How to Replace the Battery in an Envision Key Fob?
2 Answers
To replace the battery in an Envision key fob, follow these steps: 1. Press the button on the key fob to extract the mechanical key; 2. Use an appropriate tool to open the outer shell of the key fob; 3. After opening the battery compartment, you will see the battery—simply remove the old battery and replace it with a new one. The Envision has the following dimensions: length 4694mm, width 1839mm, height 1686mm, with a wheelbase of 2750mm and a fuel tank capacity of 66 liters. It is equipped with a 1.5T turbocharged engine, delivering a maximum power of 124kW and a maximum torque of 250Nm, paired with a 7-speed dual-clutch transmission.
I've replaced the battery in my Envision key fob several times, and it's quite simple. There's a small gap on the back of the key fob. Use a thin tool like a small screwdriver or coin to gently pry it open, but don't apply too much force to avoid damaging the plastic casing. Inside, you'll find a CR2032 coin battery. Remove the old one, making sure the positive side faces up (usually the side with text), and replace it with a new battery of the same model. You can buy these batteries at supermarkets or online – opt for reputable brands like Panasonic or Nanfu for longer-lasting performance. After replacement, test the buttons to see if the indicator light comes on, or try locking the car from a short distance. If the key fob responds slowly or the remote range shortens, it might indicate low battery, so consider replacing it every two years to prevent sudden failures. To extend battery life, avoid storing the key in damp places or dropping it on the ground.
