How to Remove the Turn Signal Switch on the Qashqai?
2 Answers
The method for removing the turn signal switch on the Qashqai is as follows: 1. Replacing the turn signal switch requires replacing it together with the combination switch. After starting the vehicle, there will be power assistance. After starting the car, turn the steering wheel directly to adjust it to a suitable position; 2. Expose the screw on the lower right side of the steering wheel. After turning off the engine, ensure the steering wheel remains in a fixed position to avoid affecting the operation. Use a flat-head screwdriver to unscrew the screw. Perform the same operation to remove the screw on the left side of the steering wheel; 3. Open the adjustment switch below the steering wheel and press the steering wheel downward to increase the distance between the combination switch cover and the dashboard. Use a flat-head screwdriver to pry off the cover of the combination switch and remove it.
I previously disassembled the turn signal switch on my Nissan Qashqai, and while the process was a bit challenging, it was manageable. The key points are using simple tools and prioritizing safety. You'll need a Phillips screwdriver and a small pry tool. First, make sure to turn off the car, open the hood, and disconnect the negative terminal of the battery to avoid any risk of a short circuit. Then, sit in the driver's seat and remove the steering wheel cover, which is usually secured by two screws on the sides—carefully unscrew them and don't lose the screws. Once the cover is off, you'll see the turn signal switch module, which might be held in place by clips. Gently pry it loose to remove it, but avoid using excessive force to prevent damaging the plastic parts. Finally, unplug the wiring connector at the back, and remember its position for reassembly. The entire disassembly takes about 15 minutes. After reassembling, test the turn signals to ensure they flash properly before hitting the road. Last time I did this, I noticed the switch was dirty, so I cleaned the contact points—it worked even better afterward.
