How to replace the wiper blades on the new Sylphy?
3 Answers
The steps to replace the wiper blades on the new Sylphy are: 1. Lift the wiper arm on the windshield; 2. Press the release lock pin, then slide the wiper blade along the arm and remove it; 3. Insert the new wiper blade into the wiper arm. The new Sylphy is a compact car with body dimensions of 4631mm in length, 1760mm in width, 1503mm in height, and a wheelbase of 2700mm. It is equipped with a 1.6L naturally aspirated engine, delivering a maximum power of 90kW at 6000rpm and a maximum torque of 155Nm, paired with a 5-speed manual transmission.
First, turn off the car's power and immediately push the wiper lever to raise the wiper arms into maintenance mode. Then, gently lift the wiper arm, making sure to support it with your hand to prevent it from suddenly snapping back and damaging the windshield—placing a thick towel underneath is recommended. Press the small square button at the connection point between the wiper blade and the wiper arm, then slide it downward to remove the old blade. When purchasing new wiper blades, ensure you select the correct model, typically a 24+16 inch U-hook type. During installation, align the hook with the slot on the new wiper blade and listen for a click to confirm it's properly secured. Finally, gently lower the wiper arm back onto the windshield. After replacing both sides, test the wiping effect by spraying windshield washer fluid. Handle the process with care, as the wiper arms are fragile and can easily bend if excessive force is applied.
I just replaced the wiper blades for my friend's new Sylphy the day before yesterday. The steps are actually quite simple. First, turn on the ignition and then power off the vehicle. The key is to push the wiper lever upward within ten seconds, which will make the wiper arms stand upright on the windshield. At this point, it's crucial to place protective padding—I usually use a plush steering wheel cover under the wiper arms to prevent accidental drops during the operation. There's a plastic clip button at the connection point of the old wiper blades; press it all the way down and slide the blade out along the wiper arm. When installing new wiper blades, pay special attention to the direction of the clip to avoid installing it backward. After confirming proper installation, gently lower the wiper arm back and start the car to test with the washer fluid. If you notice skipping during the test, simply lift the wiper arm again and adjust its position. It's best to purchase OEM-sized wiper blades online in advance as backups—incorrect sizes won't clean properly.
