
First, turn off the ignition button and wait for about 10 seconds. Then press the ignition button again to restart the vehicle while keeping your foot on the brake pedal. Next, press and hold the electronic parking brake (EPB) button to check if it can be released. If unsuccessful, repeat this operation several times for testing.

My Soueast DX7 once had an issue where the electronic parking brake wouldn't release, which was really frustrating, but I've researched the manual release method. Generally, it's caused by circuit problems or low voltage leading to a lock. To manually release it, you need to locate the emergency release device—a yellow pull cable handle under the hood or on the side of the trunk. First, park the car on level ground and shift into neutral. Open the hood or trunk and carefully look for the small pull ring; a gentle tug will physically release the brake. Afterward, try moving the vehicle to ensure the release is effective. Remember, this is only a temporary solution—you must promptly visit a repair shop to check the battery or wiring issues, or it might get stuck again next time. Regular maintenance, especially monitoring battery health, can prevent such annoying situations.

It's rare to encounter a situation where the electronic parking brake gets stuck while driving, but my Soueast DX7 experienced it once. Manually releasing it is actually quite simple: I figured out that first, ensure a safe environment—flat ground and neutral gear. Then, open the trunk, and on the right side, there's a small, inconspicuous cover. Pry it open, and you'll see a pull ring. Give it a firm but steady tug, and the parking brake will release. The issue might stem from a low battery or a faulty sensor—after I replaced the battery, it never happened again. After manual operation, drive gently to test it out; don't speed off immediately. Make it a habit to regularly check your vehicle to avoid mishaps at critical moments, especially for older models where aging electrical circuits need extra attention.

The electronic parking brake failing to release is quite common on the DX7, usually caused by power interruption or control module issues. The manual release method isn't complicated: locate the manual release lever in the trunk, typically hidden behind the side trim panel. Pulling that cable can forcibly unlock the brake. Ensure the vehicle is on level ground during operation, and having the engine running is preferable to prevent accidents. After completion, test drive over a short distance. This is only an emergency solution - professional inspection of fuses or voltage regulators is mandatory afterward. Since electronic systems rely on power supply, maintaining the battery properly serves as the key preventive measure.


