How to open the front hood of the Haval H6?
3 Answers
To open the front hood of the Haval H6, pull the switch located at the lower left side of the driver's cabin. The Haval H6 is a compact SUV under the Great Wall Motors brand. Taking the 2021 Haval H6 as an example, its body dimensions are: length 4653mm, width 1886mm, height 1730mm, with a wheelbase of 2738mm. The 2021 Haval H6 is equipped with a 2.0T turbocharged engine, delivering a maximum power of 155kW and a maximum torque of 325Nm. It features a MacPherson independent front suspension and a multi-link independent rear suspension.
The first time I opened the hood of my Haval H6, I was a bit nervous. Remember to first sit in the driver's seat, bend down, and feel for a small lever near your left foot on the driver's side, usually marked with a hood icon or labeled 'hood'. Pull it firmly inward, and you'll hear a slight pop as the hood lifts slightly. Then quickly step out of the car and walk to the front, crouch down to observe the lower middle part of the hood, find the small safety latch, and gently push it left or right while using your other hand to grab the edge of the hood and slowly lift it. The Haval H6's hood is quite heavy, so it's best to use the support rod to prop it in the correct position to prevent it from falling. The whole process takes less than two minutes and is suitable for beginners, but make sure the vehicle is turned off before doing this for safety. I often use this method to check the oil level, adding more if it's low to avoid engine overheating and bigger issues. It's easy to overlook these small details over time, but developing a habit of regular checks can save a lot of trouble.
As a DIY enthusiast car owner, opening the hood of my Haval H6 is a piece of cake for me. Simply put, the first step is to locate the release lever inside the cabin, which is either below the steering wheel or near the pedals—just pull it. The second step is to walk to the front of the car, where you'll find a small flap at the lower front of the hood. Gently pry it open with your finger or a screwdriver to reveal the latch, push it sideways, and then steadily lift the hood. Remember to secure the support rod properly; otherwise, the hood might fall and cause injury. I do this routinely, like when replacing the air filter, to also check if the coolant is within the proper range, ensuring the cooling system functions well. The Haval H6 is thoughtfully designed with an easily noticeable latch position, making the operation effortless. If the lever gets rusty or the latch sticks, just apply some lubricant—don’t force it and risk damage.
