How to Renew an Expired Driver's License Online?

How Much Refrigerant Should Be Added to a Car's Air Conditioning System?

Before adding refrigerant, it is necessary to use a pressure/vacuum machine to pressurize the system and check for leaks. If leaks are found, components such as the air conditioning pipe joints, condenser, evaporator, dryer, compressor, and other parts of the air conditioning system must be inspected using foam water to locate the leaks for repair or replacement. After replacement, the system should be pressurized again to check for leaks. Only after confirming there are no leaks should the vacuum process be performed before adding refrigerant. Below are additional details on the refrigerant charging steps: Connect the refrigerant gauge to the air conditioning system (both high and low-pressure pipes), then proceed with vacuuming. Choose low-pressure vacuuming (rotate the switch corresponding to the low-pressure gauge counterclockwise, while keeping the high-pressure gauge switch closed). Generally, there is no need to monitor the negative pressure value during vacuuming; a 3-minute vacuum is sufficient. After the time is up, tighten the low-pressure gauge switch, and then connect the refrigerant canister for charging (again, do not touch the high-pressure switch, only open the low-pressure switch).

19

1

Share

What Are the Symptoms of Needing an Oil Change?

When the engine oil is insufficient, the parts of the engine will rub against each other, leading to damage over time. Without the cooling effect, during high-speed operation of the engine, phenomena such as burning the crankshaft and bearing shells are likely to occur. It is recommended to replenish the oil as soon as possible when it is insufficient. Below is more relevant information: 1. The Role of Engine Oil: Engine oil, often referred to as the 'blood' of a car, serves to lubricate and reduce friction, assist in cooling, seal against leaks, prevent rust and corrosion, and provide shock absorption. 2. How to Add Engine Oil: When adding engine oil, it is generally sufficient to keep the oil level at the midpoint of the dipstick's marked range. Ensure the car is parked on a safe and level surface, as measuring the oil on an incline will yield inaccurate readings. Do not overfill the oil beyond the upper limit, as this can increase resistance on the crankshaft, leading to additional friction losses. Moreover, it can raise the pressure in the crankcase, increase oil consumption, and impair engine combustion.

19

5

Share

What does the MODE button on the Emgrand mean?

Mode switching button, mainly used to toggle between the infotainment system's music and radio modes. Functions vary by location: When the MODE button is positioned on the center console panel, it controls the switching of air conditioning vent modes. When located on the steering wheel, it cycles through multimedia modes, typically alternating between FM/AM/online radio/USB/local storage/Bluetooth music modes. Emgrand maintenance light reset procedure: 1. Turn off the ignition switch 2. Simultaneously press both arrow buttons 3. Turn on the ignition switch while keeping the arrow buttons pressed 4. After approximately 3 seconds, release both arrow buttons 5. The maintenance menu will appear prompting for reset confirmation 6. Press and hold the SET (reset) button for over 3 seconds 7. Press the MODE button 8. Turn off the ignition switch to complete the reset

10

2

Share

Does the Volkswagen Polo cylinder head screw have a washer?

Volkswagen Polo cylinder head screws have washers. The washers can be divided into three types. Industrial rubber sheet: Natural rubber is suitable for media such as water, seawater, air, inert gases, alkalis, salt solutions, etc., but it is not resistant to mineral oils and non-polar solvents. The long-term use temperature should not exceed 90°C, and it has excellent low-temperature performance, usable above -60°C. Nitrile rubber is suitable for petroleum products such as petroleum, lubricating oil, fuel oil, etc. The long-term use temperature is 120°C, and it can withstand 150°C in hot oil. The low-temperature range is -10~-20°C. Chloroprene rubber is suitable for seawater, weak acids, weak alkalis, and salt solutions. It has excellent resistance to oxygen and ozone aging, and its oil resistance is second only to nitrile rubber but better than other general rubbers. The long-term use temperature is below 90°C, with a maximum use temperature not exceeding 130°C, and a low-temperature range of -30~-50°C. Asbestos rubber sheet: Although rubber and some fillers are added to the gasket material, it still cannot completely fill those interconnected micro-pores, resulting in slight permeability. Therefore, it cannot be used in highly polluting media, even under low pressure and temperature. When used in some high-temperature oil media, due to the carbonization of rubber and fillers in the later stages of use, the strength decreases, and the material becomes loose, leading to permeation at the interface and inside the gasket, causing coking and smoking phenomena. Polytetrafluoroethylene: Polytetrafluoroethylene is prone to cold flow and creep under pressure and high temperature, so it is generally used for low-pressure, medium-temperature, highly corrosive, and pollution-free media, such as strong acids, strong alkalis, halogens, pharmaceuticals, etc.

12

5

Share

When will the China 6 emission standard be implemented?

The China 6 emission standard was implemented in key regions, the Pearl River Delta region, and the Chengdu-Chongqing region on July 1, 2019, while it was implemented in other regions starting from July 1, 2020. Below are the specific regulations for China 6: 1. State Council Plan: Article 4, Section (15) of the "Three-Year Action Plan for Winning the Blue Sky Defense Battle" issued by the State Council clearly stipulates that the China 6 emission standard would be implemented in advance in key regions, the Pearl River Delta region, and the Chengdu-Chongqing region starting from July 1, 2019. The promotion and use of gas vehicles meeting the China 6 emission standard were encouraged. 2. Provincial and Municipal China 6 Implementation Dates: Fifteen provinces and municipalities across the country successively issued documents to implement the China 6 emission standard in advance in 2019, meaning that from July 1, 2019, only vehicles meeting the China 6 emission standard could be registered.

5

Share

What is the fuel tank capacity of the Passat 1.4 in liters?

The fuel tank capacity of the Passat 1.4T model is 68.5 liters, as officially announced. The Passat 1.4T model requires 95-octane fuel, with a fuel consumption of 5.8L per 100 kilometers. A full tank can provide a driving range of approximately 1181km. During daily driving, it is essential to monitor the remaining fuel level in the tank. This is typically done by observing the fuel gauge inside the vehicle. Under normal circumstances, the fuel gauge accurately reflects the remaining fuel. The fuel gauge usually has 5 to 6 segments, and it is advisable to refuel when only 2 segments remain to avoid running out of fuel mid-journey. In actual refueling, the amount of fuel may exceed the marked capacity. This is because the manufacturer's specified tank capacity is measured from the bottom of the tank to the safety limit, and there is additional space from the safety limit to the tank opening. This extra space is designed to accommodate fuel expansion due to temperature increases, preventing overflow. If fuel is filled up to the tank opening during refueling, the actual amount may exceed the marked capacity.

7

0

Share

How to Renew an Expired Driver's License Online?

How Much Refrigerant Should Be Added to a Car's Air Conditioning System?

What Are the Symptoms of Needing an Oil Change?

What does the MODE button on the Emgrand mean?

Does the Volkswagen Polo cylinder head screw have a washer?

When will the China 6 emission standard be implemented?

What is the fuel tank capacity of the Passat 1.4 in liters?

How to Warm Up Your Car in the Morning?

How Many Kilowatt-Hours Does It Take to Fully Charge an Electric Vehicle?

Why is the reversing image mirrored left and right?

What is the script for 4S store regular maintenance invitations?