How to Replace the Air Filter in a Mazda3 Axela?

1 Answers
LaSteven
07/30/25 10:47am
To replace the air filter in a Mazda3 Axela: 1. Open the glove box, push both side walls of the glove box with your hands to remove it; 2. Pull out the old air filter by its paper tab, insert the new filter, and reinstall the glove box. The Mazda3 Axela is a compact car under Changan Mazda. Taking the 2020 Mazda3 Axela Manual Zhimei Edition as an example, its body dimensions are 4662mm in length, 1797mm in width, 1445mm in height, with a wheelbase of 2726mm. The 2020 Mazda3 Axela Manual Zhimei Edition is equipped with a 1.5L naturally aspirated engine, delivering a maximum power of 86kW at 6100 rpm.
Was this review help?
17
5
Share
More Forum Discussions

What is the normal tire pressure range for Changan CS75 in winter?

For the Changan CS75 in winter, the tire pressure should be adjusted based on the standard tire pressure of the car tires, with an appropriate increase of about 0.2bar. According to the provisions and requirements of the international GBT2978-2008 standard, the tire pressure for different tires is as follows: Standard tires: 2.4-2.5bar; Reinforced tires: 2.8-2.9bar; Maximum pressure: should not exceed 3.5bar. In summer, the lower limit of the standard tire pressure for car tires is generally sufficient. For example, the lower limit for standard tires is 2.4bar. If the car is often parked outdoors, the tire pressure can generally be about 0.1bar lower than the standard to avoid tire blowouts due to high temperatures.
8
3
Share

What Does the Lateral Marking Mean?

Lateral marking means: In some windy or open areas, crosswinds may occur, alerting drivers that there will be strong side winds ahead. Lateral deceleration markings are a set of parallel white dashed lines, usually installed at highway toll booths, curves, tunnel entrances, and other locations to remind drivers to reduce speed. When drivers see lateral markings, they need to increase their attention and grip the steering wheel slightly tighter with both hands to prevent sudden crosswinds from causing the vehicle to deviate from its intended direction. Highways have lanes and median barriers, so there are no crosswinds. However, when entering ramps, vehicles may encounter winds blowing perpendicular to the body, which can easily lead to danger. Therefore, it is crucial to be aware of crosswinds, as high-speed vehicles affected by them are often prone to accidents. Crosswinds have a greater impact on box-shaped vehicles such as vans, large buses, and canvas-covered trucks because these vehicles have a higher center of gravity and larger lateral surface area.
9
1
Share

How long does it take for fuel consumption to return to normal after adding fuel additive?

Fuel additive has no direct relationship with fuel consumption. Its main function is to make gasoline burn more completely and reduce carbon deposits. Therefore, theoretically, fuel consumption will return to normal once it is fully burned. Here is some additional information: 1. Fuel additive: Fuel additive (also known as gasoline detergent or fuel additive) is a type of automotive chemical and a common name for the third generation of gasoline detergents. Its purpose is to address carbon deposit issues in the fuel system of fuel-injected vehicles, quickly restore the engine to optimal working condition, and compensate for certain deficiencies in gasoline properties, while also imparting new beneficial characteristics such as improved atomization, reduced wear, engine protection, and lower emissions. 2. Authenticity verification: Purchase channels: Buy from official channels (such as physical stores, online flagship stores, 4S stores, etc.); National standards: Some fuel additives that meet national standards will have the label GB19592-2004 on the bottle; Third-party testing: Send to professional institutions for physicochemical testing using specialized equipment.
15
3
Share

What are the effects of using 95 octane fuel in a car designed for 92 octane?

Using 95 octane fuel in a car designed for 92 octane may lead to incomplete combustion, resulting in insufficient power and increased carbon deposits. Below are detailed explanations of the impacts of improper fuel selection: 1. Using 95 octane fuel in a 92 octane car: The octane rating is too high, and the engine's compression ratio is insufficient, leading to incomplete combustion. Over time, this can cause carbon deposits in the combustion chamber and waste fuel. 2. Using 92 octane fuel in a 95 octane car: The engine's high compression ratio combined with insufficient octane purity can cause knocking, affecting power output and resulting in reduced performance. This also increases engine wear. Always choose fuel based on your car engine's specified compression ratio standard.
9
2
Share

How Often Should the Combustion Chamber Be Cleaned in Terms of Mileage?

The combustion chamber carbon deposits should be cleaned approximately every 40,000 kilometers. Over time, carbon deposits accumulate in the intake tract, valves, and combustion chamber. These deposits absorb fuel when the engine is cold and release it when the engine is hot, leading to difficulties in cold starts and increased fuel consumption when the engine is warm. This results in degraded engine performance, manifesting as idle shaking, poor acceleration, increased fuel consumption, and excessive exhaust emissions. Below are the hazards of carbon deposits in cars: 1. Increased fuel consumption: Carbon deposits can reduce engine power and increase fuel consumption. 2. Engine damage: In severe cases, carbon deposits can cause engine knocking, acceleration noise, and damage to pistons and crankshafts, potentially leading to engine oil burning and necessitating major repairs. 3. Impact on exhaust emissions: Carbon deposits directly affect vehicle exhaust emissions, making it difficult to pass annual emission inspections.
11
3
Share

Do I still need to undergo an annual review of my driver's license after deducting points through legal studies?

After deducting points through legal studies, you do not need to undergo an annual review of your driver's license. Below is some extended information about driver's licenses: 1. Basic Information: The full name of a driver's license is "Motor Vehicle Driver's License," also known as a driving license. Driving requires certain skills, and if one hasn't received training from a traffic authority or school, they may encounter issues such as rear-end collisions, traffic violations, or hitting pedestrians on the roadside. 2. Importance: Only after completing study, training, and passing examinations can a driver obtain a driving qualification certificate issued by the local traffic authority. In short, life is only once, so it's important to cherish others' lives, uphold one's moral principles, and be a driver who values oneself and respects others.
4
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.