How to replace the brake light stopper on the Tiggo 3?
4 Answers
Replacement method for the Tiggo 3 brake light stopper: Press the brake pedal to the bottom, use a jack to lift the vehicle, then remove the stopper above the brake pedal and replace it with a new one. Additional information about the Tiggo 3 is as follows: 1. The Tiggo 3 features a new textured and stylish interior, offers authentic urban off-road SUV driving control, and comes equipped with the latest Cloudrive 2.0 intelligent cloud-connected driving system, fully meeting the demands of young consumers for an urban SUV. 2. The Tiggo 3 adopts a piano black finish for its stylish and dynamic front grille, along with newly designed eagle-eye headlights, complemented by dual five-spoke 17-inch aluminum alloy wheels, giving the overall exterior a more youthful and dynamic appearance.
I've driven a Tiggo 3 for many years. Last time, the brake light kept not working, and it turned out to be a faulty brake pedal stop switch. Replacing it isn't too difficult. First, park the car on level ground, engage the handbrake, turn off the engine, and disconnect the negative terminal of the battery for safety. Then, crawl under the driver's seat to locate the stop switch at the top of the brake pedal, which is secured by two small bolts. Use a wrench to loosen the bolts and gently unplug the electrical connector. When installing the new stop switch, make sure it's properly aligned with the pedal to avoid misalignment. Tighten the bolts but don't over-torque them to prevent stripping. Reconnect the battery terminal, and finally, test the brake light by pressing the pedal. The whole process takes about 30 minutes. Keeping a spare part in the car is a good precaution, and regular inspection of these small components can prevent unexpected failures. Remember, safety first—don't attempt repairs in the middle of the road.
Replacing a brake light switch is quite straightforward, especially for a family SUV like the Tiggo 3. You just need a standard wrench—park the car, engage the handbrake, and turn off the engine first. Crawl under the driver’s side floor to locate the pedal switch, which sits slightly above the footrest. Unscrew the mounting bolts, carefully unplug the wiring without yanking it. Align the new switch with the socket position to ensure it triggers the light when pressed. Finally, reconnect the battery and test it. DIY saves money and hassle, and regular dust cleaning extends its lifespan. If it’s stubborn, avoid forcing it—having the right tools makes the job smooth. The whole process should be seamless.
Steps to replace the brake light limiter are clear: After parking and cutting off the power; locate the switch at the top of the Tiggo 3 driver's seat pedal; remove bolts and unplug wires; install the new part with alignment; reconnect the power and test the light. Ensure proper alignment to avoid short circuits, and operate safely.
