How to Remove the Rear Door Lock Block of an Older Lavida Model?
3 Answers
Disassemble the control device of the door lock. When removing the lock, take off the fixing clip between the control device and the lock device. Wrap the tip of the screwdriver with tape for the door lock. Check that the door should fit properly, and the door lock linkage should be adjusted correctly.
I recently worked on removing the rear door lock mechanism of an older Lavida model, and it's a step-by-step process. You'll need to prepare the right tools: a Phillips screwdriver, a trim removal tool, and a pair of gloves. Start by opening the door—there are several screws hidden under a small cover near the door handle. After removing them, carefully pry off the door panel liner with the trim tool, being gentle to avoid breaking the clips. Next, disconnect the window switch connector to expose the rear door lock mechanism. It's secured by a few small screws; once removed, gently pull out the lock. Remember to take photos of the wiring positions to avoid mistakes during reassembly. After removal, check the lock for rust or jamming—common issues often originate here. The whole process requires patience to prevent rushed mistakes, and getting it right means your car will last longer.
Removing the rear door lock assembly on an old Lavida is actually a quite common repair. I always prioritize safety when working on it. First, ensure the vehicle is turned off, and wear safety goggles to protect against flying small parts. Recommended tools include a combination screwdriver and socket set—be extra careful with door panel clips as they're fragile and often break. Step-by-step: Locate the door panel screw points (usually under the armrest), loosen them, then pry open the panel; disconnect all wiring harness connectors; the lock assembly screws are on the inner door frame—remove them and carefully take out the assembly. Always check wire insulation conditions, replacing any damaged parts immediately to prevent short circuits. The whole process should take about 30 minutes. For beginners, reviewing the manual or watching tutorial videos beforehand provides extra confidence.
