the maximum level. In such cases, excess oil should be drained. Below are some additional details about engine oil: 1. Increased fuel consumption: When adding oil, the oil level should be between the upper and lower limits on the dipstick. If too much oil is added, the oil volume will expand as the engine temperature rises, increasing the pressure in the oil chamber and the running resistance. This can reduce the car's power and increase fuel consumption. 2. Overfilling oil: If too much oil is added, the crankcase breather pipe may leak oil, and the increased crankcase pressure can loosen the oil seals due to the oil pressure, leading to oil leaks. 3. Cooling: Overfilling oil can affect engine cooling.

6

4

Share

Where is the Air Filter Located in a BMW 2 Series?

The air filter in a BMW 2 Series is located under the front windshield. Below is some knowledge about the air filter. Functions of the Air Filter: It ensures the filter fits tightly against the housing, preventing unfiltered air from entering the cabin. It separates solid impurities such as dust, pollen, and abrasive particles from the air. It adsorbs moisture, soot, ozone, odors, carbon oxides, SO2, CO2, etc., from the air, providing strong and long-lasting moisture absorption. It prevents the car windows from fogging up, ensuring clear visibility and safe driving for passengers. It supplies fresh air to the cabin, preventing harmful gases from being inhaled by occupants and ensuring driving safety. It also effectively sterilizes and deodorizes. Maintenance of the Air Filter: Cleaning Tip: If the filter is dirty, clean it by blowing compressed air from the opposite side. Hold the air gun about 5 cm (centimeters) away from the filter and blow at 500 kPa pressure for approximately 2 minutes. The air filter tends to accumulate a lot of dust, and blowing away the loose dust with compressed air is sufficient. Never clean it with water, as this can easily damage it.

7

3

Share

Whose name should the insurance be under if the car belongs to my father?

It can be under anyone's name. However, in the event of a claim, the person whose name is on the policy will need to sign for the claim. Below is relevant information about auto insurance: 1. Introduction: Motor vehicle insurance is a type of property insurance, also known as auto insurance, which covers the vehicle itself and third-party liability related to the vehicle as a mode of transport. 2. Types of motor insurance: Motor vehicle insurance generally includes compulsory traffic insurance and commercial insurance. Commercial insurance consists of basic insurance and additional insurance. Basic insurance is divided into vehicle damage insurance, third-party liability insurance, comprehensive theft insurance (theft insurance), and passenger liability insurance (driver liability insurance and passenger liability insurance).

17

5

Share

How to Reset the Low-Pressure Run-Flat Indicator?

How to Break in a Newly Purchased Motorcycle?

How to Renew an Expired Motorcycle Driver's License?

How to operate the lights on the Hongqi HS5?

Why does a hot engine have more oil than a cold engine?

Where is the Air Filter Located in a BMW 2 Series?

Whose name should the insurance be under if the car belongs to my father?

Which model is the BMW 325i hardtop convertible?

How many minutes of illegal parking will not be fined?

What is the Service Brake? And What is the Brake Pedal?

What is the purchase tax for motorcycles?