How to Remove Door Anti-Collision Strips?
2 Answers
Methods to remove door anti-collision strips: 1. Use a hairdryer to heat the residual adhesive, which can be peeled off once softened; 2. An eraser can also easily remove the residual adhesive without damaging the car paint; 3. Use a dedicated tar remover to eliminate the residual adhesive (wear gloves as tar removers can be corrosive); 4. Wipe the residual adhesive with alcohol until it is completely removed. Installing door anti-collision strips mainly prevents door scratches, not only providing protection but also enhancing the vehicle's lines and dynamism, serving as a decorative element that adds to the car's aesthetic appeal.
With decades of driving experience, removing door edge guards is no big challenge. I use a household hair dryer to heat the strip for a few minutes, softening the adhesive before starting. Gently peel from a small corner at the edge—no rushing or hard pulling, or you might scratch the paint and cause major trouble. For leftover sticky residue, wipe with alcohol-soaked cotton balls; for stubborn bits, spray WD-40 and clean thoroughly. Then rinse the door panel with water and apply wax to prevent rust. Remember to wear gloves and choose an overcast day—strong sunlight dries the adhesive too quickly, reducing effectiveness. In my younger days, I rushed and scratched the paint, spending half a day fixing it—now I’ve learned to work gently for a smoother, easier job. The whole process takes about an hour, and with patience, your car will look as good as new.
