How to Remove the Steering Gear of the Languid?
4 Answers
The automotive steering gear, also known as the steering mechanism or steering box, is the most critical component in a car's steering system. Its function is to amplify the force transmitted from the steering wheel to the steering linkage and to alter the direction of force transmission. The steps to remove the steering gear of the Languid are as follows: 1. First, locate the position of the disassembly mechanism. The disassembly mechanism is located on the backside of the steering wheel. 2. After turning off the engine, shut down all electrical devices. 3. Turn the steering wheel to 90 degrees; there is a hole on the backside of the steering wheel. Use an appropriate tool to touch this hole. 4. Finally, return the steering wheel to the straight position, turn it to 90 degrees in the opposite direction, and use an appropriate tool to touch another hole. At this point, the airbag assembly can be removed.
To remove the Verna's steering gear, first ensure safety precautions by disconnecting the battery negative terminal. Then, lift the vehicle, remove the front wheels and underbody cover to locate the steering gear. Once the steering gear mounting bolts are found, loosen them with a socket wrench—pay special attention to the intermediate universal joint shaft, which requires professional tools for disassembly. Clearly label all electrical connectors before disconnecting. Finally, support the steering gear and carefully remove it. The entire process requires two people for coordination, as the steering wheel is heavy and dropping it could damage other components. It's recommended to prepare a ratchet wrench and torque wrench, ensuring bolts are tightened to the factory-specified torque during reassembly to prevent steering noise issues.
Last time I helped a friend remove the Lantra steering gear, we started by taking off the front wheels and the underbody protection panel. The key is to locate the universal joint connecting the steering column to the steering gear - it's best to use an impact wrench when loosening the fixing bolts, as a regular wrench tends to slip. Remember to take photos of the wiring connectors before unplugging them for easier reassembly. When supporting the steering gear, keep it steady - it's much heavier than you'd expect. Note that the Lantra has electric power steering, so you must disconnect the battery before unplugging any connectors to avoid short-circuiting. Actually, the hardest part is repositioning during reassembly - the universal joint teeth must align perfectly with the grooves, being off by even one tooth will cause steering misalignment, so it's advisable to mark the positions beforehand.
Disassembling the Langdong steering gear focuses on tool preparation and step sequence. Essential tools include a jack, socket set, and universal joint wrench. First, disconnect the power and lift the vehicle. After removing the tires, the steering gear becomes visible. When disconnecting all sensor harnesses, press the clips firmly - pulling hard will damage them. Removing the mounting bolts requires an extension bar due to awkward positioning. The most troublesome part is actually the universal joint shaft, which requires tapping vibrations to loosen. The entire disassembly process takes about three hours. Protective clothing is recommended as there's significant grease contamination. Beginners shouldn't attempt this themselves - mistakes in the steering system can be extremely dangerous.
